实验结果表明，该算法所获得的仿真结果图像接近真实葫芦烙画图像效果。
The comparison of the proposed method with the Poission image editing algorithm shows that the simulation image effect of the proposed algorithm is closer to the real gourd pyrography image effect.
通过在鼠笼式电机传动系统参数辨识中应用的仿真结果，验证了该辨识方案的正确性。
The validity of the derived identify scheme is proved by the simulation results of HNN based asynchronous motor drive system parameters' identification in consider of sensors' characteristics.
通过与BP算法的仿真结果比较分析，发现该算法稳定性好，收敛速度快，预测精度高。
Through the analysis of simulation results as compared with BP algorithm, this algorithm has the advantages of fine stability, fast convergence speed and high precision.
通过与BP算法的仿真结果比较分析，发现该算法具有稳定性好，收敛速度快，预测精度高的特点。
According to the analysis of simulation results compared with BP algorithm, this algorithm has the advantage of the fine stability, fast convergence speed and high precision.
针对电子膨胀阀步进电机驱动方式和本文的仿真结果，应用增量式PID和模糊控制方法进行实验分析。
PID and Fuzzy controllers are using in the experimentation based on the simulation results of the PID, fuzzy and fuzzy self-tuning PID controllers and the driven method for EEV.
二区域四机的仿真结果证明施加这种控制策略的电力系统稳定器抑制振荡能力更强，进入稳态时间更短。
Simulation results in two-area four-machine proves that power system stabilizer under this strategy has stronger capacity of checking shocks and becomes stable more quickly.
将改进后的车身模型的仿真结果与改进前进行对比，结果表明达到了提高吸能特性和碰撞安全性的目的。
Finally, the simulation results before and after car modeling modification were compared, which indicated that modification can improve the absorption property and crash safety.
建立了IGBT电路仿真模型，给出了IGBT功率损耗与开关频率和栅极电阻阻值之间关系的仿真结果。
The circuit model for IGBT simulation is provided. The relationships between IGBT power loss and the switch frequency and between IGBT power loss and grid resistance are presented.
实际电网负荷预测的仿真结果验证了文中提出的相空间相关邻近点的选择方法与峰谷荷修正思想的有效性。
The simulation results of practical load forecasting show that the proposed method to select reference points and peak-valley load correction are more effective.
通过对基于该方法设计的BP网络离线训练后所进行的仿真结果分析与比较，使其有效性和可行性得以验证。
After the designed BP network be out-line trained based on the method, its efficiency and feasibility have be proved by comparing and analyzing simulated results.
系统为用户提供大量的、可视化的仿真结果，从而协助他们完成飞行方案的设计、验证、论证、筛选和确定。
The system can give user plentiful and visually result of simulation; consequently help them accomplish the design, validation, argumentation, filter and decision of flight scheme.
根据平稳随机过程理论，利用白噪声驱动成形滤波器，获得海浪的干扰模型，并得到了令人满意的仿真结果。
Using white noise to drive shaping filter, the interference model of wave is acquired on the basis of stable stochastic process theory, and the simulation results are satisfactory.
实验表明，上述方法将基于传感器测量到的真实火灾数据动态反馈至仿真系统中，获得了更可信的仿真结果。
The experimental results show that the framework can track the dynamically changing fire front based on fire sen- sor data, thus, it provides more aecurate predictions.
在T形和S -曲线速度轮廓运动模式下，模型的仿真结果与理论分析一致，验证了该方法的合理性和有效性。
The reasonability and validity of the method was testified by the coincidence of the simulation and the theory analysis under the motion mode of trapezoidal velocity and S-velocity profile.
利用包含原理，提出一种分散L QG控制的设计方法，并给出利用该方法对距离偏差控制进行设计的仿真结果。
A decentralized LQG control scheme is proposed by using inclusion principle. The simulation results are given by this method for this distance bias control design.
通过计算机仿真，文中还给出了基于传统控制理论的伺服跟踪系统和用神经网络构建的伺服跟踪系统的仿真结果。
Then simulation of servo system based on both traditional control theories and neural network method is carried out separately and result of comparison is given.
根据以上设计，结合导引头模型、复合控制系统模型、弹体运动学模型、目标机动模型，给出上述设计的仿真结果。
Finally, present the simulation result of above design combining seeker handing-off model, compound control system model, projectile body kinematics model and target maneuver model.
以MATLAB软件为平台对半主动控制下的起落架着陆过程进行仿真，并与被动控制下的仿真结果作了分析对比。
The semi-active control landing gear model was simulated trough the Simulation soft MATLAB and the simulation results were in contrast with the results of passive control model.
两种模型的仿真结果与工艺试验结果比较表明，双椭球形热源模型比高斯热源模型更适合双丝焊的三维有限元分析。
The comparisons between the simulated results of two models and experiments show that double ellipsoidal model is better than Gaussian model on three-dimensional analysis.
基于双离合器式自动变速器整车系统模型和评价系统的仿真平台，给出了起步品质和换档品质优化前后的仿真结果。
Give the simulation result about starting quality and shift quality after the optimization which based on the vehicle model and evaluation system simulation platform of DCT.
通过计算机仿真，文中还给出 了基于传统控制理论的伺服跟踪系统和用神经网络构建的伺服跟踪系统的仿真结果。
Then simulation of servo system based on both traditional control theories and neural network methoe is carried out separarely and result of comparison is given.
通过整车试验数据与相同工况下的仿真结果对比，表明所述模型可以以很好的精度反映汽车在各种工况下的动力学性能。
Comparing the test result and simulation result and simulation result in same maneuver, it is proved that the presented model gets vehicle dynamic performance by simulation in high precision.
用该方法建立的APDL程序，只需输入材料及焊接参数，即可通过ANSYS分析获得与实际焊接相吻合的仿真结果。
After the material and welding parameters being inputted, the APDL program, which is programmed with this method, can lead to simulate the results tallying with practical welding by ANSYS analysis.
文中给出了全桥整流驱动额定电压情况下不同开通角时合闸过程及电压变化时的仿真结果，并对仿真结果作了细致分析。
Simulation results of making process for different phase angles of flow driven by full bridge rectifier are given and analyzed at rated and variable voltages in detail.
用该方法建立的APDL程序，只需输入材料及焊接参数，即可通过ANSYS分析获得与实际焊接相吻合的仿真结果。
After the material and welding parameters being inputted, the APDL program, which is programmed with this method, can lead to simulate the results tallying with practical welding by ANSYS a...
针对上海地区某一商务楼及其空调系统进行了仿真试验，对系统正常启动和提前启动两种控制策略的仿真结果进行了比较。
An office building in Shanghai is tested with two operation strategies of normal and pre-cooling respectively. The results show that the capacity of building can be used for energy storage.
主要讨论了并联式混合动力电动汽车的控制策略，详细阐述了控制策略的依据以及控制过程，并给出了控制策略的仿真结果。
The control strategy for a parallel hybrid electric vehicle is studied, the base of control strategy and the control course are expatiated, finally the simulation result is given.
首先，为了找出目标跟踪软件中的对象，本文简要叙述了应用比较广泛的几种典型的目标跟踪算法，并给出了相应的仿真结果。
First, to get the object in the target tracking software, several widely used typical target-track algorithm are briefly mentioned with some simulation results.
分析了多音传输系统的信道容量，在两种比特分配算法的基础上提出了一种简化的比特分配算法，并给出了不同信道下的仿真结果。
The channel capacity of multitone systems is analyzed. Based on two bit allocation algorithms, a simple bit allocation algorithm is proposed, and simulation results over different channels are given.
从模型的仿真结果我们可以预计到，随着劳动力市场中高学历工人比例的逐渐提高，高学历工人和低学历工人的失业率均有提高的趋势。
From the simulation result of model, we may prognosticate that the unemployment rates of two types of workers also increase as the ratio of workers with higher degree certificate increases.
应用推荐