Abstract: in the three-dimensional model, the cable path is formed with a series of bridge components (Pipe, Branch, components, etc.), the cable will be used when laying the cable path.
摘要：在三维模型中，电缆路径通过一系列的桥架元件来组成(Pipe、Branch、Components等)，电缆敷设时将会用到电缆路径。
When creating metal wire cables I started from creating the section of all 6 wires that are a part of the whole cable and a path.
当创建金属电缆时，我首先创建来所有6根线的界面，那是整个电缆的一部分，以及一条路径。
Continuity checks are typically performed on a variety of devices, including cable assemblies, printed circuit boards, and connectors, to ensure these components have a continuous path where desired.
各种各样的装置都需要进行通断性检查，包括电缆成套件、印制板和连接器，以确保这些元件具有预期的连续通路。
In the future, power cable nearly becomes the main path for the power transmission and distribution, especially in the city and the power user of large scale industry.
特别是在城市及大型工业电力用户，电缆几乎成为今后主要的电能传输、分配的途径。
Examples of insulation resistance measurements include measuring the path be tween traces on a printed circuit board or the resistance between conductors in a multi-conductor cable.
测量绝缘电阻的例子包括测量印制板上走线之间的通路，或多芯电缆中导线之间的电阻。
Seismic data and system order are transmitted through the path defined by the operator, which can avoid the lay -out problem produced by separate cable fault.
地震数据及系统命令沿操作者定义的路径传输，可避免因个别电缆故障而引发的排列问题。
Currents often cause feathering of the cable away from the ship's path.
潮流的影响，常常会使拖缆偏离船只的航线。
But the existence of noise funneling in the return path of cable network in HFC system restricts the selection of modulation techniques for the return path.
但HFC网络中同轴电缆网络上行信道中存在的噪声漏斗效应限制了上行信道调制技术的选择。
A resistive load placed at the end of a cable to prevent data signals from reflecting back into the data path.
终结器就是置于电缆终端的一个电阻负荷，用来防止数据信号又反射回到线路中去。
The laying path, basic structure, layout mode, the intermediate joint structure and grounding mode of the cable were also described.
介绍了电缆敷设路径、电缆的基本结构、布置方式、电缆中间接头的结构、电缆接地方式。
Modules at each end of the cable provide a phantom path for telephony signals between a telephone near the data set and a PBX, through both conductor pairs in a phantom circuit arrangement.
配置在电缆两端的模块通过幻象电路配置内的两对导线为一个靠近数据设备的电话机与一个PBX之间的电话信号提供一个幻象通路。
The cable provides a continuous drain path for melting snow and ice to flow (through the gutter and into the downspout ).
电热带提供了一条连续的排水的路径。
All cable lines will be laid underground along the planning path.
以上电缆线路均沿规划路径埋地敷设。
A radio frequency band or cable segment providing a single path for transmitting electrical signals.
供单一线路传播电子信号的一段广播频率或部份电缆。
This article introduces an Advanced Physical Layer technology to the data return path over cable network.
介绍了一种利用有线电视网络进行数据通信的回传通道的高级物理层技术。
In order to avoid immense loss for optical cable break, a quick fault detection and optical path automatic switching system is designed and realized.
为避免光缆阻断带来的巨大损失，本文设计完成了一个光纤故障快速检测光路自动切换系统。
The ultimate load of cable-stayed bridges is determined by the failure path of structure under the dead load.
在自重荷载作用下，斜拉桥极限承载力与结构的失效路径有关；
They manage the resource of optical cable, equipment, transmission path, and so on. the whole system is based on the equipment and optical cable subsystem.
其中，设备管理子系统和光缆管理子系统是整个系统的基础，分别生成空闲的设备埠和光缆纤芯资源，光电路子系统则市对这些资源进行占用、管理。
Finally, points out the main problems exists in the HFC network: noise funneling in the re-turn path; control tactics of noise; reflection in the cable.
同时对双向HFC网存在的主要问题：上行通道噪声漏斗效应、各种噪声干扰控制策略、回波反射等进行了说明。
Magnetic suspension technology was explored for the cable-creating machine. Theoretical analysis and designing method with consideration of magnetic path, temperature were presented.
针对电缆管绞机中的实际要求，在对其磁力悬浮系统的磁路、磁力以及电阻和温度等各方面进行理论分析的基础上，提出了设计方法。
Magnetic suspension technology was explored for the cable-creating machine. Theoretical analysis and designing method with consideration of magnetic path, temperature were presented.
针对电缆管绞机中的实际要求，在对其磁力悬浮系统的磁路、磁力以及电阻和温度等各方面进行理论分析的基础上，提出了设计方法。
应用推荐