信号(signal)是软件中断。
处理软件中断所用百分比。
The amount of time the CPU has been servicing software interrupts.
对比软件中断。
眼睛报警的软件中断优先级高于嘴巴报警的优先级。
换句话说，软件中断常常在指令运行周期的开始发生。
In other words, SOFTWARE interrupts always occur at the beginning of an instruction execution cycle.
软中断用于在内核线程上下文中处理时间要求严格的处理过程（软件中断）。
Softirqs were used for time-critical processing (software interrupts) in the kernel thread context.
信号就是软件中断，可以向正在执行的程序(进程)发送有关异步事件发生的信息。
Signals are software interrupts that send information about an occurrence of an asynchronous event to an executing program, or process.
一个操作系统典型地由一个函数调用集、软件中断和定期时钟周期组成。
An operating system typically consists of a set of function calls, or software interrupts, and a periodic clock tick.
软中断最初为具有32 个软中断条目的矢量， 用来支持一系列的软件中断特性。
Softirqs were originally designed as a vector of 32 softirq entries supporting a variety of software interrupt behaviors.
目的地(服务器)上的接口接收传入syn包，将其放在ipintrq队列中，并引发软件中断。
The interface on the destination (the server) receives the incoming SYN packet, places it on the ipintrq queue, and raises a software interrupt.
在第9章，你可以看到详细的讨论，关于NIC驱动可以选择性的设计成很好的软件中断模式。
In Chapter 9, you can find a detailed discussion of NIC driver design alternatives as well as software interrupts.
该控制系统采用软件中断控制系统结构及子程序结构简单，条件明确在经济型数控中应用较多。
The control system USES software interrupt control system structure and subroutine is simple, clear in the economic conditions in the application of NC more.
有一点值得指出的是，这些tasklet/bottomhalf会关闭这个中断上下文（软件中断）。
It is important to note that these tasklets/bottom halves will run close to the interrupt context (software interrupt).
通过软中断机制来调度微线程，当机器处于严重软件中断负荷之下时， 可通过ksoftirqd（一种每CPU内核线程）软中断来调度。
Tasklets are scheduled through the softirq mechanism, sometimes through ksoftirqd (a per-CPU kernel thread), when the machine is under heavy soft-interrupt load.
一段必须按次序执行的代码，并且不能被中断，否则不能保证软件正确地操作。
A block of code that must be executed in sequence and without interruption to guarantee correct operation of the software.
幸运的是，聪明的供应商在它的软件中设定了一种机制，对这批中断的地方附加了临时恢复点。
Luckily, the vendor wisely put a mechanism in its software to affix a temporary resumption point to the batch where the interruption occurred.
向外扩展就是在能添加更多服务器来执行同样的功能时，无需中断软件，即可增加应用程序所支持的用户数。
Scale out is when more servers that perform the same functions can be added, without disturbing the software, to increase the number of users supported by the application.
如果下载了部分软件分发作业的文件后，设备连接中断，那么当连接恢复时分发作业从断点处继续。
If the connection with a device is broken after some files of a software distribution job are already downloaded, the distribution continues where it left off when the connection resumes.
响应特定中断而运行的一小段软件。
A piece of software executed in response to a particular interrupt.
最后，FIT通过确保团队能够立即知道组件何时完成，以及何时错误地中断完成的工作，从而提高了软件的总体质量。
Finally, FIT increases overall software quality by ensuring that the team knows immediately when a component has been completed as well as when completed work has been mistakenly broken.
一段必须按次序执行的代码，并且不能被中断，否则不能保证软件正确地操作。参照：竞争状况。
A block of code that must be executed in sequence and without interruption to guarantee correct operation of the software. See also race condition.
软件设计分为：初始化、串行中断服务程序、串行口选择三个模块。
Software designed divide into three model: initialize, serial interruption service programming, serial port selected.
当中断服务程序退出，对处理器的控制权转到先前运行的那个软件上。
When the interrupt service routine exits, control of the processor is returned to whatever part of the software was previously running.
系统安全——系统安全是指网络系统的硬件、软件及其系统受到保护，系统连续可靠正常地运行，网络服务不中断。
System security is that the hardware, software and system of the network system are protected, and the system runs normally and reliably.
本文主要介绍32位单片机80960KB中断系统的软件结构及其运行机理。
This paper introduces interruption system software structure and operation of 32 Bit 80960KB Single-chip microcomputer.
它也有可能是病态的软件程序，以用于其他目的，定时器，计数器和中断率的变化。
It is also possible for an ill-behaved software program to use the timer-counter for another purpose and change the interrupt rate.
在软件设计中，通过灵活设置中断与DMA，不仅提高了图像数据的传输效率，而且充分发挥了DSP的高速性能。
Flexible setting of interrupt and DMA is adopted in the software design, which improves the efficiency of data transfer and performance of DSP.
X9241采用二线串行i2c总线与单片机传递数据。其软件由主程序、中断子程序组成。
Data between X9241 and SCM is transmitted with I2C Bus, and the software includes main program and interrupt subprogram.
X9241采用二线串行i2c总线与单片机传递数据。其软件由主程序、中断子程序组成。
Data between X9241 and SCM is transmitted with I2C Bus, and the software includes main program and interrupt subprogram.
应用推荐