The circuit noise and digital pulse interference have been restrained effectively through the system analysis.
通过对系统的细致分析，有效地抑制了电路噪声和数字脉冲干扰。
This amplifier's drive capability limits the resistor's minimum value, and the overall circuit noise limits the maximum value.
放大器的驱动能力限制了电阻的最小值，全电路噪声限制电阻最大值。
It includes wiring of printed circuit board, electric capacity coupling, tolerance of digital circuit noise, and transmission line.
其中包括对印制板的布线、电容性耦合、数字电路的噪声容限和传输线的探讨。
The problems of circuit noise and collecting speed concerning the design of the real random number collecting system are also discussed.
同真随机数采集系统设计相关的电路噪声问题以及采集速度问题也作了讨论。
When using pulse counting method, the precision of pressure-measuring with vibrating-wire sensor is influenced by the precision of pulse counter, circuit noise, temperature compensation, etc.
应用振弦式传感器并基于脉冲计数法进行压力测量可达测量精度受脉冲计数精度、电路噪声及温度补偿等多重因素影响。
If the magnitude of this noise is large enough it can turn an electronic circuit to junk.
如果噪音的强度够大就可以将电子回路变成一堆垃圾。
It features with simple circuit, accurate position detection, immunity from noise and common mode disturbance and wide speed scope.
该控制系统的优点是电路简单，位置检测准确，免受噪声和共模干扰影响，调速范围增加。
A circuit used for detecting the signal of the micromachined gyroscope with capacitive detection is pre-sented, and its capability of restraining noise is also analyzed.
提出了一种适用于电容检测型微机械陀螺的信号检测电路并分析了其对噪声的抑制能力。
If the short circuit has a very low thermoelectric EMF, this can be used to verify input noise and zero drift with time.
如果输入端的短路点具有很低的热电动势，用这种方法就可以验证输入噪声和零点随时间的漂移。
Advanced electronic design offers many features such as operation from 5-26 volts DC power, short circuit protected outputs, and EMI noise resistance.
先进的电子设计提供了诸如操作许多功能，从5月26日伏直流电源，短路保护，输出和EMI噪声阻力。
Extreme low noise level Smart Fan Control Circuit based on our Automatic Temperature sensor.
超低噪音水平智能风扇控制电路我们的自动温度传感器。
The signal processing circuit has strong ability to suppress noise interference.
信号处理电路具有较强的抑制噪声干扰能力。
According as principal of cross-correlation, the hardware circuit is used to restrain noise efficiently and acquire faint change of crack signal.
根据互相关原理，设计了相应的硬件相关电路，有效的抑制了噪声并能够提取缺陷信号的微小变化量。
Selecting the appropriate circuit model and then analyzing their frequency accuracy, the requirement for the noise suppression and channel linearity.
选择合适的电路形式，再分析它们的频率精度和噪声抑制要求，以及对信道的线性要求。
The signal processing circuit has high ability to suppress noise interference.
信号处理电路具有较强的抑制噪声干扰能力。
Low noise, high linearity RF front end circuit is the key of the whole RF receiver system design.
低噪声、高线性度的射频前端设计是整个射频接收机系统电路设计中的关键。
The variable volume and pressure compensated design simplifies circuit design, and reduces heat buildup and noise.
采用多流量、压力补偿设计简化了电路设计，降低了热堆积和噪音。
A column readout circuit to reduce fixed pattern noise (FPN) for CMOS active pixel sensor images is presented.
针对CMOS有源像素传感器，提出一种降低固定模式噪声(FPN)的列读出电路。
The method can effectively reduce noise interference of the detecting circuit and increase signal noise ratio of the output signal.
该方法可有效地降低检测电路的噪声干扰，提高输出信号的信噪比。
In intelligent peripheral subsystem, Radio Frequency Front Modules include linear power amplifier, low noise amplifier and detection control circuit.
智能天线子系统中，射频前端模块包括线性功率放大器，低噪放大器，检测控制电路。
Using method of Fokker-Planck equation, effects of electrical current in RL circuit are discussed, and the effects of noise parameters on stationary probability distribution are analysed .
利用福克-普朗克方程的方法，讨论了RL回路中热涨落产生的电流效应，分析了噪声参数对电流定态几率分布函数的影响。
The RF pulse-to-pulse phase noise through microwave test circuit becomes a VF pulse signal of random fluctuation.
射频脉间相位噪声经过微波检测电路、视频电路后变成随机起伏的视频脉冲信号。
The microwave circuit unit is composed of microwave signal resource, low noise amplifier and microwave detector.
测量系统采用了微波信号源、低噪声放大器和微波检波器等组成微波电路单元。
This paper presents a new type of low noise frequency conversion circuit based on the research of phase noise conception, generation as well as relativity measurement method.
本文在对相位噪声的概念、产生及其相关测量方法研究的基础上，设计出一种低噪声频率变换电路。
For maximum exceed noise ratio generated, circuit structure to match the equivalent circuit diagram of the solid-state noise diode in avalanche breakdown state has been designed.
根据固态噪声二极管在雪崩击穿状态的等效电路，设计出与之匹配的电路结构，以实现超噪比的最大输出。
Furthermore, the change of the noise through narrowband filter and detection circuit and the effect on the radar tracking precision are analyzed in quantity.
对噪声经过窄带滤波、检波电路后的变化及其对雷达跟踪精度的影响进行了定量分析。
The noise model of the conversion circuit is analyzed in detail.
详细分析了转换电路的噪声模型。
The system consists of driving pulse generating circuit for CCD, instrumental amplifier with low noise, MCU controlling circuit and PC program for dealing with the data conveyed by MCU.
系统包括CCD驱动脉冲产生电路、低噪声测量放大电路、自适应比较电路、单片机控制电路以及上位机处理程序。
The system consists of driving pulse generating circuit for CCD, instrumental amplifier with low noise, MCU controlling circuit and PC program for dealing with the data conveyed by MCU.
系统包括CCD驱动脉冲产生电路、低噪声测量放大电路、自适应比较电路、单片机控制电路以及上位机处理程序。
应用推荐