该文采用等效电路法研究了容栅传感器的数学模型。
This paper uses the equivalent-circuit way to study the mathematical model of capacitive grate transducer.
所得到的结果与一般的等效电路法获得的结果完全一致。
The results are agreement with that obtained from general equivalent circuit method.
本文用等效电路法对五臂混合环进行了分析,并得出两种改进方案。
Analysis by the use of equivalent circuit method is made for the five-arm ring, and two ways to improve it are found.
多谐振腔宽带换能器的理论分析采用经典等效电路法与有限元法相结合的方式。
Equivalent circuit method and finite element method have been studied for theoretical analysis of the resonator transducer.
本文通过三种负反馈类型的具体例子同时介绍了两种分析方法,即方框图法和等效电路法。
In this paper, two methods of analysis, the block diagram method and the equivalent circuit method, have been introduced simultaneously with specific examples of three negative feedback types.
文中采用等效电路法计算了单交叉梯形慢波电路的匹配特性。计算结果与实验测量基本一致。
Matching characteristics of single staggered ladder slow wave circuit are calculated by eguavelent circuit method in the paper.
采用电化学阻抗法研究支撑液膜膜液的流失行为,并采用等效电路法分析得到的交流阻抗图谱。
The losing behavior of liquid in supported liquid membranes (SLMs) was studied by electrochemical impedance spectroscopy (EIS) method in this paper.
针对高损耗衬底,基于复镜像理论,结合部分元等效电路法,建立了一种新的片上互连线物理模型。
A new physical model for on-chip interconnect on high lossy substrate is proposed based on complex image theory and PEEC.
应用微变等效电路法,对具有同型和异型结构的两类复合管的电路特性,进行了比较系统的分析和研究;
The micro-variation equivalent circuit method is used to analyse and study the circuit features of the multiple unit tubes with the isomorphous or heterogeneous structure systematically.
以日本神钢电机公司制造的PM型(永久磁铁型)SLPMU-025A为样机,利用等效电路法对其效率特性进行了解析计算。
Taking PM type(the permanent magnet model) SLPMU -025A motor as an example , this paper makes analytical calculation of its efficiency characteristics by the means of equivalent circuit.
利用横向谐振法结合奇异积分方程技术,导出了具有快速收敛特性的不连续性等效电路参量计算公式。
A formulation for the equivalent circuit parameters of the discontinuities with superior convergency is derived by the transverse resonance method with the singular integral equation technique.
目前PD P放电单元工作特性的CAD研究方法主要有两类,流体力学模型法和等效电路模型法。
There are two main kinds of CAD method to study the property of PDP cell now, the fluid model and the equivalent electric circuit model.
本文尝试用感应电动机的T型等效电路和能量比法,分析三相感应电机的工作特性。
The author tries to analyze the operational characteristics of three phase induction motor using the T-type equivalent circuit of induction motor and the energy ratio method.
依据等效电路的节点导纳方程,采用弦截法分析了自励感应发电机的稳态特性。
According to the nodal admittance equation, the analysis of steady state performance of self excited induction generators is carried out by using the secant method.
本文依据传输线理论、微波网络理论、天线原理、矩量法和矩阵理论等,建立起基本传输线方程和四种等效电路模型,为使用集总电路迭代近似方法建立了基础。
In this paper, basic transmission line equation and four kinds of lumped-circuit model were constructed according to transmission line theory, microwave network, antenna theory and matrix theory.
最后本文详细介绍了高阶电流模式滤波器的系统方法,阐述了等效电路替代法和多环反馈法,给出了设计的具体步骤。
In the last section, as the design methods of high-order current-mode integrated filters, the equivalent circuits and the multi-loop feedbacks are systematically expounded.
利用移源法讨论耦合电感元件的消互感问题,具有消互感后的等效电路的优点,并可得到消互感方法的适用条件。
Based on the method of source transfer, this paper discusses the decoupling inductor. The method can easily present a decoupling circuit and give the usable conditions of the decoupling inductor.
本文提出了一种可以应用于由交流阻抗数据计算等效电路元件数值的数据拟合方法-随机单纯形法。
A random simplex method, which could be used to evaluate the value of components in equivalent circuit from impedance data, is proposed. It is a combination of Monte Carlo method and simplex method.
采用加权残余法建立了静电驱动梁单元的节点法模型,在HSPICE中构建了相应的等效电路模型。
A nodal analysis model of electrically actuated microbeams was developed based on a weighted residual method.
采用加权残余法建立了静电驱动梁单元的节点法模型,在HSPICE中构建了相应的等效电路模型。
A nodal analysis model of electrically actuated microbeams was developed based on a weighted residual method.
应用推荐