本文对具有高承载能力的空气静压轴颈轴承进行了研究，给出了实验和计算结果。
This paper has investigated air hydrostatic bearings with high load carrying capacity and given experimental and calculating results.
在分析一类高速永磁轴承工作原理的基础上，根据磁库仑定律建立其轴颈轴承承载力模型。
Based on the analysis of the working principle a type of high-speed permanent magnetic bearing, bearing capacity model was founded on Coulomb's Law.
本文对具有高承载能力的空气静压轴颈轴承进行了研究，给出了实验和计算结果。在设计计算上，对传统的计算方法做了修正。
This paper has investigated air hydrostatic bearings with high load carrying capacity and given experimental and calculating results. Traditional method is modified in design and calculation.
这种轴颈向滚子轴承是一种特殊的回转轴承的设计。
The axial-radial roller bearing is a special slewing bearing design.
计算结果表明，轴颈倾斜时，轴承油膜压力分布、最大油膜压力、油膜厚度分布和最小油膜厚度等都有明显的变化。
The results show that there are obvious changes at film pressure distribution, maximum film pressure, film thickness distribution and minimum film thickness when there is misalignment.
万向节十字轴的四个轴颈叫做万向节十字头，分别装在两个万向节叉顶端的轴承中。
The four arms of the spider, known AS trunnions, are ASsembled into bearings in the ends of the two shaft yokes.
通过对发动机曲轴轴颈与轴承损坏原因的分析，重点阐述了发动机在使用与维修中预防损坏的措施和方法。
By analyzing reasons for break of engine crankshaft journal and bearing, this paper describes mainly some countermeasures they are break in use and maintenance.
计算结果表明，在非线性因素作用下，轴承中心的轴心轨迹不再具有对称性，而轴颈中心却表现为一种稳定的运动状态。
The results shown that, with the effect of nonlinear components, the symmetry of rotation trajectory of the bearing center was broken, and the motion of the journal center presented a steady state.
曲轴的各轴颈在很高的比压下作高速旋转运动，使轴颈和轴承受到强烈磨擦。
Because the shaft necks whirligig with high speed under high pressure, the shaft necks and bearings endure intense attrition.
同样，在进行曲轴轴颈和曲轴轴承配合间隙的测量时，也可以借鉴这种操作技巧。
Similarly, in the crankshaft journal and crankshaft bearing clearance measurements, they can draw on such skills.
当有径向载荷作用时， 自主式轴承能抑制轴颈位移并因此使轴承获得无穷刚度。
When radial load is applied, the active bearing can surpress the displacement of the shaft, thus obtaining an infinite stiffness.
尾轴承的承载能力随轴颈倾斜率的增大而减小。
The carrying ability of the stern tube bearing decreases with the increase of the inclination of the shaft neck.
研究了轴颈偏斜对径向滑动轴承静态性能的影响。
In this paper, the traditional hydrostatic characteristic formulas of hydrostatic bearing, or slide guide, are analyzed.
在图1-4中，曲轴实际上由以下不同的部分组成，它们分别是：主轴承轴颈、连杆轴颈、曲轴臂、轴承、平衡配量（？）以及飞轮端。
The crankshafts shown in Fig 1-4 is actually made up of various parts such as main bearing journals, rod journal, crank arm, bearing, counter balanced weight and flywheel end.
常见的电动机轴颈磨损原因：装配不合理、键装配不合理、电动机轴承损坏。
The usual reasons of abrasion of electric motor crankshaft are in the following: unreasonable assembly, unreasonable key assembly as well as the spoilage of electric motor bearings.
提出了轴颈倾斜情况下的轴承油膜厚度方程。
The film thickness equation considering the journal misalignment is put forward.
轴倾斜使得轴-轴承系统的动力学响应、润滑性能以及轴颈表面动应力发生改变。
Multidisciplinary coupling analysis on dynamics, tribology, strength and stiffness for a shaft-bearing system was studied herein, considering misalignment caused by shaft deformation on variable load.
介绍了铁路货车段修专用的滚动轴承、轴颈测量与选配系统的软硬件结构与功能。
Described are the structure and the function of hardware and software of the measuring and allocating system for roller bearing and journal of the freight car.
本文讨论了内燃机曲轴轴承副的工作状况和磨损，给出曲轴轴颈磨损的计算模型和计算方法。
The operation conditions and wear of crankshaft bearings in internal combustion engine are discussed in this paper. A model and method for calculating the crankshaft journal wear are given.
尺寸小于标准的凸轮轴主轴承轴颈。
这种新型轴承由检测轴颈位移的非接触式传感器，驱动轴颈的控制阀及调节整个系统的控制器组成。
This new type of bearing is composed of noncontact sensors to detect the radial displacement of its axis, control valve to drive the axis and a controller to regulate the whole system.
数值结果表明，同轴承长径比及转子质量偏心相比，轴颈间隙是影响系统轴心轨迹和频域特性的主要因素。
The result shows that compared with slenderness ratio of bearing and the eccentricity of rotor, the journal clearance is the main factor influencing the trajectory and domain characteristics.
数值结果表明，同轴承长径比及转子质量偏心相比，轴颈间隙是影响系统轴心轨迹和频域特性的主要因素。
The result shows that compared with slenderness ratio of bearing and the eccentricity of rotor, the journal clearance is the main factor influencing the trajectory and domain characteristics.
应用推荐