Two power amplifier output stage using PMOS and NMOS transistors by the special design.
两个功率放大器的输出级均采用PMOS和NMOS晶体管特殊设计而成。
Second, a push-pull class A amplifier output stage will have inherent rejection of power supply ripple and noise.
第二，推挽A级放大器输出阶段将拥有固有拒绝电源纹波和噪声。
In the design of column readout stage, master and slaver structure has been adapted, where master amplifier converts charge to voltage, and slave amplifier works with standby mode to drive output bus.
列读出级采用新型主从两级放大列读出结构，其中主放大器完成电荷到电压的转换，从放大器驱动输出总线来满足一定的读出速度。
A current-driven common source amplifier which is biased on class AB constitute the output stage.
由偏置在AB类的电流驱动的共源放大器构成输出级；
As improved, input buffer circuitry comprises a pull up stage to pull up the voltage of the differential amplifier output slightly higher during an output low condition.
作为改进，输入缓冲电路组成的阶段拉一拉期间的输出低的条件差分放大器的输出电压略高。
When designing output stage, in order to enhance the efficiency, it uses the push-pull common source stage amplifier as the output stage, the output voltage swing basically reached rail-to-rail.
在输出级设计时，为了提高效率，采用了推挽共源级放大器作为输出级，输出电压摆幅基本上达到了轨至轨；
The principle figures of input stage middle gain stage and output stage for a usual two stage low-voltage CMOS operational amplifier and their principal performance are presented in the paper.
给出了一种常用两级低电压CMOS运算放大器的输入级、中间增益级及输出级的原理电路图，并阐述其主要工作特性。
We also experimentally demonstrate a novel three-stage erbium-doped fiber amplifier with high gain, low noise figure, and high output power.
研究了新型的三段级联泵浦优配的掺铒光纤放大器的优化光路结构，得到高增益，低噪声，大输出功率的掺铒光纤放大器；
Amplifier class has absolutely nothing to do with output stage topology.
放大器级绝对没有任何关系与输出级拓扑。
The technology of temperature compensation and cascade current mirror was used, and the output of two stage amplifier was used for the bias of itself.
电路运用带隙温度补偿技术，采用共源共栅电流镜，两级运放输出用于自身偏置电路。
To make sure the stability and lower the transient overshoot of the LDO, a buffer stage is used to isolate the pass element and the output of the error amplifier.
为了保证系统的稳定性以及减小系统的输出瞬时过冲，本文设计了输出缓冲级来隔离误差放大器的高阻抗输出节点与通路器件的栅极。
A single stage amplifier was used outside the loop cavity to increase the output power, and the influence of amplification on laser quality was analyzed.
环形腔输出后加入单级光放大提高输出激光的光功率，分析了放大对激光性能的影响。
Based on traditional two-stage amplifier, cross-coupled class AB output stage and cascode compensation were adopted to improve output voltage swing and bandwidth.
在传统两级运放的基础上，采用交叉耦合的AB类输出级和共源共栅补偿，提高了输出摆幅和带宽，并通过数学工具对功耗进行了优化。
On the basis of analysis of the output stage function and stability, an operational amplifier (OP) with high gain and low distortion is designed.
在对输出级的功能和稳定性作了分析计算后，设计了一种高增益、低失真的运放（OP）电路。
On the basis of analysis of the output stage function and stability, an operational amplifier (OP) with high gain and low distortion is designed.
在对输出级的功能和稳定性作了分析计算后，设计了一种高增益、低失真的运放（OP）电路。
应用推荐