In the section of hardware design, selection of the CAN bus communication interface card, design of CAN nodes and the signal acquisition system are introduced.
在其硬件设计中，着重介绍了CAN总线通讯接口卡的选择、CAN节点设计与信号采集系统设计。
The data transfer rate between varied boards in radar signal processors based on VME or CPCI bus was limited by the bus rate.
在基于VME总线或CPCI总线的雷达信号处理机中，板与板之间的数据传输速率受限于总线的速率。
In this paper, a signal processing system based on PCI bus is designed and completed, which is made up of four chips of ADSP21060 (SHARC) which the most advanced parallel DSP device.
本论文采用当前国际上较流行的DSP器件ADSP21060 (SHARC)，设计和实现了一个基于PCI总线的四片adsp21060并行信号处理板。
The serial bus can carry multiple channels of data at the same time in a multiplexing signal.
数据的串行总线可以携带多个通道同时在一个多路复用信号。
Based on the designed PCI bus memory card, the signal definitions and command operations of PCI bus and the process of data access on the PCI bus are discussed in detail.
以自行开发的PCI总线存储卡为背景，详细论述了PCI总线的信号定义和命令操作，以及总线上的数据传输过程。
The structure of the switching module and the bus signal distribution of the motherboard are described in detail. Then the controlling cards and switching cards are developed.
以转接模块的设计为重点，详细介绍了转接模块的结构、背板信号的分布以及控制板、转接板的开发和设计。
PCI bus is a popular computer bus presently. The character, signal, command and transfer protocol, configuration of PCI bus were introduced in this article.
PCI总线是目前流行的计算机总线。文章介绍了PCI总线的特点，描述了PCI总线的信号、命令、传输协议与PCI总线的配置空间。
With the development of fabricate technology for digital signal processor (DSP), the power dissipation of the bus is the main part of the wh ole power dissipation in DSP.
随着数字信号处理器制造工艺的进步，总线的功耗已经成为数字信号处理器功耗的主要组成部分。
A scheme of signal conditioning platform based on USB bus technology is put forward in the paper after studying the open general-purpose signal-conditioning platform for ATS.
针对开放式通用ATS信号调理平台进行研究，提出了基于USB总线技术的信号调理平台设计方案。
A signal acquisition card for inductance sensor based on PCI bus is designed in this paper.
研制了一种基于PCI总线的电感传感器信号采集卡。
HART communication protocol which belongs to transitional protocol introduced in this paper is rudiment of field bus, which permits transmitting digital signal on analog signal circuit.
HART协议是现场总线的一种过渡性协议，可使数字与模拟信号同时传送且互不干扰，实现双向通讯。
This paper introduces the problems of Signal Integrity in high-speed parallel bus interconnect design and the new design methodology.
本文介绍了高速并行总线互连设计中出现的信号完整性问题及新的设计方法学。
In this system, the application of the CAN bus accomplish the hypogyny-computer and CAN ignition of network topology, realization of each node monitoring and signal transmission.
在该系统中应用CAN总线实现了下住机和CAN点火器的网络拓扑设计，实现网络上各个节点的监控和信号的传输。
This paper presents the function and characteristics of CAN bus, and gives more description of CAN intelligent nodes application in coal transportation signal, integrated and blocked system.
在了解CAN总线功能与特性的基础上，重点阐述了CAN总线智能节点在煤矿运输信、集、闭系统中的应用。
In data storage transmission modular, we adopt PCI bus line and FIFO data memory carry out succession for plenty of data to storage transmission, guarantee AE signal accurate collecting.
数据存储传输模块采用PCI总线和FIFO数据存储器对大量的数据进行连续存储传输，保证数据的准确完整。
Subsequently, a novel controller for DC bus voltage regulation is put forward according to the small signal model based on the instantaneous power balance in AC and DC sides of three-phase SAPF.
然后根据交流侧和直流侧的功率平衡方程，推导了电压环的小信号模型。最后基于该模型设计了一种高动态性能的直流电压调节器。
HART protocol which is the transitional protocol of field-bus allows transferring both digital signal and analog signal simultaneously in order to actualize bidirectional communication.
HART协议是现场总线的一种过渡性协议，可使数字与模拟信号同时传送且互不干扰，实现双向通讯。
It revolves around four aspects to spread out, that is bus-only approaches, bus stop, transit signal priority in the intersection, bus Rapid Transport (BRT).
具体围绕公交专用进口道、公交停靠站、交叉口公交信号优先、快速公交四个方面展开。
Most of the monitoring systems for roof bed separation are designed based on RS-485 BUS, which is low in both signal transmission efficiency and reliability.
国内顶板离层计算机测控系统多采用RS- 485总线，传输效率低，可靠性不高。
Most of the monitoring systems for roof bed separation are designed based on RS-485 BUS, which is low in both signal transmission efficiency and reliability.
国内顶板离层计算机测控系统多采用RS- 485总线，传输效率低，可靠性不高。
应用推荐