• An example is a bolt hole circle, in which the diameter of the bolt circle, the spacing of thebolt holes, and other parameters must be specified.

    例如螺栓圆形,螺栓直径其中必须指定螺栓其他参数间距

    youdao

  • Permissible deviation of bolt hole circle diameter on flange and permissible limited deviation of two adjacent holes on flange shall be less than 0.6mm.

    法兰螺栓中心直径容许偏差法兰相邻极限容许偏差的小于0.6毫米

    youdao

  • The size of the hole away from the plate edge should be not less than 40 mm, all the hole diameter should be greater than the bolt diameter, heat bilges cold shrink to fit the board.

    板材边缘尺寸少于40mm所有钻孔直径大于螺栓直径,以适应板的热胀冷缩。

    youdao

  • The size of the hole away from the plate edge should be not less than 40 mm, all the hole diameter should be greater than the bolt diameter, heat bilges cold shrink to fit the board.

    板材边缘尺寸少于40mm所有钻孔直径大于螺栓直径,以适应板的热胀冷缩。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定