输入方式：电机直联、电机皮带联接或输入轴、联接法兰输入。
Input Method: electrical Direct, electrical connection, or a belt input shaft, flange type connection.
曲轴皮带轮、水泵皮带轮、空调皮带轮、电机皮带轮、张紧轮、减震皮带轮及怠速轮的生产及安装。
Our products mainly include crankshaft pulley, water pump pulley, air-conditioner pulley and electric motor pulley, tensioner pulley, damping pulley, Idler assy pulley.
优质电机及皮带的选用，使用更可靠。
Selection of high-quality motor and belt use and more reliable.
拆开机器后部上、下板，观看内部电机、皮带、压缩机等部件得否有因运输而引起的松动。
Remove the upper and lower board in the rear part of machine to check the motor, belt, compressor and other components for looseness which may occur during transportation.
车后轮和电机连接的是用皮带， 很有趣。
LD- 120五辊冷轧管机的主要传动执行部件有主电机、皮带传动系统、回转送进箱、中间床身、主传动系统。
The main drive actuating parts of LD-120 five-high tube cold rolling mills include the main motor, belt driving system, rotary feed-in case, intermediate bed and main driving system.
飞轮由电机和三角皮带驱动，飞轮积聚地能量仅在曲柄转动地小部分范围，即材 料变形地时候才释放出来。
The flywheel which is driven by an electric motor and "V" belts stores energy that is used only during a small portion of the crank revolution namely during deformation of the material.
主轴采用皮带或齿轮变速，工作台采用滚珠丝杆，步进电机；
We use belt or cogwheel to regulate speed for the main shaft , ball lead screw and stepping motor for operating plat form .
本机由电机作动力驱动，经三角皮带传动减速机，带动工作转台作顺时针方向旋转。
The machine is motor driven. The turntable rotates clockwise through a triangle belt transmission reducer.
驱动采用变频电机调速控制，进口同步皮带传动，恒功率、恒扭距输出，平稳可靠。
Feeding drive is controlled by frequency conversion motor and synchronized with import conveyor belt. Power output and torque is steady and reliable.
在安装新皮带时，要用手动的方式使电机向驱动轴移动而使所有皮带均处于滑轮槽内。
When the belts have been located in the belt pulley grooves, moves the drive motor away from the driven shaft so that uniform teensioning of the belts is achieved.
汽车用交流发电机的皮带轮、定子线圈、整流器的故障率相对较高，本文给出了其故障的处理对策，以延长其使用寿命。
The belt sheave, stator winding and rectifier of the vehicle alternator have a rather higher breakdown rate. Therefore, this paper gave out their solutions to extend the alternator life.
发电机传动皮带的状况和张力。
测速传感器选用步进电机测速形式，测速传感器向秤重仪表发出系列脉冲信号，每个脉冲代表皮带行程的一个单位，脉冲频率和皮带速度成正比。
Choose stepping motor speed sensor speed form, to speed sensor weighed instrument issued a series of pulses, Each pulse represents one of the units.
无皮带轮的发电机运输时得有一个薄纸板制作的管或是安装上垫圈以防运输时转子损坏内部零件。
All alternators that are shipped with out pulleys are to have a cardboard tube or spacers installed to as to prevent the rotor from damaging internal components during shipping.
旧巴恩斯是皮带驱动一电机出现的旧不够，已建成由Tom爱迪生自己！
The old Barnes was belt driven by an electric motor that appeared old enough to have been built by Tom Edison himself!
采用一种无电刷的直流伺服电机来传动用于精确传动积极式喂纱器的皮带。
A brush-less DC servomotor is used to drive the belt that drives the positive yarn feeders accurately.
发电机传动皮带张力的调整应该适度，既不能过松也不可过紧。
The tension of generator driving belt must be adjusted correctly; it can not be too loose or too tight.
离心式永磁直流发电机把皮带轮与离心式转子设计为一体，磁场得到了充分利用，降低了成本。
Put pulley and rotor of the centrifugal together and made full use of magnetic field, the centrifugal permanent-magnet direct-current generator reduces the cost.
皮带过松会影响水泵、交流发电机、动力转向以及空调等工作。
Loose belts affect the water pump, alternator, power steering, and air conditioner.
伺服皮带应张紧无松动，如有变化应立即调整伺服电机固定座位置。
The servo belt must be tight, when it's found loosened, adjust the position of the servo-actuator immediately.
发电机通常装在发动机机体的一侧，由发动机风扇皮带来驱动。
The generator is usually mounted on the side of the engine Block. It is driven by the engine fan belt.
这根皮带一般也驱动交流发电机工作，皮带的张紧度通过在支座上摆动发电机的位置来进行调整。
Usually the same belt drives the alternator, and belt tension is adjusted by swinging the alternator on its mounting.
在皮带轮同电机机壳端盖之间保留供密封风道用的密封板穿过的电机轴空隙位。
A motor shaft gap used for a sealing plate for a seal air channel is left between the belt pulley and the end cover of the motor shell.
此电机的电机轴两端伸出分别同一风叶和一皮带轮通过键槽和键相 配接固定；
Two ends of the motor shaft of the motor respectively extend to match and fix with an impeller inducer and a belt pulley through a key slot and a key.
结合实例，对皮带机驱动机构的电机、减速器、耦合器和支座等主要部件进行了选型设计。
Based on the instance, this article introduces some designs of motor, reducer, bearings and other major components of the belt driving mechanism.
发动机风扇通常安装在水泵轴上，由驱动水泵和发电机的同一条皮带驱动。
The engine fan is usually mounted on the water pump shaft and is driven by the same belt that drives the pump and the generator.
其成型设备包括：电机、皮带轮、螺旋绞龙推进器、料斗、活塞驱动系统、活塞、锥模、凸模、法兰、机座、推杆、成型筒等。
The forming apparatus includes motor, belt wheel, spiral propeller, material bin, piston driving system, piston, mold, pedestal, forming barrel and other parts.
机器设备应接地，电线应可靠绝缘，并装在蛇皮带内，经常检查电机接线是否磨损和漏电。
The machine should be grounded parts the electrical wire should be insulated and installed in the snakeskin annultions. Check out whether the motor is abrasion or creepage.
机器设备应接地，电线应可靠绝缘，并装在蛇皮带内，经常检查电机接线是否磨损和漏电。
The machine should be grounded parts the electrical wire should be insulated and installed in the snakeskin annultions. Check out whether the motor is abrasion or creepage.
应用推荐