The circular formula of intellectual capital and have enough to meet need have the characteristic of its oneself.
知识资本的循环公式和周转有其自身的特点。
The paper has studied straightening stress and residual deformation of circular shaft by using elastic - plastic theory, deueloped calculation formula of straightening loud in given deflection error.
从弹塑性理论出发以圆截面轴为例对校正应力与残余变形进行了分析研究,提出了在给定弯曲误差下的校正载荷的计算公式。
The load assignment formula and the method of the double circular arc gear under the wiring error influence between the contact mark was introduced and inferred.
介绍并推导双圆弧齿轮在安装误差影响下接触迹间载荷分配的计算公式和方法。
The formula contains a circular reference (the calculated column refers to itself). You must remove or change the circular reference.
公式包含循环引用(计算列引用其本身)。必须删除或更改循环引用。
For present shortcoming of water depth of uniform flow in circular section, which is great calculating error and small application scope, this paper desired to get a new approximate formula.
针对目前圆形断面均匀流水深计算公式存在计算误差大、适用范围小的弊端,欲提出一种新的近似计算公式。
The paper theoretically analyzes the abrasion characteristics in the process of the longitudinal circular grinding, obtains the calculation formula of the radial abrasion of the wheel.
从理论上分析了在纵向外圆磨削过程中砂轮的磨损特点,得出了砂轮径向磨损的计算公式。
Gantry structures, Y axis use simultaneous dual motor and drive, X, Y, Z axis with circular rail (formula type linear guide can be chose), steady transmission, high precision.
龙门式结构,Y轴采用同步双电机双驱动,X、Y、Z三轴采用圆导轨(可选配方型直线导轨),传动平稳,运行。
A built-up circular piston sound source is established in this paper. The directivity formula of its far field is obtained, and its validity is simulated.
依据本文构造的组合圆形活塞声源,导出了该声源远场指向性公式,并对其正确性和有效性进行了仿真研究。
The polar equation of non-circular gear pitch curve, calculation method of center distance, formula of pitch curve length, primary circle radius and pressure Angle is given.
给出了非圆齿轮的节曲线极坐标方程,两齿轮中心距的计算方法,节曲线长度、基础圆半径和压力角的计算公式。
The conventional empirical formula to calculate the maximum electrical intensity at conductor circular corner for large generators is modified, and a more reasonable formula is developed.
修正了传统计算大型发电机导线角部最大场强的经验公式,提出了更合理的计算公式。
A general diffraction formula for circular apertures is derived. This formula is not limited by the aperture radius and the distance from the screen and can be used as a theory of near field optics.
推导了圆孔衍射公式,该公式不受孔径大小和到屏距离的限制,可以作为近场光学的理论。
Objective for present shortcoming of water depth of uniform flow in circular section, which is great calculating error and small application scope, this paper desired to get a new approximate formula.
【目的】针对目前圆形断面均匀流水深计算公式存在计算误差大、适用范围小的弊端,欲提出一种新的近似计算公式。
Double Angle formula can transform the circular function equation to a biquadratic algebraic equation, and the analysis solution can be solved by extract equation directly.
用倍角公式可将该三角函数方程转化成一个四次代数方程,然后用求根公式直接求出解析解。
A formula is given to calculate the stress in tooth middle of GB12759-91 double circular-arc gear via regression analysis in this paper.
本文用回归分析法求得了GB12759—91型双圆弧齿轮的齿腰应力的计算公式。
Combining practical matters, a method of the stress calculation of circular ring plates under press loading using flat circular plates formula was introduced.
本文结合实际问题,给出了利用《应力应变公式》中的等厚平圆板公式对受压环板应力的理论计算方法。
In consideration of melt pressure, the circular plate thickness can be calculated in accordance with the formula.
考虑熔体压力,圆形板厚度可由公式算出。
In this paper, the design of curve of grooved drum is researched, which deduced two types of circular cone curves analytic formula of grooved drum.
探讨了槽筒沟槽曲线的设计,导出了络圆锥筒子的二种类型的曲线解析式。
Besides, the projecting formula of the circular arc is also listed in the paper, which can offer the computer a calculating method to draw stereoscopic projection.
本文还给出了圆弧的投影方程,为计算机绘制极赤图提供了计算方法。
Results of the proposed formula for plain circular hole were compared with the experimental and theoretical data, and they agreed well.
将得到的简单平圆孔的计算公式与实验资料和理论分析结果进行了比较,吻合的很好。
The theory of Circular Standiug-wave meter is analyzed in this paper, A formula of detector current is obtained and the calculated values are found to agree with the experimental results.
本文分析了环形驻波测量仪的工作原理,导出了检波电流的表达式。理论计算与实验结果相一致。
The theory of Circular Standiug-wave meter is analyzed in this paper, A formula of detector current is obtained and the calculated values are found to agree with the experimental results.
本文分析了环形驻波测量仪的工作原理,导出了检波电流的表达式。理论计算与实验结果相一致。
应用推荐