检查钢瓶阀门。
关闭钢瓶阀门。
Always open a cylinder valve slowly.
总是慢慢地开启钢瓶阀门。
Always open a carbon dioxide cylinder valve slowly.
总是慢慢地开启二氧化碳钢瓶阀门。
The regulator must be closed before opening the cylinder valve.
在开启钢瓶阀门之前,必须关闭调整器。
Always close the cylinder valve when product delivery is not needed.
当不需要产品输出时,总是关闭钢瓶阀门。
Note automatic leak control arm cylinder valve and locked balance valve.
说明内泄出自动臂缸的控制阀及锁死平衡阀。
Stand as shown (see Fig. 2) with the cylinder valve between you and the regulator.
站得象演示得那样(见图2),使钢瓶阀门在你和调整器之间。
Discontinue use and contact the supplier if a cylinder valve is difficult to operate.
如果钢瓶阀门难于操作,停止使用并同供应商联系。
When the high-pressure gauge indicates maximum pressure, open the cylinder valve fully.
当高压量表指示为最大压力时,彻底打开钢瓶阀门。
The tapered or open end is threaded to receive a cylinder valve or other suitable outlet connection.
钢瓶顶部是锥形的,最上端有个小开口。
They are designed to provide a secondary seal in the event the cylinder valve develops leakage through the valve seat.
它们是设计用来在钢瓶阀门通过阀座产生泄漏的情况下提供一个二次密封。
At the end of the shift or work day, close the cylinder valve and bleed the pressure off the regulator and torch equipment.
在下班或工作日结束的时候,关闭钢瓶阀门,放出调整器和吹管设备内的压力。
Leaks occurring at the cylinder valve's pressure relief device, diaphragms, or valve to the cylinder connection cannot be repaired.
发生在钢瓶阀门的减压装置、横膈膜或阀门到钢瓶的接头处的泄露不能维修。
According to different working conditions, rotary cylinder valve selection of different control components, can be classified as follows.
根据不同工况,旋筒阀选用不同的控制元件,可以分类如下。
Always close the cylinder valve when product delivery is not needed. Do not leave it open when the equipment is unattended or not operating.
当不需要产品输出时,总是关闭钢瓶阀门。当设备无人照管或没有运转时,不要让阀门开着。
The cylinder valve is the most vulnerable part of the compressed gas package and requires a thorough understanding in order to maximize its performance.
钢瓶阀门是压缩气体包装的最脆弱的部分。为了最大程度发挥它的作用,要求彻底地理解阀门。
If a leak develops in a customer system, close the cylinder valve and vent residual product, and purge the lines with inert gas before attempting repairs.
如果在用户的系统里发生了泄露,关闭阀门并排出残余产品。在试图修理之前,用惰性气体净化管道。
When returning cylinders to the supplier, properly close the cylinder valve, replace and secure any valve outlet seals, and properly install the cylinder cap.
钢瓶返还给供应商时,正确关闭钢瓶阀门,替换并固定阀门排气口密封,正确安装钢瓶帽。
Turn the adjusting knob clockwise and establish the required use pressure by referring to the low-pressure gauge. Make sure that the cylinder valve is easily accessible.
顺时针旋转调整钮,通过查看低压量表建立要求的使用压力。确认钢瓶阀门容易接近。
To introduce the structure, performance of the cylinder valve of INERGEN fire extinguishing system, and to analyse its performances of the adjustment, action and safety.
介绍了烟烙尽灭火系统容器阀的结构、性能和设计要点。
To introduce the structure, performance of the cylinder valve of INERGEN fire extinguishing system , and to analyse its performances of the adjustment , action and safety.
介绍了烟烙尽灭火剂的组成、灭火机理、性能及对环境的影响,分析了河津电厂集控楼烟烙尽灭火系统的设计特点,指出了设计上的不足之处及改造方案。
With the regulator adjusting knob turned fully counterclockwise, place both hands on the cylinder valve and open it slowly, allowing the pressure to rise gradually in the regulator.
调整器的调节钮逆时针旋死后,两只手放在钢瓶阀门上,慢慢地开启,使调整器内的压力逐渐增加。
Mud valves and Angle by the hydraulic cylinder type combination valve, hydraulic power drive cylinder valve lift, the valve open or closed channel, in order to achieve the fluid off.
排泥阀产品由液压缸和角式截止阀组合而成,液压缸内动力带动瓣升降,使阀体通道开或闭,以达到流体通断。
To introduce the structure, performance and key elements of the design of large diameter Marine cylinder valve. It is original in choice of design and has a reliable sealing feature.
介绍了大口径船用瓶头阀的结构、性能和设计要点,该阀具有设计新颖,密封可靠的特点。
To introduce the structure, performance and key elements of the design of large diameter Marine cylinder valve. It is original in choice of design and has a reliable sealing feature.
介绍了大口径船用瓶头阀的结构、性能和设计要点,该阀具有设计新颖,密封可靠的特点。
应用推荐