研究了通过曼尼西反应合成的单宁大孔吸附树脂对黄芩苷的静态吸附、脱附、动态吸附、 吸附动力学过程。
The process of static adsorption, desorption, dynamic adsorption and adsorption kinetics of baicalin on macroporous adsorption resin immobilized tannins by Mannich reaction were investigated.
而计算多体系统动力学和虚拟样机技术的出现，使得对于飞机着陆过程起落架和机身动态响应的模拟更逼近于现实。
Computational multibody dynamics and virtual prototyping technology are brand new modeling and analysis methods for simulating the landing process of an aircraft.
利用动力学原理，分析和研究了电磁净化乳化液的动态过程；
The dynamic processes of purifying emulsion with electromagnetic technique are analyzed and studied by dynamics principle in this paper.
然而回转过程的动态反应是工程实际的客观存在，因回转起制动引起的动力学问题应引起足够关注。
However, dynamic response of slewing process is the objective existence in actual engineering and the dynamic problems caused by slewing start and brake should arise enough concern.
建立了螺旋锥齿轮研齿过程的动力学模型，求出了动态研磨力的大小。
The dynamic model of the lapping was setup, and the dynamic lapping force was calculated.
分析人体双足步行的动态稳定性以及跳跃运动的动力学过程。
The dynamical stability of biped locomotion and the dynamical process of jumping motion of human body are analyzed in this paper.
目的探讨在不同认知作业状态下脑电非线性动力学特性的变化规律，以及脑电非线性动态分析在认知过程研究中的作用。
Objective To investigate the changes of non-linear dynamics properties of EEG under different mental tasks, and the application of non-linear dynamic analysis for cognitive function research.
在气源条件研究中，以化学动力学理论为主线对天然气的生成过程和生成量进行了动态、定量评价。
In study of gas source condition, the quantitative dynamic evaluation of generation of natural gas and gas-generating amount are made on the basis of chemical dynamics.
对动态磁致伸缩过程进行分析，并建立了超磁致伸缩换能器的等效动力学模型。
Equivalent dynamic model of giant magnetostriction transducer is set by means of analyzing dynamic magnetostriction.
利用动力学原理分析了电磁方法净化乳化液的动态过程。
According to dynamic principle, this paper describes the dynamic process of purifying emulsion using electromagnetic technique.
利用动态热重法研究了两种含氟聚酰胺酸薄膜在连续升温过程中的亚胺化反应动力学。
The imidization kinetics of two kinds of fluorinated poly(amic-acid) films during the continuous increase of the temperature were investigated using dynamic TG method.
然后以铣削为对象，建立了两自由度的铣削加工颤振动力学模型，并运用数字仿真技术，对动态端铣过程进行了时域仿真研究。
Based on the establishment of the dynamics model of milling processes with two degrees of freedom, the end-milling processes are simulated in time domain by using numeric simulation technology.
本文以红茶为研究对象，采用酶技术和超微粉碎技术对红茶的静态萃取、动态萃取和萃取动力学过程进行了系统研究，结论如下。
The static and dynamic extracts and extract kinetics of black tea are systematically studied by technology of enzyme and super-micro-comminution.
基于物料衡算、热量衡算和反应动力学建立的催化裂化过程动态模型是具有非线性、分布参数的模型形式。
Based on the material balance, energy balance and reaction kinetics, a dynamic model, having the form of a nonlinear distributed parameter has been presented for catalytic cracking process.
该文基于患者行走过程的运动学和动力学特性，建立三维非线性有限元模型，研究动态载荷对界面压力的影响。
Based on the analysis of kinematic and dynamic properties during walking, a 3-d nonlinear finite element model was developed to analyze the effect of dynamic loads on the interface stress.
电导率法是适用于含水矿物脱水过程动态监测及脱水过程中水的分布、迁移等动力学过程就位研究的有效方法。
Electrical conductivity method can be used to monitor dynamically the dehydration process of hydrous minerals, and to study the distribution and migration kinetics of free water.
通过对关节式移动机器人越障过程运动学和动力学分析，得出控制移动机器人越障时保证动态稳定性的约束条件。
Analyzed kinematics and dynamics of the obstacle negotiations for an articulated mobile robot a restriction condition to guarantee dynamic stability when it gets over the obstacles.
本文基于履带车辆转向动力学和发动机动态工作过程，建立了履带车辆动态转向过程的仿真模型。
A simulation model for the dynamic steering processes of tracked vehicles was established, based on steering dynamics and engine transient working processes.
瞬态动力学分析通过考察联轴器传递转矩过程中的最大应力、最大位移及其发生部位来分析联轴器的动态刚度和强度状况。
The transient dynamic analysis researched the dynamic stiffness and strength of the joint by investigating the maximum stress and strain when it transmits torque.
用自适应过程减小参数不确定性的影响，并通过动态滑模控制器的高鲁棒性抑制机器人模型中的未知非线性动力学及测量噪声等的影响。
The adaptive process extenuates the influence of parameter uncertainty, and the robustness of the dynamic sliding mode control inhibits the influence of unknown dynamics and measurement noise.
分析人体双足步行的动态稳定性以及跳跃运动的动力学过程。讨论与竞走和跑步运动有关的 力学问题。
The dynamical stability of biped locomotion and the dynamical process of jumping motion of human body are analyzed in this paper. Some problems related to the race-walking and running are discussed.
利用多体动力学仿真分析软件ADAMS，对断路器机构系统进行动态仿真建模与分析，获得其分闸过程的动态特性。
The model of ACB mechanisms for dynamic simulation was built with multi-body dynamics simulation program ADAMS, and the dynamic characteristics were obtained by simulation analysis.
在进行挖沟器的系统动力学分析过程中，利用了虚拟样机技术adams软件对挖沟器链传动过程中的受力情况进行了动态仿真。
During the dynamic analysis of mechanical system, the force that act on the chain of trenching implement is simulated by virtual prototype soft ADAMS.
基于神经网络方法建立了公路隧道纵向通风在线控制模型，结合交通模型、空气动力学模型及污染模型，对隧道内污染物进行了通风控制过程的动态模拟。
An on-line control model for road tunnel with longitudinal ventilation was proposed based on neural networks and by combining traffic model, aerodynamics model and pollution model.
本文从动力学角度分析了车削过程中刀具后刀面磨损量对切削力的影响，得出切削力动态成分与刀具后刀面磨损量之间的关系。
According to dynamics, this paper analyses effect of the tool flank wear on cutting force. It gives relationship between the tool flank wear and dynamic cutting force.
通过试验研究指出，磨碎过程是一个动态过程，故动力学方程序的参数也将是变化的。
In this paper, it is stated that grinding process is a dynamic one. Then the parameters of grinding dynamics equation will change.
根据废水处理理论并分析比较活性污泥法有关模式的假设和推导过程，作者导出了稳态条件下厌氧流化床的动力学模式。文中还提出稳态和动态的流化模式。
Based on the theory of wastewater treatment and relevant models of activated sludge processes, a kinetic model of the anaerobic fluidized bed reactor under steady state conditions is developed.
根据废水处理理论并分析比较活性污泥法有关模式的假设和推导过程，作者导出了稳态条件下厌氧流化床的动力学模式。文中还提出稳态和动态的流化模式。
Based on the theory of wastewater treatment and relevant models of activated sludge processes, a kinetic model of the anaerobic fluidized bed reactor under steady state conditions is developed.
应用推荐