空气线路断路器空气线路断路器的功能是当电流大小超过断路器的过流跳脱设定值后自动断开。
Air circuit breaker An air circuit breaker automatically interrupts the current flowing through it when the current exceeds the trip rating of the breaker.
该电路具有既能将负载电流限制在设定值以内,又能控制限流工作时功率管的开关频率等特点。
This circuit has both characters of restricting the current within the giving value and limiting the switching frequency of MOSFET operating on current limited condition.
热继电器的设定值应能在不超过压缩机额定电流的140%时断开。
Thermal relay value should be able to in no more than 140% of the rated current compressor when disconnect.
注:常规出厂的CM 2 Z四极断路器中性极电流值符合表二,用户也可自行100%保护设定。
Note: Normally, current values of neutral pole of CM2Z four-pole, conform to table two, and it can be setted by users with 100% protection.
只要预先设定好胶合电流值和时间,本系统会根据电流的反馈信号自动调节,胶合电流不会受到厚薄的变化和模具温度上升的影响。
As long as the pre-set current value and a good bonding time, the system based on current feedback signal auto - Regulation, will not be glued current thickness change and mold temperature rise.
恒流方式时要求不论输入电压如何变化(在一定范围内),流过该电子负载的电流恒定,且电流值可设定。
Constant current mode, regardless of the input voltage required to change (within a certain range), flows through the constant current electronic load, and the current value can be set.
它只需一只外接电阻就可设定所需的电流值。
Current is established with one external resistor and no other parts are required.
这些特征数据用于提供设定点对目前的离子电流比较值。
These characteristic data are used to provide set point values against which the prevailing ion current is compared.
BCM系列电流监测器具有1至400微安交流或直流可调设定点(BCM - 44 B上有5个预设值)。
The BCM has an adjustable set point (5 presets also available on BCM-44B) between 1 and 400 microamperes AC or DC.
当充电电流在达到最终浮充电压之后降至设定值的1/10 时, EMC5040将自动终止充电循环。
The EMC5040 automatically terminates the charge cycle when the charge current drops to 1/10th the programmed value after the final float voltage is reached.
投入点、切除点、过压值、动作延时值、路数、电流反相等等参数,可通过面板设定。
Fling point, cutting point, overvoltage value, time delay value etc can be set by panel.
电流在反馈电阻上产生的电压超出设定值时,IR 2132启动内部保护电路,关断输出通道,实现电流保护。
When the voltage on the feedback resistance over the designed value, the inside protection circuit was operated and the output channels were cut in IR2132 to achieve current protection.
电流在反馈电阻上产生的电压超出设定值时,IR 2132启动内部保护电路,关断输出通道,实现电流保护。
When the voltage on the feedback resistance over the designed value, the inside protection circuit was operated and the output channels were cut in IR2132 to achieve current protection.
应用推荐