针对薄膜压力传感器的特性，设计各种性能补偿方法。
Various performance compensation methods have been designed according to the characteristic of the thin film pressure sensor.
在一个压力容器中加热酒精含量为80%的龙舌兰酒从而产生钻石薄膜。
Thin films of diamond were produced by heating 80%-proof tequila blanco in a pressure vessel.
他们的方法是将一块会随着压力变薄的橡胶薄膜和电容整合起来，以此测量变化。
Their approach was to use a rubber film that changes thickness due to pressure, and employs capacitors, integrated into the material, to measure the difference.
现已证明金刚石薄膜有压阻效应，这个性能打开了金刚石薄膜在压力传感器领域的应用。
It has been established that diamond films have piezoresistivity. This property enables diamond films to be used in the field of pressure sensor applications.
重新封装薄膜，先进的剥离技术，暴露了压力感应层当消费者打开包。
Reseal film, an advanced peelable technology that exposes a pressure sensitive layer when the consumer opens the package.
影响阳极基底与YSZ电解质薄膜共焙烧匹配性的主要因素是成型压力、预焙烧温度和焙烧升温速率。
Molding pressure, Sinter temperature in advance and the velocity of temperature raised are the main factors for the matching of anode substrate and thin film YSZ electrolyte.
影响阳极基底与YS Z电解质薄膜共焙烧匹配性的主要因素是成型压力、预焙烧温度和焙烧升温速率。
Molding pressure, sinter temperature in advance and the raise velocity of temperature were the main influencing factors for the matching of anode substrate and thin film YSZ electrolyte.
研究了氢稀释、气体压力和RF功率对薄膜性质的影响。
The effects of hydrogen dilution, gas pressure and RF power on the properties of the films have been investigated.
针对偏瘫病患者身体接触面间的压力分布检测，提出并研发了一种基于压阻效应的新型非硅薄膜网格压力传感器。
A new type of non-silicon thin film grid pressure sensor was brought forward and devised to detect and measure the pressure distribution between the bodies s touching surfaces of hemiplegics patient.
在不同压力条件下用原位聚合法制备了导电聚苯胺薄膜。
The conducting PANI films were synthesized by in situ polymerization under various high pressures.
然后通过设计实验，研究了反应剂浓度，反应温度，反应压力等各反应条件对介质薄膜的影响，以及不同反应条件下淀积形貌的特点。
Experiments are designed to study the effects of precursor concentration, reaction temperature and pressure on deposition film properties, and the deposition profile under different conditions.
附带的电子器件可增加校准时的薄膜加热功能和放大从探头的扩音压力传感器输出的信号。
Additional electronics have been added to provide film heating for calibration and to amplify the signal from the head's microphone pressure sensor.
结果表明：在较低压力沉积的氮化铝薄膜有良好的择优取向性；氮化铝薄膜残余应力为压应力，且随气体压力增加而逐渐变化。
Results show that AlN films deposited at low gas pressure have good selective orientation, and compressive residual shes increased with gas pressure is found in the films.
通过相图讨论了系统压力、激活温度和氟含量对低压金刚石薄膜淀积条件的影响，可以为实验研究提供理论指导。
The principles of effect of system pressure, activation temperature and content of fluorine were obtained by the phase diagrams.
其中着重描述了反应腔对反应温度，反应压力和气体流量的控制方法，以及测量设备对淀积薄膜性能的测量原理。
This paper reviews the work principle of the reactor for deposition temperature, pressure and gas flow control, and the measurement theory of the measurement devices.
薄膜的沉积速率随溅射功率增大而增大，随n 2压力增大而减小。
While the deposition rate increased with the RF power, but decreased with the N2 pressure.
实验发现，射频频率的变化对碳化硅薄膜的防水汽扩散能力影响最大，气体流量比次之，而功率和气体压力的变化影响较小。
The experiment results indicate that the moisture-resistance capability of SiC x film was mostly influenced by RF frequency and precursor gas flow ratio. It was also found that t…
介绍一种以多晶硅薄膜为敏感材料的压力传感器。
A polysilicon thin film pressure sensor is presented. It utilizes polysilicon thin film as stress sensitive material.
介绍一种以多晶硅薄膜为敏感材料的压力传感器。
A polysilicon thin film pressure sensor is presented. It utilizes polysilicon thin film as stress sensitive material.
应用推荐