寻呼机用电池要求小电流连续放电加上间歇中电流脉冲。
A small current output and intermittent middle current pulse were demanded in the battery for bp.
由于复合材料导热性能较差，导致电机整体的散热性能不佳，因而连续放电运行时电机的热性能预估显得十分重要。
Due to the poor thermal conductivity of composite materials, heat dissipation of the machine is severe, and heat performance estimate becomes vital during continuous discharges.
德国阳光蓄电池抗深放电能力强，100%放电后仍可连续接在负载上，在一月支配充电可恢回复复兴容量95%。
Germany sunshine battery deep discharge resistance is strong, 100% still can pick up on the load continuously after discharge, dominant charging can restore the revival capacity of 95% in January.
研究了利用该方法从连续周期性干扰和白噪声干扰中提取放电脉冲的可行性。
The possibility of picking up the discharge pulses from continuous periodical interference and white noise interference by this method is simulated respectively.
讨论在多孔MCP输入面形成连续电子透射膜与气体辉光放电的关系，工艺失败对MCP的危害性。
The relation between continuous film forming at the input of porous MCP and glow discharge of the gases is discussed, and the harm of failure processing to MCP is analyzed.
若连续起动时间过长，将造成蓄电池大量放电和起动机线圈过热冒烟，极易损坏机件。
Consecutive start-up time is too long, would result in battery discharge and substantial smoke starter coil overheating, mechanical damage easily.
采用了子波函数对含强载波干扰的局部放电信号进行连续子波变换。
This paper introduces a continuous wavelet transformation for detecting the disturbed partial discharge pulses in HV transformer.
它可工作于脉冲和连续两种放电模式。
每个第一放电单元部分地围绕放电室，并且连续的第一放电单元通过第二放电单元耦合在一起。
Each first discharge unit partially surrounds a discharge cell, and successive first discharge units are coupled together by second discharge units.
脉冲调制器的放电回路采用先进的固态开关技术，以实现频率和脉宽的连续可调。
This kind modulator is characterized by repetitive frequency and easily-adjustable width of the output pulse for utilization in solid state switch.
脉冲调制器的放电回路采用先进的固态开关技术，以实现频率和脉宽的连续可调。
This kind modulator is characterized by repetitive frequency and easily-adjustable width of the output pulse for utilization in solid state switch.
应用推荐