温度和相对湿度也会影响表面电阻。
Temperature and relative humidity can also affect the surface resistance.
目的：研究牙冠表面电阻状态。
Aim: to study the electric resistance of the crown surface of tooth.
很多塑料具有高的表面电阻和低的导电性能。
Many plastics have high surface resistance and low electrical conductivity.
体电阻率和表面电阻率的测量决定于几个因素。
Volume and surface resistivity measurements are dependent on several factors.
湿度将使表面电阻率的测量结果比正常情况低一些。
Moisture will cause the surface resistivity measurements to be lower than normal.
测量的粒子，表面电阻和膜厚度的数值分别记录在表单，见表2。
The measured value of particle, sheet resistance and film thickness have been respectively recorded in a table, please see table2.
分析了影响防静电瓷质地板表面电阻和体积电阻测定的主要因素。
The paper analyzed the main factor for determining surface electric resistance and cubic electric resistance of anti-static-electric porcelain tiles.
本文报导一种测量高温超导薄膜微波表面电阻的新方法和测试装置。
A new method and experimental device for measuring microwave surface resistance of high Tc superconducting thin films are presented in this paper.
达到期望表面电阻的同时，不会影响到制成品的表面光泽及透明性。
It could achieve expected surface resistivity, without an effect on the gloss and transparency of final products.
“污染等级”是指固体、液体或气体恶化绝缘强度或表面电阻率的程度。
"Pollution degree" describes the degree to which a soild liquid or gas which deteriorates dielectric strength or surf ace resistivity is adhering.
研究碳纤维水泥试块两电极电阻和三电极法测得的体积电阻与表面电阻。
The volume resistance and surface resistance measured by three electrodes and the resistance between two electrodes (r) of carbon fiber reinforced cement (CFRC) were studied.
因此，用什么方法去测量高温超导薄膜的微波表面电阻就显得尤为重要。
Therefore, the method to measure high-temperature superconductor thin films' microwave surface impedance plays an important role.
绝缘刷表面电阻在1012- 1016之间，是一款廉价的防静电设备。
Insulative brushes have a surface resistivity of 1012-1016 and are an inexpensive water resistant alternative to Anti-Static brushes.
电阻率的测量方法是测量电阻，然后再考虑几何因素将其变换成表面电阻率或体积电阻率。
Resistivity is determined by measuring resistance, then converting to surface or volume resistivity by taking geometric considerations into account.
高温超导(HTS)体由于具有较低的表面电阻，在天线应用中，它可以提高天线的效率。
The high temperature superconductors (HTS) bearing low surface resistance can be used to raise the efficiency of antenna.
本文介绍了两种测试高温超导薄膜微波表面电阻的方法：双谐振器法和蓝宝石介质谐振器法。
Two kinds of microwave surface resistance Rs measurements of high Tc superconductive thin films are introduced in this paper, two-resonator method and the sapphire resonator method.
本文介绍了绝缘子污染的测量方法，表面电阻测量装置和泄漏电流检测装置，并取得一些结果。
This paper introduces the method of insulation pollution testing, including surface resistance device and Vent current testing device, with correct results.
这两种方法虽然各有优缺点，但都能够测量高温超导薄膜的微波表面电阻，而且测试灵敏度较高。
Though both of the methods have it's own advantage and disadvantage, the Rs can be measured with high sensitivity.
玻璃和陶瓷也具有很高的体电阻率，但是在高湿度下表面电阻率性质较差，并且其压电性常常也较差。
Glass and ceramics also have high volume resistivity, but poor surface properties at high humidity and often-poor piezoelectric properties.
结果表明，随离子注入的种类不同、剂量的变化、温度的升降，PET膜的表面电阻率呈规律性变化。
The results show that the specific surface resistance of the PET film decreases regularly with increasing implanting dose and growing temperature.
影响印制板表面电阻的因素包括印制板材料、有无涂层(例如防焊漆或保形涂层)，以及电路板的清洁。
Factors that affect the surface resistance of the board include the board material, the presence of coatings such as solder masking or conformal coatings, and board cleanliness.
随着镀铜层厚度的增加，木材表面的导电性有明显的提高，同时不同切面各方向上的表面电阻率的值也趋于一致。
With the increasing of the thickness of copper layer, the electric ability of the surface is also improved and the exterior resistivity of different surface is also more identical.
本文中对任意费米面求出了金属在红外波段的表面电阻，所得表达式适用于各种性质的趋肤效应(正常、反常和中间情况)。
Surface impedance of metals in infrared region is calculated for an arbitrary Fermi surface. Expressions applicable to all cases of skin-effect (normal, anomalous and intermediate) are obtained.
研究了使用三类不同导电填料制得的粉末涂料的表面电阻与导电填料含量的关系，确定了粉末涂料中各类导电填料的渗滤阈值。
The relationship between surface resistance and conductive fillers content in hybrid type powder coatings for three different types conductive fillers was studied.
本节详细介绍如何使用这些测试夹具来进行表面电阻率和体电阻率的测量，以及测量电阻率时使用的变换极性和变换电压的技术。
This section details how to make surface and volume resistivity measurements with these test fixtures, as well as the Alternating Polarity and Alternating Voltage techniques for measuring resistivity.
表面电阻测试仪是一种测试物体表面电阻率和对地电阻的仪器，可进行简单可重复的导电性能、静电耗散、绝缘表面性能的测量。
This compact meter measures both surface resistivity and resistance to ground. It is giving simple repeatable measurement of conductive static dissipative and insulative surface.
方法：采用自行研制的人体穴位表面电阻测定仪对2 281名健康人的胃经五输穴体表阻抗进行测试，分别于春、夏、秋、冬季检测。
Methods:The impedance fluctuation on different points in Wushu was measured by a micro-computer with pressure sensor to 2281 healthy people.
方法：采用自行研制的人体穴位表面电阻测定仪对2 281名健康人的胃经五输穴体表阻抗进行测试，分别于春、夏、秋、冬季检测。
Methods:The impedance fluctuation on different points in Wushu was measured by a micro-computer with pressure sensor to 2281 healthy people.
应用推荐