壳聚糖辐照后并未发现有羰基形成。
铁矿石则表现为辐照后粗粒级产率明显降低。
For iron ore, the yield of coarse fraction was obviously reduced after irradiation.
对质子辐照后硅橡胶的力学性能进行了测试。
经过辐照后，微生物比如细菌、霉菌、大肠埃希菌不复存在。
After the irradiation solution, microbiology such as bacteria, mildew or Escherichia coliform will not exist anymore.
实验中还发现，辐照后温6的胚芽鞘呈现紫红色的变异现象。
Moreover, it was found that the coleoptile of Wen6 became purple with the ion beam implantation.
辐照后立即测定SOD活性、MDA含量，检测细胞存活率。
辐照后基极电流、结漏电流增大，集电极电流、击穿电压减小。
The base current and the junction leakage current increase, while the collector current and the breakdown voltage decrease for SiGe HBTs after radiation.
材料辐照后太阳吸收率发生明显变化，而辐射率几乎不发生变化。
The solar absorptance changed obviously, while the emittance has little change after irradiation.
结果：HPPM辐照后，出现以酶活性显著降低为主的心肌酶谱紊乱。
RESULTS: Myocardial enzyme spectrum disturbance occurred after HPPM irradiation, mostly was the decrease in enzymic activity.
此光纤经紫外辐照后吸收峰处损耗明显增加，而低损耗区损耗几乎不变。
After ultraviolet irradiation, the fiber attenuation increases obviously at several absorption peaks, whereas the value in low absorption region remains almost no change.
本文对高剂量辐照后银杏的营养成分、微量元素以及感官指标进行了研究。
The results showed that there were no difference in the content of crud fat and microelement between treatment with high dosage irradiation and contrast.
HIPIB辐照后的横截面金相组织照片分析，证实了能量沉积模拟结果。
The analysis of cross section Metallograph before and after HIPIB irradiation confirms the simulation results of energy deposition.
质子辐照后，硅橡胶的质量有所损失，其质损率随辐照能量和剂量的增加而增加；
There was mass loss of silicon rubber after proton radiation and the mass loss percent increased with the increase of irradiation fluence.
结果HIFU辐照后肿瘤细胞立即发生凝固性坏死，电镜下亦见到不可逆的破坏。
Results Tumor cells underwent coagulation necrosis immediately after irradiation with HIFU. Irreversible destruction was observed under electron microscope.
紫外辐照后，LLDPE的晶型和晶面间距未发生变化，但是其熔融温度和结晶度下降。
After the ultraviolet irradiation, the crystal shape and distance of the crystal plane of LLDPE remain unchanged. However, the melting temperature and crystallinity decrease.
论述了辐照后包壳管在热室中的拉伸、爆破、蠕变等试验方法，比较辐照前后包壳力学性能的变化。
Tensile test, tube burst test and creep test of irradiated cladding in hot cell were discussed. The changes of mechanical properties of cladding before and after irradiation were compared.
通过对X射线辐照后材料运动过程的数值模拟和分析，提出了一种计算汽化反冲冲量的数值计算公式。
By calculating and analysing the process of material radiated by pulsed X ray a numerical model that calculates the blowoff impulse generated in solid material by pulsed X ray radiation is given.
结果表明，发光强度的增加并非由ATP所造成引起的，而是由农产品中含有的细菌经辐照后引起的；
The results show that the increase of luminescence in irradiated food was not caused by ATP, is caused by the influence of the irradiated bacteria in sample;
实验结果发现：电子辐照后器件响应光谱在短波处有变窄的趋势，但响应峰值波长和截止波长基本无变化；
It's been observed that after irradiation, the response spectra of detectors become narrower at shot wavelength while the peak and cut-off wavelength have no noticeable change.
介绍了现在通行的燃料棒辐照后破坏性检验的一般方法，包括燃料辐照后的微观结构观察和力学性能试验；
Several methods of destructive post-irradiation examination(PIE) including microstructure observing and measurement of mechanical properties of irradiated fuel rod were introduced.
拉曼光谱和X射线衍射（XRD）的检测结果表明，激光辐照后材料的晶格产生畸变，晶格质量明显下降。
Results of Raman spectrum and XRD indicate that lattice distorted and quality of lattice declined after irradiation.
还测定了36种药物的LD _(50)及观察40种药物之主要药理作用，在辐照后3个月时重复检定一次。
LD50 of 36 kinds of drugs were measured and main pharmacological effect of 40 kinds of drugs were observed.
反应堆燃料元件的裂变气体释放率测量是辐照后检验的一项重要内容，它对于评价燃料元件的性能起着重要作用。
Fission gas release measurement of reactor fuel rods is one of the main issues of post-irradiation examination, which plays a key role to the evaluation of fuel performance.
初步研究了辐射剂量、剂量率对淀粉粘度的影响，测定了辐射降解淀粉中羧基的生成量，评价了淀粉辐照后的（?）
The effects of both irradiation dose and dose rate on starch's viscosity were studied, and the generated quantity of carboxyl in the irradiated starch was determined.
一些消费者团体抱怨食品加工后广泛的采用辐照只是在掩盖食品工业的卫生问题。
Some consumer groups complain that widespread irradiation of food after processing would simply cover up the food industry’s hygiene problems.
试验和研究了塑料着色用常用颜料偶氮类，酞菁类及无机颜料对PE着色后的辐照特性。
The color characteristics of colored PE in different radiation dosages, which is colored with azos, phthalocyanines, inorganic pigments respectively, has been studied in this paper.
停止辐照同一样品在自然培养液中培养24小时后，两处理组的心跳频率都大大增加。
The frequences of heart-beat of both treating groups were greatly increased after the irradiation had stopped and the same sample had been cultured in the natural culture fluid for 24 hours.
停止辐照同一样品在自然培养液中培养24小时后，两处理组的心跳频率都大大增加。
The frequences of heart-beat of both treating groups were greatly increased after the irradiation had stopped and the same sample had been cultured in the natural culture fluid for 24 hours.
应用推荐