飞秒脉冲放大器中色散的计算和评价方法。
Calculation and evaluation of dispersions in a femtosecond pulse amplification system.
此外，就放大器输入电路及反馈环节的数学模型进行了误差计算与工作稳定性的分析与评价。
In addition, the mathematical model of the input circuit and the feedback link of the amplifier are analyzed on the error computation and stability evaluation.
数值计算的结果表明，半导体光放大器在全光波长转换中具有很好的线性响应特性和较高的转换速率。
The result of numerical calculation indicates that semiconductor optic amplifier has a good responding characteristic and higher conversion rate in all-optical wavelength conversion.
建立了用蒙特卡罗和光线跟踪法计算高功率固体激光系统棒状放大器能量沉积分布的模拟程序。
The ray tracing and Monte Carlo method are applied to calculate the distribution of deposited pumping energy within a rod amplifier of the high power solid state laser system.
利用谐振放大器的原理计算了光谱特性。
The spectral characteristics have been calculated with the principle of the resonant amplifier.
通过合理分析提出了便于计算多波长双向抽运光纤拉曼放大器信号及噪声功率的实用数值模型，给出求解信号和噪声功率的快速算法。
A novel numerical model and an efficient algorithm are developed to calculate the powers of signal and noise light waves in multiple wavelengths bidirectionally pumping fiber Raman amplifiers.
介绍了放大器中ase的常用计算方法。
The general calculating methods of ase for laser amplifiers are introduced.
提出了一种改进的、可用于计算偏振相关拉曼增益的光纤拉曼放大器的非线性耦合波方程。
A set of improved nonlinear coupled-wave equations describing the properties of fiber Raman amplifiers is developed, which can be applied to calculate the polarization dependent Raman gain.
通过计算机对接收机增益进行智能化控制，既避免了放大器饱和，又使得采样的量化误差最小。
The smart gam-control of the receiver not only avoids the amplifier saturation, but also minimizes the discrete error.
计算单元从由第二放大器放大的每个像 素信号中减去黑电平信号成分。
The computing unit subtracts a black level signal component from each of the pixel signals amplified by the second amplifier.
论文的第四章给出CARM放大器数值模拟模型，对数值模拟过程中的参量计算，程序流程图做了详细的论述；
The forth chapter introduces the Numerical simulation model of coaxial-waveguide CARM amplifier, gives out parameters computation, and procession flow charts.
借助于计算机的模拟计算，对于读出放大器的设计作了一些改进。
Using simulation techniques, we have made some improvement for design of the sense amplifier.
同时，利用相位渗透理论，数值计算了垂直腔半导体光放大器（VCSOA）中的有效腔长。
The efficient cavity length of vertical cavity semiconductor optical amplifier (VCSOA) is calculated with the theory of phase penetrating.
双回转机构的步进电机控制电路由TDA1521音频集成功率放大器组成平衡桥式功率驱动电路，由计算机并行口经过锁存器构成脉冲分配器。
To control stepping motors, the balance bridge power drive circuit is made up by TDA1521 integrated audio power amplifier, the pulse allotter is made up by the parallel ports of computer and latches.
介绍了用工业控制计算机控制卫星地面站功率放大器的一种方法，阐述了控制系统的硬件和软件基本组成。
This paper introduce a method that industry control computer controls power amplifier in the satellite earth station, and expound the structure of the hardware and software of the control system.
本文提出了一种完全依照理想运算放大器的特性，对含这类元件的线性时不变电路利用PSPICE进行计算机仿真的新方法。
New systematic approach to the simulation of circuits containing ideal operationamplifiers using the standard simulators such as PSPICE is first presented.
编制了一套用蒙特卡罗方法计算钕玻璃片状放大器内自发辐射放大(ase)的模拟计算程序，考虑了光线在两大表面不同入射角对反射率的影响。
In this paper, a model program has been established to investigate the amplified spontaneous emission (ASE) in the nd: glass disk amplifier with the Monte Carlo method and rays tracing.
在放大器的非饱和范围内，计算结果和实验结果十分一致。
The simulated calculations are in good agreement with experimental results before the amplifiers are saturated.
该系统主要由电动执行机构、高压油泵、盘式制动器、压力传感器、放大器、接口电路、计算机及打印机等组成。
The system is composed of the electro-actuating mechanism, oil pump of high pressure, disc brake, pressure sensor, amplifier, interface circuit, computer and printer.
基于该模型，编写了圆柱腔回旋自谐振脉塞放大器单模波束互作用计算程序，并对麻省理工学院的一个实验进行了非线性模拟。
Based on the model, a code of nonlinear beam-wave interaction in the CARM amplifier has been made. We use this code to simulate the experiment achieved in Mashachusetts Institute of Technology (MIT).
利用卧式后坐装置、磁电式速度传感器、测量放大器、瞬态波形记录仪及计算机组建了一套水下发射装置后坐能量测试系统。
Recoil energy measuring system of a underwater launcher is formed by means of horizontal recoil device, electromagnetic velocity sensor, measuring amplifier, transient waveform recorder and computer.
阐述了流量放大器的工作原理，建立了流量放大器的静动态数学模型，并利用计算机进行数字仿真。
The principle behind the flow amplifier is described and the static and dynamic mathematical models is established. On this basis, digital simulation is implemented on a computer.
计算了不同的片放张数、放大器增益和普克尔盒效率与系统隔离效率之间的关系。
The relationships of the isolation efficiency with the numbers of slab, the growth of the amplifier and the switch efficiency of Pockels cell are calculated theoretically.
利用计算机和参数控制与数据采集器对膜片钳放大器进行数字控制和参数检测，并采用最小二乘拟合等算法计算相关参数。
The routine controls and inspects the patch-clamp amplifier by employing the personal computer and data acquisition, and then evaluates the analog parameters using relative arithmetic.
概述了拉曼光纤放大器(FRA)和掺铒光纤放大器(EDFA)的理论模型，据此计算它们的增益谱。
The theoretical models of Fiber Raman Amplifier (FRA) and Erbium Doped Fiber Amplifier (EDFA) are presented, and their gain spectra are accordingly calculated.
该系统是以微型计算机为主，由脉搏传感器，程控放大器和多功能数据采集器组成。
The system is composed of microcomputer, sensor of pulse, program-control amplifier and data sampler.
利用该程序研究了椭圆波导FEM放大器的输出功率、效率、带宽等高频特性，并对不同椭圆度的椭圆波导FEM放大器的性能进行了计算、对比分析。
The characteristics of FEM amplifier with elliptical guide, such as the evolutin of power, efficiency and bandwidth, are analyzed. These results are useful to design FEM devices.
多级放大器的放大倍数的计算有两种基本方法，但当多级放大器中含有双入双出型差动电路时。
When multistage amplifier has double-input double-output differential circuit, the two methods produce different calculating results.
多级放大器的放大倍数的计算有两种基本方法，但当多级放大器中含有双入双出型差动电路时。
When multistage amplifier has double-input double-output differential circuit, the two methods produce different calculating results.
应用推荐