分析了节流孔的设计和计算方法。
The design and calculating method of the orifice are analyzed.
本文就节流孔板进行了试验研究。
Experimental study on throttle orifice plate is processed in this paper.
根据设置压力和节流孔通径来确定阀门的流容。
膜片节流孔受堵。
文中还给出了液路系统中各串联节流孔压降公式。
Also, a formula calculating the pressure drop of series throttle holes in the liquid propellant transporting system is given in this paper.
文中还给出了液路系统中各串联节流孔压降公式。
Also, a formula calculating the pressure drop of series throttle holes in the liquid propellant transporting sys...
在空气静压导轨中，节流孔形状和孔径大小是主要振源之一。
The orifice shape and aperture size is one vibration source on aerostatic bearing.
在热力入口或空调靠近冷源环路的部分管段上增加节流孔板。
Heat or air conditioning at the entrance near the cold source loop on part of tube sections to increase savings Orifice.
结果表明，U型弧底节流孔具有更大的压降和更高的热力学效率。
It is shown that the U-bottom orifice has higher total pressure drop and (thermodynamic) efficiency.
节气门体有一个节流孔和IACV，以满足发动机怠速气流要求。
The Throttle body has a by pass hole and IACV for meeting the idle airflow requirement of the engine.
研究结果表明：空气弹簧动态特性与节流孔孔口大小有着明显的关系。
The result showed that the dynamic characteristics of the air spring with auxiliary chamber are interrelated observably to the size of the throttle orifice.
该文对初始稳定流开始的液流通过节流孔的过渡过程进行了数值解析计算。
The transient flow through a pipe orifice starting from an initial steady flow has been studied via numerical analysis.
介绍了选择节流孔板的计算方法，包括节流孔板级数、压力差和孔径的计算。
As for the selection of throttle orifice, methods for calculating the number of orifice stages, pressure difference and orifice diameter are described as well.
结果表明，节流孔尺寸误差越大、位置偏移误差越大，引起的干扰力矩越大；
The result shows that disturbing torques are increased with both the diameter error of orifices and their position error;
本文对末端为容腔和节流孔的简单管路提出了一套对谐振频率和峰值的估算方法。
This article puts forward a complete set of evaluating method of resonance frequency and its peak in simple line with a chamber and restriction orifice at the end.
根据计算提出采取固定节流孔外加垂向减振器方式更适合我国的车辆运营状况和线路情况。
It is pointed out on the basis of the calculation that application of the fixed throttle and the vertical damper are more appropriate to the vehicle operation and track conditions in our country.
常开：当线圈通电时，先导孔关闭，阀上腔由活塞节流孔增压和复位弹簧的推力，电磁阀关闭。
Normally Open: When the coil is energized, the pilot hole closed, the valve chamber and pressurized by the piston return spring throttle thrust, the electromagnetic valve is closed.
对于强制循环系统，为了避免循环水动力的多值性，设计均要求在每一根水冷壁管设置节流孔板。
For the forced circulation system, to avoid the excessive values of circulation water dynamic, every water cooling tube must be mounted throttle plate in the design.
通过在溢油口开设节流孔，使该阀开启和关闭较为缓和，这样有效地降低了因控制阀造成的噪声。
To reduce the noise of the control valve, a throttle is set on the export of control valve to make it opening and closing not so frequently.
当对节流孔以及环形缝隙两变量赋予合适的数值时，得到的空载恢复时间数据符合设计规范的要求。
The datum of the recovery time are clarified to be in line with the requirements of the design criterion by choosing the proper parameters for the throttle gate and the annular gap.
本文在介绍空气轴承式板形检测辊的工作原理、结构设计的基础上，分析了节流孔的设计和计算方法。
After introducing the operating principle and structure design of the strip shape measuring roll based on Pneumatic bearing, the design and calculating method of the orifice are analyzed.
这个战略装备虚度光阴和部分节流孔操作的一个极端精瘦的整体混合物，与对燃料消费的比照减少。
This strategy furnishes an extremely lean overall mixture for idling and part-throttle operation, with commensurate reductions in fuel consumption.
结果表明，空气弹簧气囊外形及材料特性、附加气室容积和节流孔直径是影响空气弹簧性能的主要因素。
The results show that shape of the air cell, properties of the material, volume of the appended gas chamber and diameter of the throttle hole are main factors affecting the dynamics of air springs.
船舵踏板哀伤地使用一个私有的连接器（象节流孔），因此您不可能卖他们对没有G940的其余的人。
Sadly the Rudder pedals use a proprietary connector (as does the throttle) so you can't sell them to someone who doesn't have the rest of the G940.
当一个阀的控制节流孔被一个大颗粒堵住时会出现突然失效，例如一个阀体可能因为细小淤泥而无法工作。
When a valve's control throttle is stopped up by a big pellet will appear expires suddenly, for example a valve chest possible to work because of tiny silt being unable.
当线圈断电时，先导阀芯靠弹簧复位，先导孔关闭，阀腔由活塞节流孔增压和复位弹簧的推力，电磁阀关闭。
When the coil power, the pilot valve by the spring return, pilot hole closed throttle valve chamber pressurized by the piston return spring and thrust, the electromagnetic valve is closed.
当线圈断电时，先导阀芯靠弹簧复位，先导孔关闭，阀上腔由活塞节流孔增压和复位弹簧的推力，电磁阀关闭。
When the coil power, the pilot valve by the spring return, pilot hole closed, the valve chamber and pressurized by the piston return spring throttle thrust, the electromagnetic valve is closed.
结果表明：节流孔板是电控共轨喷油器的重要构成部分，既控制着唢油嘴针阀的开启速度，义控制着喷油率的形状。
The results show that, as important components of electronic injector used in common rail system, orifices affect on the open rate of nozzle needle and injection rate shapes.
结果表明：节流孔板是电控共轨喷油器的重要构成部分，既控制着唢油嘴针阀的开启速度，义控制着喷油率的形状。
The results show that, as important components of electronic injector used in common rail system, orifices affect on the open rate of nozzle needle and injection rate shapes.
应用推荐