This paper study and analysis microelectronic solid film construction and factor that effect the film resistor conductivity and constantity.
本文对微电子固体薄膜结构，以及影响薄膜电阻导电性和稳定性的因素进行了研究和分析。
On the base of analysis and comparison, the thermal conductivity type of gas meter was considered the most promising field fumigant concentration detector.
经过比较分析，热导气体检测仪被认为是最有应用前途的现场熏蒸剂气体浓度检测仪。
Fast analysis of perchlorate was carried out by ion-pair chromatography using a silica-based monolithic column and direct conductivity detection.
研究了用硅胶整体柱和直接电导检测的离子对色谱快速分析高氯酸盐的方法。
Sensitivity analysis of model parameters showed: Saturated hydraulic conductivity is the most sensitive factor for two soil groups, and saturated water content takes second place.
对模型参数的敏感性分析表明：饱和水力传导度是最敏感的参数，饱和含水量的敏感性次之。
Simplified analysis on a single fiber fin in the duct flow demonstrates that the heat transfer can be enhanced with the increasing length-to-diameter ratio and thermal conductivity ratio.
对单根纤毛肋进行的简化理论分析表明纤毛长径比和肋材与流体的导热系数比越大其强化换热作用越好。
In combination with the well test analysis, the fracture geometry and conductivity are calculated and a numerical simulator is built for a real well in a low permeability oilfield.
文章结合试井分析，确定了裂缝几何尺寸和裂缝导流能力，对低渗油田某井建立了数值模拟模型。
The complexes were characterized by elemental analysis, IR spectra, UV spectra, weight loss analysis and molar conductivity, and tested for antibacterial activity.
由元素分析、红外光谱、电子光谱、失重分析和摩尔电导率对配合物进行了表征。
Through the analysis of the soft-field characteristic, it is found that the sensitivity field distribution is affected by the location, the size and the conductivity of the disperse phase medium.
从灵敏度角度出发多方面(离散相介质所在位置、离散相介质所占区域大小、离散相介质的电导率等)分析了介质分布影响灵敏场分布这一“软场”特性。
This analysis indicated that the hydraulic conductivity could not be assumed as a constant value when groundwater flow was simulated with numerical model.
因此，在进行现地地下水流数值模拟时，水力传导系数不能只假设为单一值。
Furthermore, different porous silicon samples were prepared, and whose surface morpho - (logy) analysis and thermal conductivity measurement using micro-raman technology were performed.
此外，采用不同方法制备了多孔硅样品，分析了其表面形貌并用显微拉曼光谱法测定了导热系数。
AC conductivity obtained from admittance analysis is almost 3-orders higher than that of DC analysis, it ought to be mainly ascribed to the effect of dielectric.
在此温区的交流导纳分析给出的交流电导率比直流电导率大三个数量级，说明此时的交流电导率主要是复介电常数的贡献。
The brief analysis shows that the primary factor of effects on heat lose of thermal insulating engineering is thermal conductivity of material.
说明影响保温工程热损失的主要因素是材料的导热系数。
The equivalent inductance and average magnetic conductivity of MS were involved in analysis of theory.
引入了磁开关等效电感及平均磁导率的概念。
In addition, theoretical analysis indicates that the reduction in the lattice thermal conductivity with vacancy defects can be explained by the enhanced point-defect scattering due to lattice strain.
同时理论方法还表明，空位缺陷对薄膜热导率的巨大影响归因于晶格应力的存在使点缺陷也发生散射作用的结果。
In addition, theoretical analysis indicates that the reduction in the lattice thermal conductivity with vacancy defects can be explained by the enhanced point-defect scattering due to lattice strain.
同时理论方法还表明，空位缺陷对薄膜热导率的巨大影响归因于晶格应力的存在使点缺陷也发生散射作用的结果。
应用推荐