采用物品进盒不到位自动停机和主传动电机过载保护装置，适用更安全可靠；
Automatic stopping is available when the material boxing is not in place, and the main driving motor overload protection device is used, so that the machine is safer and more reliable.
本产品配用电源必须符合风机铭牌标示的额定参数；电机过载保护装置请用户自行配置。
Power should be conformed with the rated parameter of blower Nameplate; overload protection device of motor is equipped by user.
检查电器箱接线及紧固情况，调整延时继电器及过载保护器，接通电路，试验电机转向，选择合适规格的保险丝。
Check the electrical box wiring and tighten the situation, adjust delay relays and overload protector, connect circuits, test motor steering, select the appropriate specifications of the fuse.
增加外部过载保护是防止电机烧毁的有效手段，如热继电器保护。
Increase external overload protection is to prevent motor burned effective means, such as thermal relay protection.
无带式，不需要调整或替换具有直接驱动器，双手动热过载保护电容电机。
No Belts to Adjust or Replace Features a direct-drive, dual-capacitor motor with manual thermal overload protection.
每台机器均配有保护行程开关，为维修、保养增加一份安全系数。且装有热过载继电器，保护电机。
Every machine is equipped with protect travel switch in order to increase safety coefficient for repairing and maintenance. It also has thermal overload relays to protect the motor.
单相电容运转电机配置热过载保护。
Single phase capacitor run motor with thermal overload protection.
以热保护为研究对象，充分考虑了电机的热积累现象，通过求解热平衡微分方程的方法，给出了新的电动机过载保护判据。
Based on the method of solving heat balance differential equation, a novel over-load protection criterion for electric motor is presented in the paper considering the heat accumulation of motor.
利用这种特性，可以设计出不同于已往过载保护方式的新型风力发电机。
By use of this feature we can design new type wind-generator different from existing overload protection means.
电机设有过载保护开关，操作简单，安全可靠，进料部位采用密封设置，防止散料非常机械外；
Motor with overload protection switch, easy, safe and reliable feed set or sealed to prevent the bulk material outside the very mechanical;
过载保护器是否脱开：（图6右）待冷后自动复合，检查电机是否发热。
Whether the over loading protector is loosed or not: (the picture 6 right) after cool then will be restoration automatically, and check the motor whether is hot or not.
过载保护器是避免压缩机电机烧毁的一个关键部件。
Overload protectors are key parts that protect compressor motors from damage.
轧制力矩过大是轧机主传动系统传动轴断裂的主要原因，传统的电机电流过载保护方式不能真实反映轧机主传动系统扭矩的动力学特性。
The breakdown of transmission shaft in the main drive system is due to too high roll torque. Overpower protection mode of motor current does not reflect the true dynamic character of roll torque.
当电机负载过载或堵转时，采用电流截止负反馈环节可保护电机和驱动器；
Motor and inverter can be protected by the current cut-off negative feedback when motor is overload or locked-rotor.
在高温、高电流运行的情况下，单相电机都受到一个内置式、自动重置热过载保护装置的保护。
Single phase motors are protected against both high operating temperatures and high current by a built in, automatically resetting thermal overload.
在运转过程中，避免因物料过长或超载引起的设备卡壳或电机短路，而导致减速电机的损坏，建议用户加装过载保护装置。
During the operation, if the conveyor is overloaded, the device may get stuck of the electric machine. To avoid it, it is suggested that a protection device for overload should be installed.
本文阐述上仰水平轴风力发电机一种过载自动保护特性的工作机理及其应用价值。
This article expounds both the working-mechanism and the application value of the overload auto-protection feature the small Angle elevated horizontal axis type wind-generator.
船舶发电机组过载保护试验、并车试验、逆功率和逆电流保护试验；
Overload protection, and vehicle test, reverse power and reverse current protection test for marine generator.
过载时，内、外磁转子相对滑脱，对电机、泵有保护作用。
Overload, inside and outside magnetic rotor relative detachment, motors, pumps with a protective role.
接地保护以及电机过载运行保护。应用于工业控制设备的数量安排、保护设备的等级和设置与加拿大电气法规第一部分相一致。
The number arrangement, and ratings or setting of protective devices used in industrial control equipment are in accordance with the requirements of the Canadian Electrical Code, Part I.
接地保护以及电机过载运行保护。应用于工业控制设备的数量安排、保护设备的等级和设置与加拿大电气法规第一部分相一致。
The number arrangement, and ratings or setting of protective devices used in industrial control equipment are in accordance with the requirements of the Canadian Electrical Code, Part I.
应用推荐