竖向抗压单桩承载力包括桩侧阻和桩端阻。
The bearing capacity of vertical compressive piles consists of skin friction and tip resistance.
电子负载可以设置为恒流﹐恒阻和恒压模式。
Electronic load can be set for constant current, constant resistance and constant voltage operation.
最优生产方法存在低阻和高数量都是一样的。
Optimal manufacturing methods exist both for low and high quantities alike.
大位移井钻井的摩阻和扭矩严重影响钻井时效。
Torque and drag in extended-reach well greatly impact on the efficiency of drilling.
利用该理论解，能方便地进行有井阻和涂抹的砂井地基设计。
By this theory, design of sand drain foundation taking account of the effect...
通过改变操作参数，确定了滤饼比阻和滤饼含湿率的影响因素。
The factors influencing the cake resistance and water content were discussed and quantized by altering operational parameters.
本发明使混凝土复合管道具有高抗腐蚀性、低流阻和低制造成本。
The concrete complex pipeline of the invention has the advantages of high erosion resistance, low flow resistance and low manufacture cost.
了解类风湿性关节炎住院患者寒湿闭阻和湿热闭阻型实验室检查概况。
To know in-hospital rheumatoid arthritis(RA) patients lab tests on cold-damp block and damp-heat block types.
本文给出了高超声速飞行器表面摩阻和传热系数(斯坦顿数)的计算结果。
In this paper the results of calculations of the coefficients of skin friction and heat transfer (Stanton number) on the surface of hypersonic flight vehicle are presented.
本文用小信号理论计算了其负阻和噪声性能，并进行了大信号性能的近似分析。
The negative resistance and the noise performances are calculated by means of small signal theory. The large-signal performances are also approximately described.
介绍了小容量无刷直流电动机（BLDCM）热阻和热导参数的含义和测量方法。
The paper introduced the concepts and their corresponding measuring methods of thermo-resistance and thermo-conductivity of small BLDCM.
通过实验方法测试了以原生长江水为冷却水的换热器污垢热阻和摩阻系数的变化。
The variation of fouling resistance and frictional resistance coefficient of heat exchanger using connate Yangtze River water as cooling water is tested experimentally.
引入随位移变化的接触热阻和接触电阻有助于描述接触部位的非连续温度场变化；
The variational contact resistance with the displacement field can help describe the discontinuous temperature distributions of the contact regions better.
等温边界条件下热量能够及时散发，内部热阻和热源分布对模块温升起主导作用。
We also find that under isothermal boundary condition, due to heat can be distributed in time, the internal thermal resistance and heat distribution leading role on the module temperature rises.
通过试验，获取了不同工艺条件下的过滤曲线，并求得了滤饼比阻和工作介质阻力。
Trough the test, some filtration curves under the different technological conditions are obtained; and the resistance of filter cakes and filter medium are calculated.
采用相关分析和通径分析法探讨了烟支重量、吸阻和抽吸口数等指标对TPM的影响。
The effects of cigarette weight, draw resistance and puff number on TPM were studied with correlation and path analyses.
通过对飞轮的自由刹车曲线进行回归分析，得出由风阻和轴承磨损等引起的系统损耗模型。
The model of system loss model caused by wind resistance and bearing friction is established based on the regression analysis of flywheel's free brake curve.
结果表明，ITO薄膜应用于OSR表面防静电放电时，需合理设计表面方阻和接地方式。
The results showed that surface square resistance and earthing way should be designed in reason when ITO film used for antistatic discharge on OSR surface.
结果表明，桩周附近的侧阻与端阻有了较大幅度的提高，而且注浆桩将具有强劲的后继端阻和侧阻。
The results indicate that the side and end resistance around the pile increase greatly, and the poured pile has the powerful continuous end-friction and bottom-friction.
DSOI器件的衬底热阻和体硅器件非常接近，并且在进入到深亚微米领域以后能够继续保持这一优势。
The thermal resistance of DSOI devices is very close to that of bulk devices and DSOI devices can keep this advantage into deep sub-micron realm.
建立受热阻和回热损失影响的埃里克森循环模型，以输出功率为目标函数，导出循环的基本优化关系式。
An Ericsson cycle model under the influence of thermal resistance and regeneration loss is established and a basic optimization relation of the cycle deduced, using output power as a target function.
激光功率密度和后续热处理温度对PT C热敏电阻方阻和电阻温度系数影响较大，并都存在一个最佳值。
The laser power density and the temperature of post heat processing have great effect on the sheet resistivity and TCR of PTC thermistor, and there exist optimum values for these parameters.
第一章综述了目前国内外机车负载试验的状况，分析了水阻和干阻负载试验的优缺点，提出改造的目标和内容。
In chapter 1, it summarizes the present state of load test at home and abroad and analyses the disadvantages of traditional water-resistance load test and put forward the goal and content of rebuild.
提出了特殊结构及冷却方式下的实验数据和处理方法；提供了行之有效的计算散热器热阻和极限散热器功率的方法。
The managing method of the experimental parameters for special structure and cooling mode is proposed, and effective algorithmic formulas for thermoresistance and limited dissipation power are g…
由于开关损坏的主要原因是过热损坏，对PIN二极管进行热阻和功耗测试以准确估计器件的内部温升是非常必要的。
Over hot is the main reason of PIN switches 'failure, therefore thermo-resistance and device dissipation power measurement to estimate the inner temperature accurately is necessary dramatically.
由于开关损坏的主要原因是过热损坏，对PIN二极管进行热阻和功耗测试以准确估计器件的内部温升是非常必要的。
Over hot is the main reason of PIN switches 'failure, therefore thermo-resistance and device dissipation power measurement to estimate the inner temperature accurately is necessary dramatically.
应用推荐