The effects of polarization, surface roughness and physical temperature on surface apparent temperature are investigated.
研究了极化、表面粗糙度和物理温度对表面视在温度的影响。
Through comparing with the comfort model used widely currently, the apparent temperature model on the basis of thermal equilibrium is proved to be more universal.
经与我国目前应用较为广泛的人体舒适度统计模型的计算结果相比较,证明以热量平衡为基础的人体体感温度模型更具有普遍性。
A new study, however, finds it's a lot more complicated - even as it dispels climate change deniers' claims that urban "heat islands" are a major cause of apparent temperature increases.
不过,一项新的研究发现它复杂多了——哪怕它证伪了否认气候变化者(关于)城市热岛效应是温度升高主因的宣告。
Apparent amylose content (AAC), gel consistency (GC), and gelatinization temperature (GT) are recognized as the most important determinants of rice eating and cooking qualities.
表观直链淀粉含量(AAC),胶稠度(GC)和糊化温度(GT)是决定稻米蒸煮和食用品质的关键因素。
The variation characteristics of temperature, precipitation and air humidity in the Shihezi Oasis have apparent seasonal.
石河子绿洲的温度、降水量以及空气湿度具有明显的季节变化特征。
The influences of the factors, such as ethanol solution, sodium hydroxide, propylene oxide, reaction temperature, reaction time on apparent viscosity and water insoluble substance of HPG are studied.
研究了合成过程中乙醇溶液、氢氧化钠、环氧丙烷、反应温度、反应时间等因素对产品表观黏度和水不溶物含量的影响。
It was further indicated that the apparent volume of CTCBE was decided by the crystallization temperature.
进一步表明CTCBE在自然缓冷固化的表观体积根本上由其结晶温度决定。
The effect of loading rate, test temperature and pre-plastic deformation on hydrogen induced apparent yield stress reduction have been investigated.
研究了变形速度,试验温度以及预先塑性变形程度对氢致表观屈服强度下降的影响。
Whereas the apparent activation energy (Q) is affected by microstructure, temperature and strain rate.
合金的表观激活能与材料的状态、变形温度及变形速率有关。
The apparent characters such as canopy temperature, senescence of canopy leaves and awns can be used to identify cold temperature materials and to select cold temperature posterity.
在育种实践中,可考虑将冠层温度、冠层叶片和芒等表观性状有机结合,以快速、准确地识别冷温材料,选择冷温后代。
The kinetic parameters of reduction were determined and apparent effect of temperature on reduction was observed.
测定了还原动力学参数,观察到温度对还原性能有着明显的影响。
While at lower temperature, apparent density increases with the increasing of screw revolution speed.
而较低的温度下,表观密度随螺杆转速的提高而增大。
In this paper, the concentration of initiators, reaction temperature, reaction time and their effects on apparent grafting efficiency (G_a) and anti-shrinkage efficiency (ASE) value have been studied.
本文研究了引发剂浓度、反应温度及反应时间对表观接枝率(g_a)和抗收缩系数(ase)值的影响。
The effects of bed temperature, input concentration, apparent gas speed, and absorbent grain size on the absorption performance were studied.
考查了床层温度、进料浓度、表观气速和吸附剂粒径对吸附性能的影响。
The analysis of microstructure can also reflect the regulation of the effect on the apparent viscosity of factors, such as shear rate, temperature and cooling rate.
显微结构分析也可以反映出剪切速率、温度和冷却速度对表观粘度的影响规律。
Two methods which were derived from the temperature and apparent activation energy at glass transition and from VFT equation were used to calculate the viscoelastic coefficients in WLF equation.
通过玻璃化转变温度和表观活化能以及由VF T方程导得WLF方程粘弹系数的两种新计算方法。
All of above provides a temperature environment that approaches to the real physiological state for the quasi vivo measurement of human blood apparent viscosity.
这为准在体测量人体血液表观粘度提供了接近生理状态的温度环境。
Finally, the macro-kinetic equations were as follows: According to the experimental data at different temperature , apparent reaction rate constants were obtained.
最终得到的宏观动力学方程如下:通过对不同温度下的实测数据进行参数估值,得到了各温度下的表观反应速率常数。
The results show that the apparent density of hard elastic polypropylene increases with a lower melt temperature, or a higher draft ratio, or a higher air blasting speed.
结果表明,熔体温度下降、所受拉伸比增加或冷却风速度升高均可使表观密度增加。
It has been found that the apparent viscosity of PBR is sensitive to shear rate, shear stress, and to temperature at lower shear rate levels as well.
表观粘度对切变速率和切应力较敏感,并且,在低切变速率下对温度也较敏感。
The corrosive solution and test temperature have no apparent effects on the grooving corrosion sensitivity coefficient.
腐蚀介质和介质温度对沟槽腐蚀敏感性系数无显著的影响。
Moreover, the low molecular weight and higher temperature are favorable to reduce the melt viscosity, to increase the critical shear rate and to improve the apparent quality of extrudates.
较低的分子量和较高的温度有利于提高临界剪切速率,改善挤出物外观质量和降低熔体粘度。
The phenomenon of increasing shear force, and decreasing apparent viscosity, showed that it was a kind of Pseudo plastic Fluid. As the temperature increased, the apparent viscosity decreased.
表观粘度测定显示辛烯基琥珀酸淀粉酯具有剪切变稀现象,属于假塑性流体,表观黏度随着温度升高而下降。
The characteristic values of temperature and pressure constant in the model can directly reflect the effects of temperature and pressure on apparent viscosity.
模型中温度和压力的特征值可直观地反映温度和压力对表观粘度的影响程度。
Its apparent viscous flow activation energy is higher so the influence of temperature on characteristics of melt is stronger.
由于其表观粘流活化能较大,故熔体特性受温度影响较大。
The background current, the dc electric conductivity and the apparent dielectric constant of KLiSO4 single crystal exhibit sharp peaks besides jump nearby the transition temperature.
在相变温度附近,本底电流、直流电导率和表观介电常数除发生跃变外还出现一个尖锐的小峰。
It can be concluded that the apparent difference of the temperature between the two places lied in the maximum and minimum temperature.
由此可见两地温度的显著差异在于极端最高和最低温度的差异。
Resistivity apparent formation factor, apparent cement exponent, resistivity index and apparent saturation exponent of shaly sands are related to temperature.
泥质砂岩电阻率、视地层因素、视胶结指数、电阻率增大系数、视饱和度指数均与温度有关。
The output power is very stable after the temperature cycling and vibration test. No apparent power decrease has been observed as the device working continuously for 500 h.
该光纤耦合模块连续工作500小时没有发现明显的功率衰减,并且输出功率经温度循环和振动冲击后具有较好的稳定性。
The output power is very stable after the temperature cycling and vibration test. No apparent power decrease has been observed as the device working continuously for 500 h.
该光纤耦合模块连续工作500小时没有发现明显的功率衰减,并且输出功率经温度循环和振动冲击后具有较好的稳定性。
应用推荐