该传感器输出一个相应于石油含水率的电压信号，由此可测量出原油的含水率。
It can provide a voltage output signal in accordance with the percentage of water in crude oil.
实验发现压阻型压力传感器的压力输出信号与外加电压并不是线性关系，存在着灵敏度电压非线性。
That the pressure signal is not linear with input voltage for pressure sensors found in experiments. The phenomenon is called electric nonlinearity for sensitivity.
这种将传感器输出转换成电压信号，并与系统的其它电路相连接的过程，称为信号调理。
This process of converting the transducer output into a voltage signal which can be connected to the rest of the system is called signal conditioning.
PT100温度传感器和精密电阻构成的电桥测量电路输出微弱的电压信号。
The electrobridge measurement circuit, which consists of PT100 temperature sensor and precise resistance, outputs slight voltage signals.
该传感器有32个10位数字低电压差分信号传输(LVDS)输出，使超过1在低功耗和低噪音标准工业协议的图像数据传输。
The sensor has 32 10-bit digital low Voltage Differential Signaling (LVDS) outputs that enable transfer of image data over a standard industry protocol at low power and low noise.
试验结果表明：这种粮食水分传感器的输出电压与粮食水分之间呈良好的线性关系，可满足粮食水分在线检测的要求。
The preliminary experimental results indicate that the output voltage of the sensor is good linear with the grain moisture and can fulfill the online moisture measurement requirement for grain.
分析了一般电桥电路作为传感器其输出电压产生非线性误差的原因。
The reason of nonlinear error caused by output voltage in common electric bridge as the sensor is analyzed.
传统的导热系数测量仪器需要不断测量温度传感器的输出电压，记录时间，工作量大，重复性工作多，难以推广应用。
Since time and output voltage of temperature sensor must be repetitiously recorded, using conventional instruments to measure thermal conductivity is a tough task and can not be generalized.
利用集成运算放大器的特点，设计了输出电压无非线性误差的电桥电路传感器。
Using the characteristic of integrated operational amplifier, an electric bridge circuit sensor without nonlinear error in its output voltage is designed.
静态试验研究表明：木材的含水率能引起电涡流传感器的输出电压下降，但下降的幅度甚微；
Static experimental test shows that wet wood can make tiny decline to the output voltage of eddy current sensor.
传感器的输出为频率量和电压量，可与监测系统联接。
The output of sensor is frequency and voltage. It can be direct connect with monitoring system.
介绍了差动变压器式传感器的结构和输出特性，详细分析了其零残电压产生的原因，以及对测量系统非线性和灵敏度的影响。
The producing reason of residual voltage at zero point and its affection to the nonlinear quality and sensitivity of measurement system were analyzed extensively.
多功能芯片ADT14既是一种输出逻辑电平控制信号的多点温度监控器，又是一种输出模拟电压信号的温度传感器，可广泛应用于各种嵌入控制系统中。
The multi-functional chip ADT14 is a kind of multi-point temperature monitor of outputting logic level control signal, It is also a kind of temperature sensor of outputting simulated voltage signal .
采用新型薄膜铂温度传感器设计了多点温度检测系统，使用正反馈型线性校正电路使输出电压与温度成线性关系，从而提高了检测系统的测量准确度。
The linearity correction circuit of positive feedback can make the output voltage be linear with the temperature, so the measurement accuracy of the system is improved.
这个传感器的电路模拟输出电压发送到3迟滞比较器。
For this the analog output voltage of the sensor circuit is sent to 3 comparators with hysteresis.
磁环式检波器是将机械震动的速度信号转换成电压信号输出的一种电磁传感器。
The magnetic loop geophone is a type of electromagnetism sensor which transforms mechanistic liberate into electric signal.
建立传感器的动力学方程并求得解析解，得到输出电压和传感器敏感质量摆角的关系。
The dynamics equation of sensor is constituted and the equation's solution is got. The relationship of output voltage and pendular angle of the sensing mass is gained.
压电传感器长度增加，输出电压也会有所增加，并且这一变化会随压电片的厚度减少而减小。
Meanwhile the change of the voltage by the change of the length will decrease when the thickness of the piezoelectric layer decrease.
某角速度传感器的输入与输出成近似线性关系，测量输出的电压值即可得到目标运动的角速度。
The relationship between a type of angular velocity trans's input and output is linear, from the output voltage we can know target angular velocity.
针对压力传感器输出特性受温度变化和电压波动影响的问题，提出了应用支持向量机对压力传感器输出特性进行非线性补偿的校正模型。
In view of characteristics of pressure sensor affected by temperature changes and voltage fluctuation, a correction model of pressure sensor is presented based on Support Vector Machine.
位移因子是表示传感器控制器输出的位移电压与中间极板的实际位移的相互关系的量。
The displacement scale factor (DSF) represents the correlation between the displacement voltages from the transducer to the actual position of center plate of the transducer.
定制的设备和树木接轨后能够产生1.1伏的输出电压，这足以运行低功耗传感器。
By hooking it up to a tree using electrodes, the custom-built device was able to generate an output voltage of 1.1 volts, enough to run low-power sensors.
该发射器还具有校准和放大传感器信号，而这是现有标准电压或电流输出。
The transmitters also have calibrated and amplified sensor signals, which are available as standardised voltage - or current outputs.
燃气温度传感器将检测到减压器输出燃气的温度转变为电压信号输入给ecu做为喷气修正的信号。
Gas temperature sensor transfers the gas temperature signal that out from reducer to voltage signal which will be delivered to ECU as spray correct signal.
发电元件传感器的开关，一时的冲动，抑制以阻止在输出上交换阶段，当工作电压应用。
EGE sensors have a switch-on impulse suppression that blocks the output during the switch-on phase, when the operational voltage is applied.
电压传感器的输入端与探针连接，电压传感器的输出端与计算机连接。
The voltage sensor has input end connected to the probe and output end connected to the computer.
燃气压力温度传感器将减压器输出的燃气压力及温度以电压的形式输送给ecu。
This sensor delivers gas pressure and temperature information which out from reducer as voltage form to ECU.
传感器输出的检测信号是中频的正弦电压信号，为采集和处理该信号，设计了以P89C51RD2单片机为核心的数据采集器电路。
The output signal of the sensor is the sinusoidal signal with intermediate frequency. To sample and process this signal, a data collection circuit that centers on P89C51RD2 single chip is designed.
高温材料，相控阵传感器，低电流的要求较稳定的输入电压，环境温度，或输出频率范围的输出信号。
The high temperature materials, phased array sensor, and low current requirements stabilize the output signals over a wide range of input voltage, ambient temperature, or output frequencies.
同类型的680压阻测量元件的压力变送器的补偿，调整和放大传感器信号，即是标准电压或电流输出可用。
The pressure transmitters of type 680 with piezoresistive measuring elements have compensated, adjusted and amplified sensor signals which are available as standard voltage or current outputs.
应用推荐