To correct the power factor, the controlling effect of both neural network controller (NNC) and current mode controller (CMC) is researched in this paper.
为改善功率因数，对神经网络控制器(NNC)与电流模式控制器(CMC)的控制效果进行了仿真比较研究。
The control system utilizes a sliding mode observer for the generation of all controller feedback information by means of non-speed information, such as voltage, current and parameters of motor.
利用非速度信息，如：电机的电压、电流及电机本身参数，通过滑模观测器产生控制器所需的速度反馈信息。
A high frequency single-ended flyback switching power supply is designed with current-mode PWM controller UC3842 chip as its core.
设计了一种以电流型PWM控制器UC3842芯片为核心的高频单端反激式开关稳压电源。
Designs on motor field and structure, controller main circuit current commuting mode design, TMS320F240 least system and system program consider system normal operation under fault condition fully.
电机场路结构设计、控制器主回路换流模式设计、TMS320F 240最小系统设计、程序设计充分考虑了故障应急状态下系统正常运行必要条件。
Two main problems in designing the main circuit of switching mode excitation controller are peek voltage and over current of switching device.
开关式励磁调节器主回路设计中需要考虑的两个主要问题是开关器件的尖峰电压和冲击电流。
The controller is UC3846 current mode control chip.
控制器为UC 3846电流型控制芯片。
The current mode PWM controller UC1845 integrated with over current protection and over voltage protection, has a quicker dynamic response.
电流控制型PWM控制芯片uc 1845集成过压、过流保护功能，脉冲频率高，驱动能力强，动态响应迅速。
A comparator circuit based on current-mode control used in PWM controller is presented that is able to compare 3-data at a time and latch output signals.
文中提出了一种用于PWM控制器的比较器输出电路的设计，该电路基于电流模式控制，能够同时对三路输入信号进行比较输出并对输出信号进行锁存。
Due to its characteristics of fast response, good stability, inherent current limiting, current-mode controller has been widely applied in power management circuits.
由于这种控制方式具有响应时间快，稳定性高，内在限流保护等特点，因此近年来电流模式控制方式在电源管理芯片中得到了广泛的运用。
The high precision and large current controller are used widely. But in the situation where there is high common-mode voltage, the detection circuit of the output current is very complex.
高精度大电流控制器有着广泛的应用，但在高共模电压情况下输出电流的检测电路比较复杂。
This paper research the design to current mode PWM controller IC, it is achieved by bipolar process.
本文主要完成了一种基于双极工艺实现的电流型PWM控制器芯片的设计。
This paper research the design to current mode PWM controller IC, it is achieved by bipolar process.
本文主要完成了一种基于双极工艺实现的电流型PWM控制器芯片的设计。
应用推荐