计算中的底部剪切应力由波流边界层模型给出波—流共同作用下的形式。
In calculation, the bottom shear stress under the effect of waves and currents is supplied by the wave-current bottom boundary layer model.
为查明不凝气体对水平管外膜状凝结换热特性的影响规律，建立了水平单管的气、液双边界层模型。
Film condensation heat transfer characteristics are studied by numerical simulation for a single horizontal tube in the presence of a non condensable gas.
本文采用边界层模型分析了单桩在强烈水平激振作用下的动力反应，并且与大尺寸的模型桩的动力试验结果进行了对比。
Dynamic response of a single pile under strong horizontal excitation is analyzed using boundary zone model in this paper, and compared with the experimental results for large-scale model pile.
建立了含有微气泡的平板边界层方程，并采用一种简单的混合长度模型和有限差分方法对该方程进行了数值计算。
The equations of the boundary layer containing microbubbles on the plate are established, then calculated employing a simple mixing length model and a finite difference method.
本文通过对电流变液的边界层扩展研究，建立了一类新型单链拉伸模型。
In this paper, we have established a new tensile model of single row chains by investigating the development of boundary layers.
利用流动稳定性理论中的一般共振三波的概念，提出了湍流边界层近壁区域相干结构的理论模型。
The theoretical model of the coherent structure in the wall region of a turbulent boundary layer was proposed, using the idea of general resonant triad of the theory of hydrodynamic stability.
本文以BL模型为例，通过可压缩湍流边界层的三个典型算例，与直接数值模拟(DNS)的结果作对比。
In this article, bl model is used to study three typical cases of compressible turbulent boundary layer, for which, data from direct numerical simulation (DNS) are available for comparison.
该模型不仅考虑了非稳态下膜相扩散阻力，而且还考虑了外相边界层的扩散阻力及膜破裂。
This model takes into account both the diffusion resistance of the membrane phase in non-steady state and the diffusion resistance of the external phase boundary film and the membrane leakage.
为模拟大气边界层，实验段较长，实验模型放在实验段后部。为减小轴向静压梯度顶板高度分段可调。风速比航空凤洞低。
In order to simulate boundary layer in atmosphere, the length of first test section is longer than usual one, the models are put into the rear part.
以传热学边界层湍流对流换热理论为理论基础，利用实测数据建立城市不透水表面对流换热的数学模型。
Based on the boundary layer turbulence convective heat transfer theory in heat transfer, we establish the mathematical model of convective heat transfer on the urban waterproof surface.
流场大部分区域为四面体网格，在边界附近采用加密的五面体棱柱型网格，满足了SST模型对边界层网格的要求；
As the tetrahedral grids exist in the majority area, the pentahedral prism grids are adopted near the boundary, which meets the SST model's requirement of mesh in the boundary layer.
本文采用随机模型，讨论等离子体边界层密度涨落对低混杂波的散射。
Making use of the stochastic model, we have studied the low-hybrid wave scattering by the density fluctuations in the edge-regions of Tokamak plasmas.
在同济大学TJ-3边界层风洞中对汕头跳水游泳馆模型在模拟的大气边界层风场中进行了测压试验。
A test of wind pressure distribution on the Shantou Natatorium and Diving Room has been carried out in TJ-3 Boundary Layer Wind Tunnel in Tongji University.
因此，应用低雷诺数模型时，边界层内必须采用较密的网格。
Therefore, a finer grid scheme in the boundary layer must be used if low Reynolds' number model is employed.
本文应用零方程模型和二方程模型计算了椭球体有攻角绕流对称面上的三维湍流边界层。
Revised method is proposed for calculation of three dimensional turbulent boundary layers on the surface of symmetry plane of a flow around ellipsoid at incidence.
该模型考虑了气、液膜之间的质量连续及能量连续特征。 对于不同的壁面过冷度，用数值方法首次求解并分析了边界层内局部不凝气体质量分数、温度和速度的分布规律。
The vapor liquid two boundary layer model is applied to predict local mass concentration of the non condensable gas, temperature profiles and velocity profiles in the boundary layer.
通过理论分析提出一种考虑叶片端部间隙影响的叶片力亏损模型，并对三种轴流压气机叶栅的端壁边界层及叶片力亏损进行了数值计算。
A new model is presented for calculating the end-wall boundary layer and its blade force defect inside the axial compressor cascade, based on theoretical analysis.
通过建立气相法聚乙烯冷凝模式操作流化床乳化相中粒子外边界层的热质传递模型，研究了冷凝模式操作时聚合粒子的过热情况。
A heat and mass transfer model across the external boundary layer of polymer particles in emulsion phase with condensed mode operation was derived.
通过建立气相法聚乙烯冷凝模式操作流化床乳化相中粒子外边界层的热质传递模型，研究了冷凝模式操作时聚合粒子的过热情况。
A heat and mass transfer model across the external boundary layer of polymer particles in emulsion phase with condensed mode operation was derived.
应用推荐