讨论了波导管输入阻抗与负载阻抗之间的关系。
Also, the relationship between the input impedance and load impedance of the waveguide is discussed.
在实验中得到了输出功率、效率和负载阻抗的关系。
The relationships between the output power, the efficiency and the load resistance have been got.
认为负载阻抗的变化和干扰信号是造成故障的主要原因。
The main reasons of the breakdowns are the changes of load impedance and disturbance signal.
如果你改变了反映负载阻抗,你会发现又一个最佳位置。
If you change the reflected load impedance, you will find yet another optimum spot.
电流互感器二次负载阻抗对电流互感器误差有较大的影响。
Secondary load impedance of a current transformer(CT) has great influence on the error of the CT.
实际的信号失真水平取决于输入和输出信号的幅度,以及输出负载阻抗。
The actual signal distortion levels depend upon input and output signal amplitude, as well as the output load impedance.
负载阻抗匹配的目的是为了使感应加热电源能够输出额定功率、提高效率。
Load matching is intended to make induction heating power to the rated output power, and improve efficiency.
在正弦稳态电路中,当负载阻抗与电源内阻抗为共轭匹配时负载获得最大功率传输。
The load obtains the maximum power transmission when loaded impedance and power source internal resistance for conjugate match in sine stable state electric circuit.
由于直流电压源的钳位作用,交流侧输出电压波形为矩形波,并且与负载阻抗角无关。
Because the clamp effect of DC voltage source, AC side output the rectangular wave voltage waveform, and it has nothing to do with the load impedance Angle.
由于变压器和滤波电容(假定)足够大,因此当负载阻抗改变时供电电压几乎没有变化。
Depending upon the transformer and storage capacitor sizes in the power supply the output voltage will not vary significantly when the load impedance is changed.
然后利用ADS软件对几种微带谐振器进行了分析和计算,使雪崩二极管的负载阻抗与其匹配。
After this, we analyzed and computed several microstrip resonators with ADS, making impedance match between the resonator and IMPATT diode.
然后利用ADS软件对几种微带谐振器进行了分析和计算,使雪崩二极管的负载阻抗与其匹配。
After this, we analyzed and computed several microstrip resonators with ADS, making impedance match between the resonator and IMPATT diode. At the same time, we simulate the transition with HFSS.
因此,它不仅解决了负载阻抗变化时输出电流的恒定问题,还解决了输出阻抗与负载阻抗的匹配问题。
Thus it not only solved the problem of constant output current while load impedance is varied, but also solved the matching problem of output impedance and load impedance.
由于该天线的输入阻抗随频率而变化,需要用一个宽带变负载阻抗匹配网络来实现天线与电台之间的匹配。
The impedance matching network of changeable load and wide-belt is required because the input impedance of spiral antenna changes with frequency.
通过对负载形式、等效电路、振荡回路以及温度变化对负载阻抗的影响等均作了分析计算,给出了图表或提出了经验数据。 。
Abstract :The author analyzes the loads of medium frequency induction heating and their equivalent circuits and resonant tanks, and presents some experience data of three typical loads.
我们还可以看到因为阻尼因子是一个比率值,而且需要负载阻抗已知才能够进行计算,所以阻尼因子必须和某一已知的阻抗同时具明才有意义。
We can also see that because damping factor is a ratio that requires the load impedance to compute it must be stated against some known impedance to be meaningful.
我们还可以看到因为阻尼因子是一个比率值,而且需要负载阻抗已知才能够进行计算,所以阻尼因子必须和某一已知的阻抗同时具明才有意义。
We can also see that because damping factor is a ratio that requires the load impedance to compute, it must be stated against some known impedance to be meaningful.
X1探头﹕没有衰减﹐输入阻抗跟示波器输入阻抗一样(通常是1兆欧)。由于对测试电路有很大的负载影响﹐所以很少使用这种探头。
X1 probe: no attenuation, input impedance follow that of scope input impedance (usually 1 Mohm). This type of probe is seldom used because of heavy loading effect on circuit under test.
而不同容量的负载,以及负载的不同功率因数,对同步发电机励磁磁场的作用是不同的,对同步发电机的内部阻抗压降的作用也是不一样的。
The effect on the generator excitation magnetic field is different when the capacity and power factor of load are different, and the effect on the internal impedance voltage drop is different, too.
介绍了工作于低阻抗负载下的高压大电流快响应脉冲变压器的一种设计方法。
The design method of the high voltage and the fast response time pulse transformer used in the condition of low load impedance was introduced.
一个高阻抗的耦合装置将限制负载。
本文归纳出利用对称负载的阻抗角,计算二瓦特计法表读数的一般规律。
This paper concludes general calculative regularity of readings of two-wattmeter method using the impedance Angle of balanced load.
该模型将微带线的有效阻抗作为匹配负载电阻,然后按适当的比例分布到端接面的网格中。
The model uses the effective impedance of the microstrip line as the value of matched resistive load and assign it into the RL mesh region in a proper proportion.
通过研究分析了恒功率负载负阻抗特性的稳定问题,提出确保电源系统稳定的方法,仿真结果验证方法的可行性。
With the research on the stability of the CPL's negative impedance characteristic, this paper proposes guarantees for the power system to be stable, which are confirmed by the simulation result.
为了使传输线能够将信号源的信号高效不失真地传送到负载,需要考虑阻抗匹配问题。
The problem of impedance matching must be considered in order to transmit the signal of generator to the load efficiently and distortionless by transmission lines.
在一个实例中,所述检测器测量开关电压,以及所述估计电路根据开关电压和该开关的两个节点之间的阻抗来估计输送到负载的功率。
The detectors in one example measure switch voltages and the estimation circuit estimates power delivered to the load according to a switch voltage and impedance between two nodes of the switch.
开关阻抗可以在校准期间,使用参考负载提供。
The switch impedance may be provided during calibration using a reference load.
开关阻抗可以在校准期间,使用参考负载提供。
The switch impedance may be provided during calibration using a reference load.
应用推荐