介绍了一种设计体积速度传感器的新方法。
This paper presents a new method to design volume velocity sensor.
针对航空修理过程中对飞行高度与速度的设定及测试的需要，设计了以振筒传感器为核心的飞行测定系统。
According to the needs of setting and testing flight altitude and airspeed in aviation repairing, the flight testing system based on vibrator-type sensor has been designed.
该系统通过红外雨量传感器检测雨量大小，使用模糊控制算法和脉宽调制技术调节雨刷器的速度；给出了系统的总体结构和具体设计方法。
This system senses the amount of rainfall by the infrared rain sensor, and adjusts the speed of wiper based on the fuzzy control algorithm and pulse width modulation technology.
提出了一种基于直接转矩控制理论的无速度传感器交流调速系统的设计方法。
A new design method of speed sensor less direct self control AC induction motor drive system is presented.
针对没有速度传感器的成像导引头位标器，从工程实际的角度出发，提出了一种位标器预定回路速度内环的设计方法。
From the point of actual engineering, a method about velocity-loop design of seeker coordinator predefined circuit was presented for imaging seeker coordinator without speed sensor.
为提高异步电机转速环的动态性能，提出一种新型的有速度传感器的转速控制器设计方案。
A new speed controller with sensor feedback was developed to improve the speed control of induction motors.
除了主要介绍微加速度计阵列的设计、制造和测试外，还着重介绍了低量程传感器在高过载环境下的结构防护问题。
The design, fabrication and the preliminary testing of this sensor is introduced, besides the structural protection for these low-range sensors in the situation of over-loading is mainly described.
针对视觉系统处理速度慢的问题，利用光电信息技术设计出基于光学小波变换的机器人视觉传感器。
A robot vision system based on optical wavelet transform is designed by means of photoelectric information techniques in accordance with slow processing speed of vision system.
通过动力学分析和有限元模拟，设计出了具有高过载保护功能的加速度传感器结构。
Utilizing the dynamics analysis and finite element simulation, the acceleration sensor's mechanical structure with high overload protection capability was designed.
本文将磁流体用于加速度传感器的设计还是一项比较先进的课题。
In this thesis, magnetic fluid was used in designing an acceleration sensor. And this is an advanced subject.
介绍一种无位置、速度传感器的交流伺服系统的设计方法，它采用自适应滑模观测器来估算转子的位置及速度。
This paper introduce a method to design the no-place, velocity sensor ac servo system, use self-adapt slid mode observer to estimate the place and velocity of rotor.
本文主要介绍了一种应用加速度传感器adxl50设计的新型便携式、低功耗的振动加速度-频率检测装置。
A kind of vibration acceleration - frequency detecting device is described, which is a new style low power consumption handy device based on ADXL50 acceleration sensor.
介绍了ADXL202的测试原理和主要参数设计原则，然后利用其集成了一种无线加速度传感器并进行了测试。
Firstly, the testing principles and important parameters designing rules were introduced. Then, a kind of wireless acceleration sensor based on ADXL202 was developed and acceleration was tested.
提出了光纤光栅加速度传感器的设计和优化方法。
Design and optimization method have been provided in this paper.
本文介绍了加速度传感器芯片adxl250在设计导航系统中的加速度计方面的一个应用。
This paper introduces the design of MEMS accelerometer based on the acceleration sensor chip ADXL250 and the related calibrating circuit.
本文研究设计了适于MEMS电容加速度传感器读出电路的低通滤波器。
This paper is to research and design the low-pass filter of the MEMS capacitive accelerometer sensor readout circuit.
利用加速度传感器和倾角传感器可设计一种基于空间运动测量的人体上肢动作输入设备。
An upper limbs action input device based on spatial movement measuring can be designed with the help of the acceleration sensors and the tilt sensors.
基于E型膜片设计了一种新型多维加速度传感器弹性体结构，并介绍了这种低成本传感器的工作原理。
Based on the E-type membrane, a new elastic body of multi-axis accelerometer is designed. The working principle of this low-cost accelerometer is introduced also.
无速度传感器转速观测能有效提高系统的冗余，使系统硬件设计得以简化，是目前电机控制研究热点。
Sensorless speed observation can increase system redundancy effectively and can reduce the hardware design complexity, which becomes a focus of current research works.
基于非接触式齿轮速度传感器检测原理，设计了一种径向多齿轮流量变送器测量系统。
Based on the method of non-contact pick-off detection of gear tooth, the detection system of a radial multi - gear flow was designed.
采用耐高温的锁定型霍尔元件和钐钴永磁转子分别构成位置与速度传感器，并设计相应的速度信号倍频电路与位置信号译码电路。
Fireresistant Hall device and SmCo rotor is used to design position and speed sensor, and the corresponding doubling circuit and decoding circuit is designed.
本文提出了一种实用的基于PL C分级递阶分布式控制的多电机无速度传感器矢量控制调速系统设计的新方法。
A practical method of designing speed-adjustable system of sensorless vector control which base on PLC hierarchical intelligent control is proposed in this paper.
提出了一种用于土木工程结构监测的无线加速度传感器的模块化设计方法，并研制开发了一种无线加速度传感器。
This paper presents a kind of modularization designing method about wireless acceleration sensor applied to civil engineering structure monitoring, and the wireless acceleration sensor is developed.
介绍了一种基于MEMS加速度传感器的自动校准平台的设计方案。
This paper describes a design solution of automatic calibration platform based on MEMS accelerometer.
分析和讨论了一种新型角加速度传感器的工作原理与设计方法。
The working principle and the design method of a new type of Angle acceleration sensor based on streaming potential is analysed and discussed.
提出了一种基于DSP（TMS320LF2407A）无速度传感器直接转矩控制系统，给出了硬件设计和软件设计方案。
This paper gives a design of sensor-less direct torque control system based on DSP (TMS320LF2407A). The hardware and software schemes are introduced.
对角速度敏感型系统的设计及角度传感器的选型具有很好的借鉴作用。
It is a good reference for the design of the velocity-sensitive system and the selection of the Angle sensor.
第三章详细论述了铰链式结构加速度传感器芯片的版图设计和制作工艺流程。
In chapter 3, layout design of the sensors' chip and the process was elaborated.
第三章详细论述了铰链式结构加速度传感器芯片的版图设计和制作工艺流程。
In chapter 3, layout design of the sensors' chip and the process was elaborated.
应用推荐