对挤条产品有侧压强度的测试，堆积强度测试和耐磨测试。
For extrudates there are side crushing strength tests, bulk crushing strength tests, abrasion tests.
进一步的台架测试结果表明，排气阀在测试过程中表现出了优异的密封性和耐磨性，完全满足发动机的性能要求。
Result of the engine platform test showed that the valve had excellent air-tightness and wear-resistant properties, so could successfully satisfy requirements of the engine.
通过力学性能和耐磨性能测试、金相组织观察和ESEM形貌分析，研究了氮含量对低碳高铬铸铁性能的影响。
The effects of nitrogen on the properties of low carbon high chromium cast iron were studied by mechanical property and wear resistance test, and metallograph analysis using OM and ESEM.
“这些笔头耐磨又好写，完全可以取代进口笔头，”贝发集团测试实验室主任胡省洋说道。
"The pen tips were wear-proof with excellent writing effects and can completely be substituted for imported ones," said Hu Shengyang, director of Beifa Test Lab.
这个卡的外观堪称经典！做工非常精细、外观大方、耐磨！下面我们测试一下这个卡，看速度怎么样。
Rated the appearance of this card classic! Workmanship is very fine, appearance and generous, wear! Here we test this card, to see how kind of speed.
测试了组合镀层的耐蚀性和耐磨性能。
Corrosion resistance and wear resistance of the combination coating are determined.
对化学沉积复合镀层的显微组织结构、显微硬度、时效处理时的晶化与过饱和相的析出以及复合镀层的耐磨往进行了测试。
The microstructure, characteristics of aging processes of the deposited coatings were studied. The microhardness, wear resistance and other properties were tested as well.
通过对弹力织物的相关性能进行测试，认为该织物具有良好的抗折皱性，且强度高、耐磨性好。
Through testing the relative property of the elastic fabric, it is considered to has better creasability, higher strength and better abrasion resistance.
对该感光材料的粒度分布、耐磨性等性能进行测试，获得满意结果。
We have detected granularity distributing, wearproof, adhesion and resolving power of this sensitive material, the results are satisfied.
金刚石-硬质合金复合片的耐磨性是一个非常重要的技术指标，但迄今为止国际上尚无统一的PD C耐磨性测试标准。
The wear resistance of polycrystalline diamond compacts (PDC) is an extraordinary important technique index, but there is no a uniform standard of PDC wear resistance testing method so far.
耐磨性测试表明，脉冲激光强化处理可提高材料耐磨性1.8倍以上。
The wear resistance experiments showed that the wear resistance of ductile iron modified by pulse laser was increased by 1. 8 times.
本文介绍了磁记录介质耐磨性的评价方法和传统的耐磨性测试方法。
The evaluation and traditional testing methods of magnetic recording media's resistance to abrasion are discussed.
采用扫描电子显微镜对膜层进行了形貌分析，并对氧化处理前后样品的耐磨性和耐蚀性进行了测试分析。
SEM (scanning electronic microscope) was adopted to observe the morphologies of the oxidized alloys. The wear resistance and corrosion resistance property were assessed.
本文介绍了用耐磨仪、试穿和扫描电镜三种试验手段，对自捻纱和环锭纱腈纶针织物所作的耐磨性能测试情况。
The wearing tests of the knitted acrylic fabric of self-twist and ring spinning yarn is conducted by means of the wear testing instrument, the wear trial and the scanning election microscope.
对镀层进行了结合力、硬度、耐蚀性以及耐磨性测试，用测厚仪测量了镀层的平均厚度。
The appearance, adhesion, hardness and corrosion resistance of the coating were tested by thickness tester to calculate the average thickness of sedimentary layers.
AATCC快速耐磨性测试仪，可快速检测纺织品、纸、皮革及塑料等柔性材料的干、湿耐磨性。
AATCC rapid wear resistance tester, can rapid detection of textiles, paper, leather and plastic flexible material of dry, wet and abrasion resistance.
通过对M L-100磨粒磨损试验机测试，发现环氧树脂涂层的耐磨性与陶瓷粉末的粒度与含量有密切关系。
Wear resistance tests have proved that the wearability of epoxy. Bonding coating is firmly connected with the size and weight of ceramic powders.
性能测试表明，改进后的热处理工艺使材料的耐磨性显著提高，延长了轧辊的使用寿命。
The property testing shows that the optimized heat treatment process can improve abradability of material evidently and prolong the life of roller.
对注入层的显微硬度和耐磨性进行了测试。
The microhardness and wear resistance of the implanted layer were determined.
对复合区进行显微组织观察及分析、显微硬度测量、耐磨性能测试。
The microstructure, microhardness and wear resistance of compound region were observed and measured.
对复合区进行显微组织观察及分析、显微硬度测量、耐磨性能测试。
The microstructure, microhardness and wear resistance of compound region were observed and measured.
应用推荐