The 14-bit, four-channel A/D converter MAX1325 is employed to sample the analog input and output voltage of the synchro and then converted them into digital.
模数转换采用了14位，四通道A／D转换器MAX1325，实现了自整角机四路模拟数据的同时、快速采样。
Since the signal which is disposed by the SCM usually is the Digital Signals, before the Analog signals are checked by the processor, they must be conversed by the A/D converter.
由于单片机所处理的信号是数字信号，对模拟电压信号进行检测处理时首先要用A／D转换器件对其进行A／D转换，然后再进行处理。
The temperature and pressure sensor gathered on-the-spot temperature and pressure signal, and A/D converter converted analog signals into digital signals to revise the on-the-spot flow of natural gas;
温度和压力传感器采集现场温度、压力信号并经A/D转换器转换成数字量用于对现场天然气流量进行温度、压力修正；
One of the important conceptions of Software Radio is to make A/D converter close to antenna, we should convert IF analog signal even RF analog signal into digital signal.
软件无线屯的设计思想之一是将A／D转换器尽可能靠近天线，即把A／D从基带移到中频甚至射频，把接收到的模拟信号尽早数字化。
Multi-switch selectable through eight analog channels, allowing time-8 analog inputs, common A/D converter to convert.
多路开关可选通8个模拟通道，允许8 路模拟量分时输入，共用A/D转换器进行转换。
In the signal into the A / D converter analog to digital conversion, the final processing of data into the microcontroller, then the output is displayed, and determine whether there is a gas leak.
在把信号送入A/D转换器进行模数转换后，将最后的数据送入单片机进行处理，随后输出显示，并且判断是否有煤气泄漏。
Two approaches are developed:one based on a D flip-flop loop and the other based on a time-division multiplexing digital-to-analog converter (DAC).
为此提出了基于D触发器环路的相控阵信号发生技术和基于时分复用数模转换器（DAC）的相控阵信号发生技术。
Two approaches are developed:one based on a D flip-flop loop and the other based on a time-division multiplexing digital-to-analog converter (DAC).
为此提出了基于D触发器环路的相控阵信号发生技术和基于时分复用数模转换器（DAC）的相控阵信号发生技术。
应用推荐