最后对基于现场可编程门阵列(FPGA)的硬件电路、VHDL语言程序设计及调试方法进行了讨论。
Lastly, the hardware circuit, VHDL program design and debugging methods based on FPGA are discussed.
优化方法的选取及编程研究，程序调试及运算。
Choosing of optimization method, programming research and procedure debugging and operating are discussed.
本文介绍了ZPW- 2000 A无绝缘移频自动闭塞工程调试中实验程序及实验方法。
The paper gives an introduction to the test procedure and method for construction debugging of ZPW-2000A non-insulated frequency-shift automatic blocking equipment.
本文介绍了自动化驼峰工程调试与开通的程序及对静态和动态试验重点项目的内容、方法。
This paper introduces the procedure of adjusting and opening and the contents and method of key item of static state and dynamic testing of automation hump engineering.
文章的最后又花了两章的篇幅分别介绍了程序代码烧写方法及重要功能电路修正和调试方法。
At last, two chapters about the FLASH programming and the debugging method are introduced. Now, most of functions of the system has been accomplished.
论文介绍了整个硬件和软件的测试平台、驱动程序的调试方法、驱动程序的测试流程，并给出了测试结果及测试结论。
This dissertation briefly introduces the test platform for the hardware and software, the method of debugging the driver, as well as test course, and gives the result of the test.
安装调试前，供方现场服务人员向业主方及需方技术交底，讲解和示范将要进行的程序和方法。
E. before installation, for field service personnel to the owner and the demand side technology gives the low-down, explanation and demonstration to be carried out by programs and methods.
本文还细致地描述了利用单片机控制的软件流程、程序设计及调试，罗列了防盗报警器误报的分析及解决方法。
This paper also careful to describe the microcontroller control software process, program design and commissioning, listing the alarm system misstatement analysis and solution.
本文还细致地描述了利用单片机控制的软件流程、程序设计及调试，罗列了防盗报警器误报的分析及解决方法。
This paper also careful to describe the microcontroller control software process, program design and commissioning, listing the alarm system misstatement analysis and solution.
应用推荐