她的牙齿不得不镶上特殊的粘固剂。
结果表明，磷酸锌粘固剂所获粘接力最大。
The result shows that zinc phosphate cement is the most retentive cement.
能够进行修理和系统改装而不需要使用液状粘固剂。
Repairs and system modifications can be made without the use of solvent cement.
将液状粘固剂加在管道上，确保对齐标志能够正确对齐。
Solvent cement components to pipe making sure alignment marks are properly matched.
结论：采用不同的粘固剂对FINESSE全瓷冠有影响。
Conclusion: Various luting cements have different effects on FINESSE all-ceramic crowns.
警告：不要让紫色底漆或液状粘固剂侵入阀门挡圈和隔膜区域。
Caution: Do not allow purple primer or solvent cement to migrate into the valve weir and diaphragm area.
用一块布，将管道和管件连接部位外部所有过量的粘固剂擦干净。
Using a cloth, wipe clean all excess cement from the exterior juncture of the pipe and fitting.
结果：玻璃离子粘固剂在整个实验期间都能释放一定量的氟离子。
Results: Both glass ionomer cements released measurable amounts of fluoride throughout the test period.
目的评价树脂改良型玻璃离子粘固剂粘接正畸托槽的临床使用效果。
Objective To evaluate the resin modified glass ionomer cement (RMGIC) for orthodontic bracket bonding.
警告：不要让紫色底漆或液状粘固剂进入接触到端口连接件的密封表面。
Caution: Do not allow purple primer or solvent cement to come in contact with the sealing face of the end connectors.
粘固剂中的多相磷酸钙成分以不同的速率再 吸收，使其由新骨适时代替。
The multiphasic calcium phosphate components in the cement resorb at different rates allowing he timely replacement by new bone.
在底漆干燥之前，液状粘固剂必须立即涂敷在底漆表面，并交互涂敷3层。
Solvent cement must be applied IMMEDIATELY to primed surfaces before the primer dries in an alternating 3-coat application.
牙科治疗和修复应用的粘结性材料包括粘固剂、合成粘结剂和复合树脂三大类。
Detal adhesive materials used in dental therapy and prosthesis can be divided into three groups, cements, synthetic bonding agents and composite resins.
粘固剂中的互连大孔可以实现血管形成、生长因子夹带、细胞移生和组织向内生长。
The interconnected macroporosity in the cement allows for vascularization, entrapment of growth factors, cell colonization and tissue ingrowth.
警告：要小心谨慎操作，避免紫色底漆或液状粘固剂流回到阀门内的隔膜或密封区域。
Caution: Exercise care to prevent purple primer or solvent cement from running back in the valve to the diaphragm or seating area.
目的研究含有丁香油的暂时粘固剂对二种新型牙本质粘结剂与牙本质粘结效果的影响。
Objective This study investigated the influence of eugenol-containing temporary cement on the efficacy of two relatively new dentin-bonding systems.
警告：要小心谨慎操作，避免紫色底漆或液状粘固剂流回到阀门内的隔膜或密封区域。
Caution: Do not allow purple primer or solvent cement to migrate into the valve weir and diaphragm area.
有必要采用底漆来渗透和软化管道和管件承插端口表面，使得液状粘固剂能够完全粘结。
Primer is necessary to penetrate and soften both pipe and fitting socket surfaces in order for the solvent cement to properly bond.
目的：比较树脂改良型玻璃离子粘固剂和传统型玻璃离子粘固剂对正畸带环的粘接效果。
Objective: To compare the effect of resin-modified glass ionomer cement and conventional glass ionomer cement on orthodontic band cementation.
用传统玻璃离子粘固剂修复根管口呈喇叭形残根与不作修复的对照组之间没有显著性差异。
However, there is no obvious difference between non-repaired and residual dental root groups repaired by traditional glass ionic adhesives.
深龋经玻璃离子粘固剂垫底后，能明显减轻复合树脂对牙髓的刺激作用，从而护髓效果更佳。
Deep caries based by the glass ions cementation agent, could significantly reduce composite resin pulp stimulation to protect pulp, and better effect.
这个标准涵盖采用液状粘固剂进行底漆连接的要求，适用于PV C管道和连接件连接化学熔化。
This standard covers the requirements for primers to be used in conjunction with solvent cement for the chemical fusion of PVC pipe and fitting joints.
连接到供电设备进口端的管道系统要用软管夹和缓冲接头或液状粘固剂紧固到附着的配合接头上。
X5.4.2 Piping connections to the inlet side of the power unit are fastened with hose clamps and flexible couplings or solvent cemented to a mechanically attached adapter.
对于真活接球阀、止回阀和隔膜阀，在上底漆和粘固剂连接之前，先拆卸活接头螺母和端口连接件。
On True union Ball, Check and Diaphragm valves, remove union nuts and end connectors before priming and cementing connections.
连接部位至少在2分钟之内不能处理或移动，只有在粘固剂经过一段规定时间后连接部位才能够进行处理。
The joint must not be handled or moved for a minimum of 2 minutes, after which the joint must be handled carefully until the cement has gone through a set period.
探讨并记录护髓垫底材料玻璃离子粘固剂与自凝氢氧化钙联合磷酸锌水门汀治疗后牙深龋的疗效并进行比较。
Explored and recorded the curative effect of protecting pulp bottom material glass ion curing agent and self-congealing hl joint zinc phosphate cement posterior teeth with deep caries repaired.
注意：所有阀体带固定承插连接端口的阀门必须安装在开阔的地方，使得粘固剂蒸汽能够顺畅蒸发而不会损坏内部部件。
CAUTION: all valves with fixed socket end connectors in the body must be installed in the open position to aid in evaporation of solvent vapors which can attack internal components.
液状粘固剂的特定类型、等级和坚固性的选择应该考虑管道类型、口径、安装条件以及粘固剂与系统流体介质的化学兼容性。
Selection of specific type, grade and consistency of solvent cement should take into account pipe type, size, installation conditions and chemical compatibility of cement and system fluids.
下表以美国材料实验协会ASTMD 2855“聚氯乙烯（PVC）管道和管件液状粘固剂连接标准规程”有关标准制定。
The following table is based on the guidelines of ASTM D 2855, "Standard Practice for Making Solvent-Cemented Joints with Poly Vinyl Chloride (PVC) Pipe and Fittings".
在连接单个管套接阀门的固定端口时，将球体放置在开启位置，使得阀内部件能够得到干燥并避免底漆或液状粘固剂接触到阀内件。
When joining the fixed end of a single union valve, place the ball in the open position to allow for proper drying and to avoid primer or solvent cement contacting internal components of the valve.
应用推荐