土壤表面湿度与土壤反射率的关系及其土壤表面湿度的几种反射率反演方法的评价；
The relationship between soil surface moisture and soil spectral reflectance as well as evaluation of several inversion method of soil surface moisture from reflectance;
最终，海水表面的温度上升，虽然不像空气温度上升那么快，但已经快到足以造成危险的湿度上升。
Eventually the temperature of the surface waters of the sea rose, not so fast as the air temperature it is true, but fast enough to produce a dangerous increase of humidity.
控制循环空气的相对湿度和空气的温度可防止表面硬化的出现。
It is prevented by controlling the relative humidity of the circulating air and the temperature of the air.
我们近期无暇顾及专利问题，因为可变形表面仍然存在坚固性和可靠性问题，尤其是在不同的温度和潮湿度当中。
We have put that aside for the near term, as they still have problems with robustness and reliability, especially across varying temperatures and humidity.
玻璃蒙上水雾模糊不清是因为温度和湿度较高的气体接触冷表面便会骤然冷凝。
Glass mists up because of sudden condensation when warm, humid air comes into contact with a cold surface.
舒适的房间和温暖的表面温度与理想的湿度平衡和传统保暖问题相结合。
Comfortable room and warm surface temperatures are combined with ideal moisture balance and an absence of traditional thermal problems.
湿度将使表面电阻率的测量结果比正常情况低一些。
Moisture will cause the surface resistivity measurements to be lower than normal.
玻璃和陶瓷也具有很高的体电阻率，但是在高湿度下表面电阻率性质较差，并且其压电性常常也较差。
Glass and ceramics also have high volume resistivity, but poor surface properties at high humidity and often-poor piezoelectric properties.
温度和相对湿度也会影响表面电阻。
Temperature and relative humidity can also affect the surface resistance.
如果空气的相对湿度介于50%-80%，底层油漆必须在表面处理后最多3小时内涂覆。
The first coat of paint must be applied maximum3 hours after the preparation of the surface if the relative humidity of the air is between50% and80%.
原因：当室外湿度大的时候，室内机制热，室外机冷凝器表面会结霜，这样会影制热效率。
Reason: when the humidity outdoor, indoor, outdoor heating surface of the condenser will, this will be the frost of heating efficiency.
请勿将产品置于高湿度环境使用，应置于坚固平坦之表面使用。
Do not use the product in humid environment. Put the machine on firm and flat surface.
冷凝物和过多的潮气能导致湿度和设备表面微生物的数量的增加。
Condensate and excessive moisture can result in increased humidity and increases in levels of microorganisms on surfaces of equipment.
施工条件：施工表面必须干燥，气温在5摄氏度以上，空气相对湿度小于80%。
Construction conditions: Construction of the surface must be dry, the temperature at 5 degrees Celsius, relative humidity less than 80%.
模型中输出参数为室内空气温湿度和各内表面的温度。
The output parameters of the model were temperature and relatively air humidity.
陶瓷基板的表面张力和厚膜浆料对基板的润湿度会影响印刷线条的分辨率。
The influence of surface energies of ceramic substrates an line resolution in screen printing was studied in this article.
尖端曲率半径、针尖在基底表面滞留时间、针尖扫描速度、空气湿度、表面粗糙度等均会影响纳米结构的线宽。
The line width of nanostructures is influenced by many factors such as tip curvature radius, detained time in the base surface, scanning speed, humidity, surface roughness etc.
实验还发现，对霜层生长初期影响最大的两个因素是冷表面的温度和空气的相对湿度。
It is also found that the most important factors that influence the frost growth are the temperature of cold plate and relative humidity of air.
由湿度随时间的微分规律拟合了吸附床的除湿传质系数与吸附剂表面平衡湿度。
Mass transfer coefficients of dehumidification and equilibrium humidity on adsorbent surfaces are determined by fittings of humidity derivatives.
大体积混凝土的养护主要是控制混凝土中心和表面的温差，保持一定的湿度，防止产生裂缝。
The main point of bulky concrete curing is to control the temperature difference of the center and appearance of concrete, maintain a certain humidity and prevent cracking.
结果表明，套袋和除袋方法以及外界环境条件变化都能在一定程度上影响袋内微域温湿度及其果实表面温度。
The results indicated that, bagging techniques and external environmental factors could affect fruit surface temperatures and its microenvironment to different extents.
与持续的空气调节器相似，此款加热器可用于较小的密闭空间或建筑物内，可以控制建筑物表面的湿度和污染物等级。
Designed like a permanent air handler, these heaters work well in tightly enclosed Spaces or buildings, helping control moisture and contaminant levels for construction finishing.
而对高温、高湿度工况，霜层表面出现了首先形成凝结水滴的现象，使得霜层密度大大增加。
Under the conditions of the high air temperature and humidity, the average frost density is raised significantly due to the appearance of the water droplet on the frost layer surface.
着重从基本界面力，即表面张力、范德瓦耳斯力和基本键合力的形成与变化，分析了二氧化硅表面粘着力随湿度的增大先增后减的原因，探讨了粘着力的产生机理。
The mechanism of the adhesion force changing with the relative humidity has been analyzed from the viewpoint of surface tension, van der Walls force, and basic bond forces.
对一台空气源热泵翅片管蒸发器表面结霜特性进行了实验研究，分析了室外环境温度和相对湿度对霜层形态和密度的影响。
The effects of the outdoor air temperature and humidity on the frost morphology and density of the frost layer were analyzed.
模式主要输入的参数有气温、地表面温度、湿度、风速及测量点高度。
The main input parameters are air temperature, surface temperature, humidity, wind speed and the measurement height of these variables.
与湿敏传感器的湿度计相比，由于不存在表面污染失效的情况，所以解决了传感器使用寿命短的问题。
Compared with the prior hygrometer with a moisture sensitive sensor, the invention solves the problem of short service life of the sensor as no failure resulting from the surface contamination occurs.
不锈钢外圈表。大的表面盘。具有温度、湿度、气压测量，时间观看的多功能。背部设计有挂墙孔，可县挂于室内、外使用。
Stainless Steel and Brushing…Large dial design and tend indicator. Has multi function to measuring temperature, humidity and atmospheric pressure. With back hole for wall mounting indoor…
不锈钢外圈表。大的表面盘。具有温度、湿度、气压测量，时间观看的多功能。背部设计有挂墙孔，可县挂于室内、外使用。
Stainless Steel and Brushing…Large dial design and tend indicator. Has multi function to measuring temperature, humidity and atmospheric pressure. With back hole for wall mounting indoor…
应用推荐