模拟组分温度与实测温度分布趋势一致。
It is found by evaluation that the trend between simulated and measured temperatures is consistent.
探讨了一种利用MODIS卫星遥感数据提取组分温度的实用方法。
A practical method was developed for component temperatures retrieval with MODIS satellite data.
当然这比你们以前,遇到过的情况要更复杂,以前我们可以得到,只有一种组分的压强温度相图。
Of course it's now a little bit more complicated than what you went through before, where you can get pressure temperature phase diagrams with just a single component.
给我温度和压强,还有两种组分,比如说水和酒精,我可以告诉你组成的所有信息,这很强大。
Give me the temperature and pressure and these two components, like water and alcohol, for instance, and I can tell you everything about the compositions. It's very powerful.
我们一开始有四个变量:,温度,压强,某个组分在液体中的比例,和它在气体中的比例。
We started out with four variables; the temperature, the pressure, and the components in the composition in the liquid phase and the composition in the gas phase.
你只需要某些你非常熟悉的宏观变量,比如压强,温度,体积,每个组分的摩尔数,系统的质量。
You just need a few macroscopic variables that are very familiar to you, like the pressure, the temperature, the volume, the number of moles of each component, the mass of the system.
研究小组分析了微生物的DNA发现它们在这么高的温度下竟然没有断裂成一段段的碎片。
The team analysed DNA from the microbes and found that it had not been broken down into small pieces, as would be expected at high temperature.
目的:确定气体组分、气溶胶、放射性物质、温度、湿度和微生物6种污染要素在潜艇舱室空气质量评价中所占的权重。
Objective: to define the weights of 6 main influencing factors, i. e. gas components, aerosol, radioactivity, temperature, humidity and microbial pollution in submarine cabin air quality.
考察了活性组分含量和焙烧温度对催化剂活性的影响。
Influences of active component content and calcinations temperature were investigated.
本品粘度0w30和优良组分可使用于宽阔的温度。
Its 0w30 viscosity and its excellent ingredients make it suitable for all temperature ranges.
同时还测量了该燃烧室内气体平均温度和组分浓度分布。
Measurements were also conducted for the time-averaged gas temperature and species concentrations in the combustor.
挤压稳定化温度、保温时间、加热方法和抗氧化组分的活性能影响抗氧化组分的分解速率。
The rate of antioxidant degradation is affected by extrusion temperature, holding time, heating methods and the activation energy of the antioxidants.
采用蛋白质组分系统分离分析,研究了不同处理温度和时间对大米蛋白质组分的影响。
The study dealt with the effect of different temperature and time on the protein fractions of rice by the fractionation of protein.
结果表明,热处理温度和时间对样品中的蛋白质组分均有不同程度的影响。
The results showed that the temperature and time of the heat treatment had different effect on the protein fractions.
以一个理想二元精馏塔为对象,讨论基于塔板温度的产品组分估计问题。
To estimate the product composition for an ideal binary distillation tower based on tray temperatures is discussed.
在一定范围内改变体系的初始压力、温度和THF浓度,得到了各组分在气-水合物两相的摩尔分率和体系达到平衡时的压力。
The equilibrium pressure of system and the mol fractions of all components in vapor and hydrate phases were gained at different initial pressures, temperatures and THF mol concentrations.
重力对于炉膛内的流场、组分分布、温度分布都有较大的影响,对这种影响给出了合理的预测结果。
The gravity could also affect the flow field, temperature field and component distribution. The reasonable prediction result of the effects was given.
本文概括介绍了熔体结构的研究进展,着重讨论了熔体组分、温度及压力对熔体结构的影响。
After simple introduction the advance in silicate structure research, the influences of components, temperature and pressure on melt structure are discussed in detail.
根据包裹体研究恢复了包裹体形成时期流体的组分、温度和压力。
By studying fluid enclosure, ingredient temperature and pressure is evoluted when fluid enclosure had being formed.
引入软测量技术,成功地开发了基于电热连续结晶机槽内温度梯度,来实现槽内物料组分的测量。
This paper has successfully developed a intelligentized software measuring instrument of the materiel components in electrorefining successive crystallization machine by its temperature grads.
通过对多孔玻璃微珠组分对比,分相温度、时间的对比,酸溶时间的对比,得到控制多孔玻璃微珠最佳工艺。
Through the comparison of ingredient, the phase separation temperature and time, acid treatment time, we get the best technology of how to control the aperture of the porous glass microsphere.
讨论了镀液中各组分含量、温度及搅拌速度对化学镀镍的影响。
The influences of each component content in plating bath, temperature and stirring speed on electroless nickel plating were discussed.
发现压力和速度主要体现声特征,熵和组分主要体现流特征,而密度和温度既体现声特征又体现流特征。
It is found that the pressure and velocity disturbances run at sound speed, the entropy and components at flow speed, the temperature and density partly at sound speed, partly at flow speed.
建立了化工过程仿真培训系统建模中的流体网络模型,这是有温度和组分变化的流体网络模型。
A novel fluid network model of chemical industrial process is proposed for the modeling in training simulators. It's a fluid network model with temperature and composition change.
结果表明,PC/PET共混体系在熔融过程中有酯交换反应发生,反应程度与组分含量、熔融温度和共混时间有关。
The result shows, the ester exchange reaction did take place in PC/PET melting blend system, the extent of exchange reaction depends on content of the components, mixing temperature and mixing time.
随氧化温度的升高,各组分的变化更为明显。
The higher the oxidizing temperature, the more remarkable the change of constituents contents.
最后,本文对炉内速度、温度及组分分布等进行了详尽分析。
Finally, the speed, temperature and composition distribution in the furnace are analyzed in detail.
探讨了双组分单体的摩尔比,溶胀温度和时间,反应压力和时间等对接枝率的影响。
The effect of molar ratio of monomers, swelling temperature and time, reaction time and pressure on the grafting density are discussed.
杂质组分以及测量误差对温度补偿有哪些影响?
What is the impact of measurement error and impurity type on temperature compensation?
杂质组分以及测量误差对温度补偿有哪些影响?
What is the impact of measurement error and impurity type on temperature compensation?
应用推荐