在分析研究三绕组配电变压器等效电路的基础上，介绍了三绕组配电变压器阻抗及等效电路参数的工程计算方法。
Based upon the analysis of an equivalent circuit for distribution transformer with three windings, an engineering calculation method for the reactance and parameters of this transformer is introduced.
增加次级绕组和电路可以获得多个输出。
Multiple outputs are possible with additional secondary windings and circuits.
产品输入，输出的电压高低是根据，联接组别，调节抽头多少，绕组容量分配以及次级单相绕组，净化电路的运用。
Product input and output voltage level is based on, join groups, adjust the number of taps, winding single-phase capacity allocation, and secondary windings, the use of purification circuit.
因为次级绕组通常输入高阻抗的电路，因此次级电流很小。
Since the secondary winding is normally operated into a high-impedance circuit, the secondary current is quite small.
电路方程用于描述定子绕组连接及转子导条和端环连接，电压源可以是任意电压波形。
The circuit equations were used to describe the winding connections to support voltage source with arbitrary waveform.
在回转器—电容模型中，磁路由容性电路来模拟，绕组由双端口的回转器来代替。
In this approach, magnetic paths are modeled by capacitive circuits and windings are represented by two-ports gyrator.
设计一种基于反激式同轴多绕组输出均衡电路，实现对多个串联单体的快速有效均衡。
One kind of equalization circuit based on CWT (coaxial windings transformer) was designed to achieve the destination of fast equalization on series connected ultra capacitors.
一般电路设计对磁性材料和绕组电流相互之间的电磁相互作用研究较少，而这对逆变器快速瞬态性能有重要影响。
To the general circuit design it is no need to research the interaction of the transformer magnetic material and coil current, but it is very important to the study of transient character of inverter.
链式电路是变压器和电机绕组波过程分析时所普遍采用的一种等效电路。
The chain equivalent circuit is generally used for analysis of wave transmission of windings in transformers and electrical machines.
在进行变压器绕组直流电阻的测量时，变压器绕组可以等效为一个由电阻、电感组成的串联电路。
During the measuring of the DC resistance of a transformer's winding, the winding is equivalent to a resistance-inductance series circuit.
本文在分析LR电路过渡过程的基础上，讨论了以特定激励源实现变压器绕组电阻零时间常数测量的方法。
On basis of LR circuit transition process analysis, the paper describes measuring method of zero time factor for transformer wire-wound resistor with specific exciting supply.
若将他励直流电动机输出功率的机理等效为一个与电动机电枢绕组并联的可变电阻，可以得到他励直流电动机可变电阻型等效电路图。
The output power mechanism of a separately excited DC motor can be equivalent to a variable resistance, which is parallel with the armature winding of the motor.
为了对异步发电机十二相功率绕组带整流负载系统进行仿真计算，采用了基于电路拓扑理论的回路电流法。
By means of circuit topology theory and loop current method, simulation and calculation are performed on the 12-phase power winding of an induction generator with rectifier load system.
本文结合河北省自然科学基金项目“特快速瞬态过电压对变压器的影响”（项目编号503624），重点研究了GIS中变压器绕组高频电路模型的建立方法。
Supported by Hebei Natural Science Foundation under grant No. 503624, The high frequency circuit model of the transformer windings in GIS is researched in this paper.
根据故障后支路的电压方程和磁链方程得出了各种绕组短路故障的等效模拟电路；
According to the basic electric circuit theory, the simulation method of various winding fault is deduced.
这种电路的每一支路中的元件，除一般电路元件外，还可能包括功率开关晶体管、二极管或隔离变压器的一个绕组。
Each of the converter circuit branches may contain a power switching transistor, a diode or a winding of an isolated transformer in addition to general circuit components.
励磁绕组和电枢电路有各种接法，因而有不同的性能，这是直流电动机的显著优点。
The field circuit and the armature circuit can be interconnected in various ways to provide a wide variety of performance characteristics - an outstanding advantage of DC machines.
励磁绕组和电枢电路有各种接法，因而有不同的性能，这是直流电动机的显著优点。
The field circuit and the armature circuit can be interconnected in various ways to provide a wide variety of performance characteristics - an outstanding advantage of DC machines.
应用推荐