截面平均总压和周向低压区内平均总压与进气流量成线性关系。
The section average total pressure and the average total pressure in the circumferential low-pressure areas are in linear relationship with the air inlet flow.
结果表明，在一定范围内增加机柜进气流量和减小通风孔尺寸可改善机柜通风换热性能。
The test results show that, increasing inlet flux and decreasing width of ventilation hole within a scale are main ways to improve the heat exchange performance of standard chassis.
随着旋转雷诺数和进气流量系数增加，转盘无量纲过余表面平均温度和无量纲径向表面温差全都下降。
The dimensionless average temperature and dimensionless temperature difference of rotor surface decrease with both of the dimensionless mass flow rate and rotational Reynolds number are increased.
通过一系列试验，分析了填充床厚度、槽电压、进气流量、通电时间对脱硫率的影响，并且探讨了该反应的反应原理。
Through a series of tests, studied the influences of the thickness of packed bed, voltage, in-flow, electrolytic time to the desulfurization rate, then analyzed the response principle of the react.
为了建立基于进气流量、DPF床温、碳烟以及喷油量的DPF压降模型，论文进行了一系列的试验，采集了大量数据。
In order to build the DPF pressure drop model based on air intake flow, DPF bed temperature, soot and fuel charge, the paper has carried out a series of tests, collected a mass of data.
研究结果表明通过适当提高进气流量、提高混合气体中的氮气或氢气含量和减少喷枪通道长度，均能提高等离子喷枪热效率。
The results show that the thermal efficiency of the torch increases with the increase of the gas flow rate, the nitrogen or hydrogen content and decrease of the length of torch.
在一定的进气状态下，为达到要求的出气干度，对给定的空气流量进行了设计计算，以得到合适的传热面积与制冷系统的匹配。
At a given air inlet condition and airflow rate, meanwhile, dryness of air outlet was required, proper heat-transfer area and matching refrigeration system are obtained through calculating.
检查载气流量，将进样模式改为手动。
To check the carrier flow, put the injection mode in manual.
该方法采用压缩空气为干燥介质，通过控制干燥段空气流量、进风温度使物料在闪蒸主机内进行 干燥。
The method adopts compressed air as the drying medium, and dries the particles in a flash evaporator by controlling the air flux of drying region and the temperature of feeding air.
对气相色谱和原子荧光的在线联用进行了设计，优化了进样口温度、载气流速、尾吹气流量及氩气流量等实验条件。
The hyphenation system was carefully designed and the operation (conditions) such as injector temperature, carrier gas flow rate, make-up gas flow rate and argon flow rate were optimized in detail.
对气相色谱和原子荧光的在线联用进行了设计，优化了进样口温度、载气流速、尾吹气流量及氩气流量等实验条件。
The hyphenation system was carefully designed and the operation (conditions) such as injector temperature, carrier gas flow rate, make-up gas flow rate and argon flow rate were optimized in detail.
应用推荐