轴带发电机负荷测验和航行时效用测验。
Load test for shaft generator and function test on sea trial.
轴带发电机负荷试验和航行时效用试验。
Load test for shaft generator and its function test on sea trial.
轴带发电机负荷试验和航行时效用试验。
Load test for shaft generator and its function test on sea trial. Interlocking reliability test.
此时电机负荷急剧增加。
此时电机负荷急剧增加。
介绍了一种用于多传动点，带同一负载时控制传动点电机负荷分配的装置。
A device which is used to control load distribution of the multipoint drive is presented.
电机负荷过大，想购买的客户因为电机负荷无法满足，放弃购买计划2。
The electrical engineering carries big, want the customer who purchase because the electrical engineering buhen can't satisfy, abandonning to purchase the plan 2.
以大功率GM系统为对象 ，提出了电枢电流模糊反馈和电机负荷均衡控制的问题。
The problem about the Fuzzy feedback of armature current and load balance control is studied, taking the G M high power system as the object.
考虑到轧制负荷很不均匀，为了均衡电机负荷，减少电机的容量，在减速机和电动机之间加有飞轮。
Taking into account the rolling load is uneven, to balance electrical loads and reduce the electrical capacity slowdown in the increase between a flywheel and electric motors.
计算结果证明了基于改进BP神经网络算法建立的双馈水轮发电机负荷优化调节特性模型的有效性。
The calculation results prove that the model for load optimal regulative characteristic of doubly fed hydrogenerator based on improved BP neural network algorithm is effective.
介绍了一种用于多传动点，带同一负载时控制传动点电机负荷分配的装置。该装置在多传动点负荷分配上实现了自动检测、自动控制、故障警示等自动功能。
A device which is used to control load distribution of the multipoint drive is presented. It has some functions such as automatic check, control, fault warning etc.
这一标准设计是基于一个由固定电机带动的传动带托台自动机械系统，适用于大部分的包装应用，而不需要考虑规划和产品负荷。
The modular design is based on a belt-driven gantry robotic system with fixed motors that can be customized to fit most packaging applications, regardless of layout or product load.
并安装了超载保护，即保证电机及油泵负荷的压力开关。
And installed the overload protection, namely to ensure that motor and pump load pressure switch.
水轮发电机组的负荷控制主要通过对调速器的控制来实现的。
Load regulating of power generator is always finished through the regulating to the regulator.
介绍了卷径计算、线速度测量、张力控制、同轴串联双电机控制、上下辊负荷平衡控制方法。
The paper introduces some methods for diameter compute, velocity measurement, tension control, the same shaft series twice motors control and load balance control of twin drive roll.
SCR电驱动钻机的柴油发电机组所使用的柴油机，在低负荷运行时结碳严重，直接影响钻机的可靠性和经济性。
Carbon-laydown occurs seriously in diesel engines on SCR electric drilling rigs during underload Performance, which affects the reliability and efficiency of the rigs.
主发电机(应急发电机)负荷及特性试验。
Load and performance test for main generator (emergency generator).
主发电机(应急发电机)负荷及特性测验。
Load and performance test for main generator (emergency generator).
随着负荷的增长，发电机组的规模也在不断的增加。
Along with increases in load growth, there have been continuing in creases in the size of generating units.
热模型保护是电动机在启动和运行期间的主要保护，需要根据电机参数以及负荷特性进行整定。
According to comparative analysis of the simulation results, thermal model protection can match the characteristics of the operating motor and guarantee the motor runs safely and reliably.
这样可提高电泵工作效率，节电，避免电机超负荷作业，延长使用寿命。
This will increase the pump efficiency, energy saving, to avoid electrical overload operation, to extend the service life.
AGC控制单元送出信号至受其控制的发电机组，按标准频率和联络线负荷的要求来增大和减少负荷。 收藏。
The AGC unit sends signals to the generating units under its control to raise or lower load as required to correct frequency and tie-line loadings.
这样可提高电泵工作效率，节电，避免电机超负荷作业，延长使用寿命。
This will improve the efficiency of pumps, power-saving, to avoid electrical overload operation, to extend the service life.
对一个三相系统模型进行仿真，分析了感应电机动态负荷特性对系统电压稳定性的影响，并给出改善电机节点电压性能的措施。
The paper simulates a three-phase system, analyzes influence of induction motor dynamics on voltage stability, and gives methods to improve voltage stability of induction motor nodes.
研究测轴承支承力法对大型汽轮发电机组轴承负荷在线监测的可行性。
It studies also the feasibility of this way for on-line monitoring bearing load of turbine generators.
目前的潮流校正措施都是从逻辑距离、优化、比例的角度进行负荷削减，而未考虑故障前发电机对负荷的分配关系，这不太合理。
So far, all load-shedding actions are based on logic distance, optimization or some proportion, but it is not reasonable because they don't consider the relationships between loads and generations.
ANN控制方法能使发电机在负荷变化、甩负荷运行、电网故障以及发电机故障等各种工况条件下，发电机端电压保持稳定。
ANN control strategy can make the voltage of generators stable in the course of load changed, load uninstalled, electrical network fault and generator fault and so on.
必须知道未来的负荷以准确确定何时必须增加新的发电机。
The future load must BE known to determine accurately when another generator must BE added.
发电机组的故障趋势分析经常受到负荷变化的影响。
The trend analysis of faults in generator sets is often influenced by load variation.
发电机组的故障趋势分析经常受到负荷变化的影响。
The trend analysis of faults in generator sets is often influenced by load variation.
应用推荐