By running an electrical current through the cell, using an ordinary battery charger, the copper in the anode (and in the pins) dissolves and is deposited on the lead cathode.
要想让电流通过电解池，你需要一个普通的电池充电器。阳极和针脚里的铜溶解之后会聚集在阴极上。
Electrolysis: make the current through the electrolyte solution at the anode and cathode cause REDOX reaction process.
电解：使电流通过电解质溶液而在阳极，阴极引起氧化还原反应的过程。
It and reversing current different is not to be, but with a anode intermittently stop, because the intermittent power supply current interrupted, cathode potential with time periodically change.
它与换向电流所不同的是不把镀件作阳极，而是间歇地停止供电，由于间歇中断电流，阴极电位随时间周期性地变化。
Along with the increase of the current density, cathode polarization effect, coating grain with increasing more and fine.
随着电流密度的增加﹐阴极极化作用随着增加﹐镀层晶粒越来越细。
Cathode temperature is one of the most important factors influencing the stability of high current glow discharge.
阴极的温度是影响大电流辉光放电稳定工作的重要因素。
Field emission stability and life time of CNT cathode is closely related with the vacuum level, thermal effects during the emission and the current transport capability.
影响碳纳米管阴极场发射稳定性和寿命的主要因素有真空度、场发射过程中的热效应以及场发射体对场发射电流的承载能力等。
Two layers of organic material are sandwiched between two conductors. When a current passes from the cathode to the anode a bright light is produced by the organic material.
两层有机物质层夹在两层导体之间。
Silicon power rectifier diode. Cathode to case. Repetitive peak reverse voltage 800v. Average rectified forward current 25a.
硅功率整流二极管。阴极情况。重复峰值反向电压800v。平均整流电流25a。
Electric lift oil: containing alkali solution in to parts used as an anode or the cathode, in the current function, remove the process of surface oil parts.
电解除油：在含碱溶液中，以制件作为阳极或阴极，在电流作用下，清除制件表面油污的过程。
When the current density is too low, the cathode polarization effect, smaller coating, not even orange crystal bulky coating.
当电流密度过低时﹐阴极极化作用较小﹐镀层桔晶粗大﹐甚至没有镀层。
Cathode production surpassed this design by 1997 through innovative process optimization and increasing the current density.
到1997年，通过工艺的革新优化，并提高电流密度，使阴极铜的产量超过了该设计能力。
Large current hot cathode glow discharge was used for plasma chemical vapor deposition of diamond films. It improved deposition rate and films quality efficiently.
大电流热阴极辉光放电用于等离子体化学气相沉积金刚石膜，有效地提高了沉积速率和膜品质。
A carbon nanotube cathode with high emission current has been fabricated with the screen printing method.
研究了利用丝网印刷法制备碳纳米管阴极，以获取很大的发射电流。
To realize the high efficiency of dernisting, thenew type cathode wires and anode tubes with superperformance were developed for increasing the current density and field intensity.
实现除雾高效化，关键在于研制高性能的新型阴极线和阳极管，提高电流密度和电场强度。
From the experiment result of metal specimens buried in underground, discussing the influence of AC stray current on cathode protection by using galvanic anode method.
根据室外现场埋片试验结果，讨论了杂散电流对牺牲阳极阴极保护性能的影响。
If the vacuum near the cathode is too poor, it will generate spark, gas ionization and ion bombardment on cathode, which can result in a fast attenuation of the emission current.
如果碳纳米管阴极附近的真空度太低，将产生打火、气体电离、离子回轰阴极等问题，将导致阴极发射电流的迅速衰减。
Applying: broadly used in the outer current cathode protection of the sea oil drilling platform, underground pipe and cable etc.
应用：高硅铸铁阳极广泛应用于海上石油钻井平台，地下管道地下电缆等设施的外加电流的阴极保护。
To design electron guns with plane cathode according to high current electron optics theory.
根据强流电子光学理论，在填充等离子体条件下，设计平面阴极电子枪。
The authors discussed the relationship that the overvoltage of cathode and anode are varied with the current density in terms ofthe electrochemistry.
从电化学理论上讨论了阴极、阳极过电位与电流密度的关系。
This paper mainly discusses how to design a high stability current control power supply for laser gyro of double anodes and common cathode in North-Finder based on Ring laser Gyroscope.
论文主要阐述了寻北仪中双阳极共阴极结构的激光陀螺高稳定度稳流电源的实现过程。
You must take this difference in the magnitude of the cathode current into account when selecting values for R7 and R8.
在选择R7和R8的阻值时，你必须考虑这两种不同大小的阴极电流的区别。
Non uniform temperature distribution causes deviation in emission current, the error of which is less than 5% for the shortest length of diode cathode.
对阴极温度的不均匀导致的发射电流偏差进行了计算分析，并首次得到了发射电流误差小于5%的阴极丝最小长度的计算公式。
Note that the relatively large cathode current of the TL431CLP requires correspondingly small values of R7 and R8.
注意到TL431CLP产生较大的阴极电流需要相应阻值较小的R7和R8。
Reasonable designs of the structure parameters of PB layer and the gate-cathode geometry are obtained by numerical iteration and an equivalent current model.
文中采用数值迭代法和建立等效电流模型，对P_B层结构参数和门极-阴极几何图形尺寸进行了合理设计。
Using beam emission models, the influence to the magnetron characteristics by the cathode current destiny can be obtained.
利用磁路电子注发射方式针对不同的阴极发射电流进行了动态模拟，得到了不同发射电流条件下磁控管的工作特性。
The effect of the current density and fuel cell temperature, humidified temperature of cathode and anode, porosity of porous diffusion layer on the results mentioned above are discussed.
讨论了质子交换膜燃料电池运行电流密度和温度、阴极和阳极加湿温度、气体扩散层孔隙率等参数对以上结果的影响。
In the electroforming process, the anode electrode shape and position determine the current density distribution on the cathode and so the distribution and properties of the deposited metal.
电铸阳极的形状和位置决定了阴极表面电流密度的分布，并最终影响金属沉积层分布的均匀性及其材料性能。
The phenomenon of double arc which is usually caused by the reasons of too big welding current, too small diameter of the nozzle and eccentric of the cathode has been simulated.
针对造成双弧现象的原因，模拟分析了由于电流过大、喷嘴压缩孔径过小和钨极偏心三种因素所导致的双弧现象。
Our experiments showed that it can ensure the same stability of thermal emission current by use of a new method of corroding cathode point.
实验表明，采用新方法对阴极尖端进行腐蚀后得到的尖端阴极，同样可保证热发射束流的稳定性要求。
Our experiments showed that it can ensure the same stability of thermal emission current by use of a new method of corroding cathode point.
实验表明，采用新方法对阴极尖端进行腐蚀后得到的尖端阴极，同样可保证热发射束流的稳定性要求。
应用推荐