The Fourier amplitude spectrum used in a seismological model can be expressed as a product of source spectrum, propagation path factor and site effect in frequency domain.
在频域内，场地的地震动傅立叶幅值谱，可以表示为震源谱、传播路径影响因子和场地效应的乘积。
The spectrum division technique was used for establishing signal model of delay time measurement, and amplitude frequency characteristics of the signal after spectrum division was investigated.
利用频谱相除技术构建了延迟时间测量的信号模型，研究了频谱相除后信号的幅频特性。
The spectrum of amplitude modulated signal are two half magnitude spectrums of base band signal positive and negative shifted by a carrier or R. F. frequency.
调幅讯号之频谱为一半强度基频讯号之频谱分别正负位移一射频或载波之频率。
First of all, starting with the estimate of signal parameter (e. g. amplitude, frequency and phasic), it makes a research in algorithms of direct, subdivide the spectrum, high-precision FFT and so on.
首先，本文从信号参数(幅度、频率、相位)估计入手，研究了直接法、细化频谱法和高精度FFT法等算法。
Spectrum of the amplitude-modulated wave is observed by a radio frequency spectrum analyzer and amplitude values of every spectrum are recorded at the upper sideband or lower sideband.
用射频频谱分析仪观测一个已调波的频谱成分，记录上边带或下边带中各条谱线的幅度值，从而可以根据有关算式计算出调制信号（音频信号）的失真度。
With the outer scale of turbulence increasing, the amplitude of low-frequency spectrum increases and the high-frequency is invariable.
随着等效湍流外尺度的增加，低频谱的幅值逐渐增大，高频谱保持不变。
Noise value, noise power, noise voltage, vibration power and amplitude vibration were measured under different cutting parameters of technology and frequency spectrum analysis was also made.
在不同的锯切工艺参数和锯片结构下，测量了噪声值、噪声功率、噪声电压、振动功率和振动幅值，并对其进行频谱分析。
The classification technique uses various features of the signal amplitude, frequency, and power spectrum applied to the fuzzy classifier.
本文研究了一种基于模糊分类的调制信号识别方法，即提取信号时域、频域、功率谱等统计特性，利用模糊分类器进行分类识别。
Cyclic period chat spectrum estimation is used on parameters estimation such as carrier frequency, chip width and amplitude.
参数估计主要对直扩信号的载频、码片时宽和幅度进行了估计。
Three features parameters derived from the instantaneous amplitude, instantaneous phase, instantaneous frequency and power spectrum of analogue modulated signals are presented in this article.
首先介绍从信号幅度、相位、频率及功率谱等特性中提取的三种特征参数，应用这三种参数采用人工神经网络对模拟调制信号进行了识别。
Studied two conditions of acoustic signals when it was single-phase gas and two-phase flow in the pipeline from sound spectrum, acoustic energy, peak frequency and amplitude.
分别从声波频谱，声波能量，峰值频率，以及幅值等方面对管道内为单相气体和两相流体两种状态下的声波信号进行了研究。
Based on vector-spectrum method, the concept of vector amplitude-frequency figure and vector waterfall figure is established.
基于全矢谱理论，定义全矢幅频特性图和三维全矢瀑布图的概念。
The sound signal received and processed by the original sonar system is converted by comprehensive frequency spectrum and forms a digitized dynamic frequency-amplitude distribution curve.
原有声纳系统接收处理后的声音信号经过综合频谱转换后，形成数字化的动态频率-幅度分布曲线。
The signal's amplitude spectrum reveals that there are two main frequency, the higher is the probe signal's dominant frequency and the lower is the testing plane's free vibration frequency.
频谱分析表明测试信号中含有两个主频，分别对应发射探头的发射主频与测试面自振频率（采用ANSYS有限元程序作半空间体模态分析加以验证）；
The signal's amplitude spectrum reveals that there are two main frequency, the higher is the probe signal's dominant frequency and the lower is the testing plane's free vibration frequency.
频谱分析表明测试信号中含有两个主频，分别对应发射探头的发射主频与测试面自振频率（采用ANSYS有限元程序作半空间体模态分析加以验证）；
应用推荐