确保调整螺栓的正确设置。
120目可调研磨间隙的调整简便,只需要使用塞尺和调整螺栓即可精确调整。
Grinding gap adjustment is simple, just use the plug-foot bolts and adjustments can be fine -tuning (10-120 mesh).
悬浮式秤架主要是由加载螺栓,调整螺栓,加载构件,称重托辊、托辊架、传感器等组成的。
The suspended scale rack is mainly composed of a loading bolt, an adjusting bolt, a loading member, a weighing supporting roller, a supporting roller rack, a sensor, etc.
将主机全部线条板,U型垫块(线条板需安装调整螺栓),放置到机组旁边以便主机安装时使用。
Put all line plates and U-shaped filling blocks of the unit beside the engine, so they can be used conveniently later. The line plates shall be fitted with adjustable bolts.
根据检查结果,可以对轨道的压板、鱼尾板、螺栓等进行必须调整。
According to the results of the inspection of track plate, fish plate, bolts etc. must be adjusted.
松开螺栓,调整光辊两端的的小搭钩,使之与卷棉平行。
Loose the bolt, adjust the small hooks on both ends until they are parallel to the cotton carrier.
调整静电带悬垂的长度,直到静电带能与地面保持碰触,然后拧紧保护螺栓。
Adjust the hanging length of this product to let the metallic wire touch the ground, and then fasten the secure bolt.
前方固定的,后面的移动调整和方法定在鼓当你不断旋转,我用了一个螺栓和螺母,在每个磁体。
The front ones fixed, the rear ones mobile with adjustment and method to fix in the drum when you get constant rotation, I used one bolt and nut in each magnet.
当所有的调整已经完成,锁螺母必须加紧了对黑色机壳的每个[3 ]每桶螺栓。
When all adjustments have been finalized, the lock nuts must be tightened down against the black casing for each of the [3] barrel bolts.
在电子天平使用地点调整地脚螺栓的高度,使水平仪内的空气泡正好位于圆环的中央。
At the place of installation, level the balance using the leveling feet so that the air bubble is centered within the circle of the level indicator.
扭矩调整器总成通过主动件上的弧形槽、螺栓与主动件装配为一体,并装配在轮轴上。
The torque regulator assembly is assembled integrally with the driving part and onto the axle;
扭矩调整器总成通过主动件上的弧形槽、螺栓与主动件装配为一体,并装配在轮轴上。
The torque regulator assembly is assembled integrally with the driving part and onto the axle;
应用推荐