因而，疲劳评估设计波法就引起了人们的关注。
This has focused attention on the design wave approach for fatigue assessment.
考虑的具体方法是将PD反馈波控制与基于极点配置法设计的模态控制相结合。
The particular approach considered is that of collocated, PD feedback wave control combined with modal control designed using pole placement.
介绍了二级光谱的基本原理，给出了波差法设计复消色差物镜的方程组。
The principle of secondary spectrum is introduced and the equations of designing apochromatism objective lens based on wave aberration are presented.
采用波差法进行复消色物镜的光学设计。
Optical design of apochromatic objective used wave disparity method in this paper.
本文针对非球面高精度检测，在总结现有检测方法的基础上，设计了基于波带板干涉法的共光路干涉系统。
In this paper, conventional testing methods were summarized. An interferometer was designed based on the schematic of zone-plate with a total optical path for testing aspheric surfaces.
基于无源性理论的波变量法可以保证遥操作系统在任意时延下稳定，已成为 遥操作控制系统设计的一个重要方法。
Wave variable method based on passivity can ensure teleoperation stability with arbitrary time delays and has become an important method for teleoperation system controller design.
此外，在以前分析计算吸波材料的反射率与入射角的关系时，常采用性线插值法，这会引入较大的设计误差。
Besides, in analysis of reflectivity versus incident Angle of absorbing materials, it used to use linear interpolating method and resulted in considerable error.
现场载荷试验及反射波法低应变动力检测试验表明，CFG桩桩身完整性很好，复合地基的承载力提高显著，证明该工程的CFG桩复合地基设计及施工是成功的。
The results of plate loading test and low strain dynamic testing show that the quality of CFG pile composite foundation is good and subgrade bearing capacity has been improved successfully.
在算法设计方面，本论文分析了血压测量中的原始数据，开发出两种方法，用来提高示波法血压测量的精度。
In the software design, this paper, analyzing the native records of cuff pressure during BP measurement, developed two methods to improve the oscillometric blood pressure measurement.
本文首先完成了对波差法光学设计理论的探讨，并进行了实例讲解。
Then calculated the original results of the doublet lenses in the muzzle-axis obtain optical system by Wave-deviation Method, designed and optimized this system by ZEMAX.
本文在分析了几种SPWM调制方法的基础上，将基于对称采样法的SPWM调制算法应用于本设计中，产生了可调频调幅的正弦波脉宽调制信号。
The SPWM algorithm using symmetrical sample in this controller, can alter its frequency and amplitude. The good performance of the BLDC Motor controller using DSP is verified by the experiment.
讨论了聚焦元件的截断效应，研究了天线增益与束腰半径关系并利用高斯波束法设计了毫米波成像准光学系统，在系统参数确定的前提下对聚焦元件进行一体化设计。
The performances of quasi-optics for millimeter-wave imaging system decide the capability of the system, so it is the emphasis of the research of millimeter wave imaging system.
讨论了聚焦元件的截断效应，研究了天线增益与束腰半径关系并利用高斯波束法设计了毫米波成像准光学系统，在系统参数确定的前提下对聚焦元件进行一体化设计。
The performances of quasi-optics for millimeter-wave imaging system decide the capability of the system, so it is the emphasis of the research of millimeter wave imaging system.
应用推荐