This method can reflect bearing condition of the whole lifting mechanism plainly.
这种方法可以清楚地反映整个举升机构的受力情况。
The oil-bearing condition of reservoir is mainly controlled by permeability when porosity is high to 10%.
当孔隙度大于10%时，储层的含油性受渗透率控制。
However, pile drivers are too bulky since the bearing condition of the mechanical model of pile drivers is different from that of crane jibs.
但是由于桩架力学模型的支承条件与起重机臂架不同，故桩架显得笨重。
To know the gas-bearing condition in shallow stratum, it must do two main works: calculate the store parameter and modeling set and distinguish hydrous and gas.
要搞清楚地层的含气状况，则需要开展两方面的工作，即储层参数计算模型建立与含水含气性识别。
By analysing the bearing condition of pier cap and foundation beam (tie beam), this article gives the design approach of pier cap and foundation beam (tie beam).
通过分析墩帽及基础梁(拉梁)的受力状态，提出了墩帽及基础梁(拉梁)的设计方法。
Real bearing condition of structures is identified according to measured modal frequencies of undamaged structures. The finite element model on in situ test structure is established.
通过现场试验实测结构的模态频率，根据未锈裂结构的模态频率识别出结构的实际支承条件，建立现场试验结构的有限元模型。
Based on the concept, geometric characteristics, stress condition and border bearing condition of cable nets, a discussion is made on structure select ion and application of cable nets to a gymnasium.
根据索网结构的概念、几何特征、受力性能及边界支承条件，浅谈索网结构在体育馆的结构选型和应用。
Axle heat damage caused by a wheel bearing fracture may lead to such a condition.
轮轴承断裂造成轴的热损伤可能会导致这类情况。
From practice, the components of the malicious tort litigation is that tort liability is the condition of actor bearing and is to determine whether the act should bear tort liability standard.
而从实践方面来说，恶意诉讼侵权责任的构成要件，是行为人承担侵权责任的条件，是判断行为人是否应当担负侵权责任的标准。
TROUBLESHOOTING GUIDE: common bearing failure modes are described, allowing you to make an assessment of your own bearing's condition and provide feedback on cause and effect.
故障排除向导：常见的轴承损坏方式已经列出，以便您确定轴承损坏情况并向我公司反馈。
The time domain identification of model parameters of rotor bearing systems is helpful for condition monitoring and fault diagnosis of rotating machines.
轴承-转子系统模态参数时域识别对于回转机械的状态监测与故障诊断具有重要意义。
The research has provided a feasible method for accurate diagnosis of main bearing wear condition in diesel engines.
此研究为准确诊断柴油机的主轴承磨损状态提供了可行的方法。
General loading condition of rolling mill bearings is medium - heavy load and shock load, thus the most suitable material is carburising bearing steel.
轧机轴承一般载荷条件是中重载荷和冲击载荷，因此，最适用的材料为渗碳轴承钢。
After test the obtained data are treated and the bearing capacity of shaft lining and the stress condition of its structure are analysed.
试验后对所得的数据进行处理，并且分析了井壁的承载能力和井壁结构受力状态。
To make technical condition evaluation of bridge is to find out the bearing capacity and performance of the bridge and whose result is very important for the safe and reliable operation of bridge.
对桥梁进行技术状况评定是为了了解桥梁的承载能力及运营使用情况，其结果对桥梁的安全可靠运营非常重要。
The thesis come from the analysis of stationary type tri-oil wedge dynamic-pressure sliding bearing dynamic working condition, analyse its elements and stress in variable-load operating mode.
本研究从固定式三油楔动压滑动轴承动态工作状况分析入手，分析了固定三油楔动压滑动轴承的原理以及变载荷工况下的受力状态；
Steel roller bearing is working in the harsh condition of heavy load, high speed and water washout, etc.
轧辊轴承是在重载荷、高转速、工作环境很恶劣的情况下工作的。
The finite method of EHLwas used to analyze the properties of sector pad and circular pad thrust bearing separately on the condition of centre pivoted.
应用有限元程序分别对圆形瓦和扇形瓦推力轴承在中心支承条件下的性能进行了计算。
The stability allowance of elliptic bearing and three oil wedge under the design parameter and operating condition in middle and light loading area is discussed.
讨论了在设计参数及运行条件下椭圆轴承和三油楔轴承在中、轻载区的稳定性裕度。
The aviation main shaft bearing usually works under the condition of high speed and high temperature.
发动机主轴轴承常常在高速条件和高温环境下工作。
By checking the large hanging type asynchronous motor for the gluey condition of babbit of the sliding bearing, a quality problem of the bearing is found.
通过检查大型悬挂式异步电动机滑动轴瓦锡基轴承合金粘合情况，找出轴瓦存在的质量问题。
It turned out that this method could assure bearing in optimal windage condition in concrete working condition, accordingly achieve the longest service life.
实践证明这种方法可以保证轴承在具体的工作条件下处于最佳的工作游隙状态，达到最长的使用寿命。
On the condition that exchange is installed, to adopt XRN can increase reliability and the capacity of network core, without bearing the burden of complex network management.
在已经安装交换机的条件下，采用XRN可增加网络核心的容量和可靠性，无需复杂的网络管理负担。
In view of the severe situation about the bed disease in the existed railway tunnel, the mechanics condition on the railway tunnel bed was analyzed by using the elastic bearing method.
针对我国既有铁路隧道铺底病害严重的现状，采用弹性支承法，对铁路隧道铺底结构的受力状态进行分析。
On the other hand, gravel ground condition is a good bearing stratum for piles, which is often met with in civil construction.
另外，卵石地层是土木工程建设经常遇到的地质条件，是桩基良好的持力层。
With the limit equilibrium condition, the ultimate bearing capacity of rock foundation was deduced under general shear failure.
根据极限平衡条件，推求了地基整体剪切破坏模式的岩石地基极限承载力。
Owing to the change of operating condition and serious water bearing in crude oil, the top of atmospheric tower is corroded and boring.
因操作条件变化和原油带水严重，造成常压塔顶部塔壁腐蚀穿孔。
The governing object function and two boundary condition: settlement and foundation bearing capacity are developed in the optimization design of the PCC pile composite foundation.
建立了PC C桩复合地基优化设计的目标控制函数和两个约束条件：沉降控制条件和承载力校核条件。
The minimal water film thickness is the basic condition which ensure the water hydraulic static bearing of valve plate working well.
最小水膜厚度是保证配流盘静压支承工作的基本条件。
Directed at the working condition of special nonstructural engineering reducers, the spherical roller bearing with extended outer ring is designed.
针对专用建筑减速机设备的工况，设计了宽外圈调心滚子轴承。
应用推荐