检查蓄电池电压是否足够。
蓄电池容量不足将不能保证正确的油泵泵送量和喷油器的触发。 蓄电池电压应高于12伏。
Check battery condition. A weak battery will not ensure proper pump delivery or injector triggering. Should be over 12 volts. B.
采用压力温度法测量氢气消耗量，对蓄电池电压、电流进行连续测量和积分运算得到电能量消耗。
Pressure and temperature method is assumed to measure hydrogen consumption, Battery voltage and current is continuously measured and integrated to calculate electric energy consumption.
UPS在极短时间内进入“德国阳光蓄电池电压过低自动关机”的工作状态，从而停止向负载供电。
UPS in a very short time into the "German sunshine low storage battery voltage automatic shutdown" working condition, so as to stop supply power to the load.
当德国阳光蓄电池电压降到低限时，报警通知用户，然后自动关机以防止德国阳光蓄电池深度放电。
When Germany sun battery voltage to the low limit, alarm notifies the user, and then automatically shut down to prevent the sun battery deep discharge in Germany.
研究了环境温度，过量空气系数，蓄电池电压，点火提前角对单循环冷起动时，起动转速和排放的影响。
The effects of environment temperature, excess air ratio, storage battery voltage on start speed and emissions are studied.
电压控制的装置出现错误可能会导致蓄电池组充电过度，这反过来可能会加速放电，比正常情况更严重。
A fault in the voltage-control mechanism may thus cause a battery to become overcharged, which, in turn, might precipitate a deeper discharge than normal.
此外，给nimh蓄电池组充电是个麻烦的过程，因为随着存储电能总量的增加，必须谨慎减少电压。
Also, charging a NiMH battery is a tricky business because the voltage has to be carefully reduced as the amount of energy being stored increases.
池的额定电压、额定容量及应由多少节德国阳光蓄电池组合等。
Pool of the rated voltage, rated capacity, and by how much day Germany sun battery combination, etc.
开路电压判断电池的剩余容量，然后采用不同的方法对德国阳光蓄电池进行补充充电。
Open circuit voltage to determine the residual capacity of battery, and then adopt different methods to supplement the Germany sunshine battery charging.
达到80%以后，UPS转为浮充电压对德国阳光蓄电池进行恒压充电。
Reached 80% after UPS to float charging pressure constant pressure on Germany sunshine battery charging.
多档电压可选，保护电压可设，大大降低维护人员的劳动强度，是蓄电池生产厂家和蓄电池用户的明智选择。
It is the intelligent choice of battery manufacturers and users that can decrease the work intensity of maintainer due to its selected voltage shift and protected voltage.
动态电压恢复器(DVR)对线路电压的跌落迅速作出响应，并通过储能装置(如蓄电池)恢复电压波形的失去部分。
A dynamic voltage restorer (DVR) instantly reacts to drop in line voltage and restores missing portion of waveform from an energy storage device (eg. battery).
电动汽车蓄电池组由多个蓄电池串联组成，电压的测量有一定困难。
Since the batteries used in the EV are in series, it is difficult to test the voltage of every single battery.
通过对电源结构的详细阐述，分析总结了电源远程监控系统需要检测、控制的主要参数，并且以蓄电池的电压、电流、温度检测设计作为电源参数检测的一个应用实例加以分析。
We analyses the structure of power supply, many parameters should be detected in remote monitoring, we give an example of how to detect the voltage, current and temperature of accumulator.
蓄电池配组方法包括：电压配组、容量配组、内阻配组及动态特性配组等。
The methods of making sets of batteries include the using of the voltage, capacity, inside resistance or the dynamic property.
研究表明，采用ISG技术后，当蓄电池的电压为36～60V时，均可将柴油机拖至目标转速，满足起动要求。
The results showed that with the ISG technology, the diesel engine can be dragged to meet the requirement speed on the battery voltage of 36~60V.
控制器还根据环境温度和蓄电池端电压选择适当的充电方式，蓄电池将充满时，控制器会自动调整成为过充和浮充方式，从而能有效地延长蓄电池的寿命。
Based on environment temperature and battery terminal voltage, the controller can also adopt proper charge mode, such as overcharge and floating charge, to extend the battery life.
在详细研究了CAN现场总线技术的基础上，本文提出了蓄电池组电压数据采集系统的设计。
On the basis of research in CAN-bus technique, this thesis proposes design of voltage data acquisition system in storage battery.
然而，在没有大容量蓄电池吸收能量的情况下，再生制动将产生很高的泵升电压，给系统工作带来不利。
However, due to the lack of accumulator of big capacity to absorb energy, this method produces high bumping voltage, which is harmful for system.
采用高倍率放电循环试验方法，研究了阀控免维护铅酸蓄电池在循环过程中端电压和容量的变化规律。
The variation of discharge voltage and capacity for VRLAB were investigated by means of cyclic tests at high discharge rate.
分析和确定了电动助力车主要性能的检测项目，并对车速、续行里程、载荷、蓄电池的放电电压和放电电流等被测项目的检测原理及实现方法进行了探讨。
The testing principle and the performing method of testing items such as speed, range, load, discharge voltage and current for electro-hybrid bicycle are described based on deciding the items.
在某型号密封铅酸蓄电池的批量生产中，出现贮存期间部分电池因开路电压显著下降而失效的现象。
In mass production of sealed lead acid battery, partial products fail because of serious open circuit voltage (OCV) loss during storage.
控制器还能实时测量蓄电池的端电压，对蓄电池进行充放电保护。
The controller also measures the battery voltage, and achieves the battery charge and discharge protection.
阐述了阀控式密封铅蓄电池组中各单电池的浮充电压值是服从正态分布规律的。
The values of floating charge voltage for all cells in the VRLA group were as the law of normal distribution.
在其生命中的电压，蓄电池仍然可以存储大约12千瓦小时，与通用汽车的设想，它可以被用来作为储能装置，一旦远离家园的汽车。
After its life in the Volt, the battery will still be able to store about 12 kWh, and GM envisions that it could be used as an energy-storage device in homes once removed from the car.
蓄电池在安装时要对蓄电池外观进行检查，对单节开路电压作测试并记录。
Installed in battery to battery exterior inspection of single-section for the open circuit voltage tested and recorded.
最后还搭建了一套蓄电池数据采集调试系统，本系统基本完成了课题的目标，实现了蓄电池单体电压、蓄电池组总电压、蓄电池电流和蓄电池温度数据的监控。
Then a battery wireless data acquisition system is set up at the end of the dissertation. The system can monitor the single battery voltage, the total voltage, current and temperature of the battery.
最后还搭建了一套蓄电池数据采集调试系统，本系统基本完成了课题的目标，实现了蓄电池单体电压、蓄电池组总电压、蓄电池电流和蓄电池温度数据的监控。
Then a battery wireless data acquisition system is set up at the end of the dissertation. The system can monitor the single battery voltage, the total voltage, current and temperature of the battery.
应用推荐