基准电压产生电路为带隙电路的扩展，节省了资源并得到了高稳定度的基准电压。
The voltage reference generator was the expansion of the bandgap circuit for saving the resources.
泄漏电流是由测量电路和附近的电压源之间的寄生电阻通路产生的。
Leakage currents are generated by stray resistance paths between the measurement circuit and nearby voltage sources.
如果将一个阶跃电压施加到电路，会产生一个瞬态电流。
If a step voltage is applied to the circuit, a transient current is generated.
虽然输入偏置电流是这种误差的常见来源，但是外电路产生的电流在源电阻上形成的电压降也能引起误差。
Although input bias current is a common source of this type of error, currents generated by external circuits can also result in errors due to voltage drops across the source resistance.
当撤去电压时，这些分离的电荷在重新组合时会在与绝缘体相连的电路中产生衰减的电流。
When the voltage is removed, the separated charges generate a decaying current through circuits connected to the insulator as they recombine.
在常规的硬开关电路中，由于变压器漏感及寄生电容的影响，常常在开关转换瞬间会产生很高的电压尖峰。
In common hard switching circuit, high voltage spike usually could be produced during switch transition process because of the effect of transformer leakage inductance and parasitic capacitor.
这些误差源包括热电动势、由射频干扰(RFI)经过整流而产生的偏置量以及电压表输入电路中的偏置量。
These sources include thermoelectric EMFs, offsets generated by rectification of RFI (radio frequency interference), and offsets in the voltmeter input circuit.
该工具可以产生用于特定设计的制造掩模，该设计包括具有优化的阈值电压的混合栅极晶体管以符合电路设计标准。
The tool may generate fabrication masks for the given design that include mixed gate transistors with threshold voltages optimized to meet circuit design criteria.
电流在反馈电阻上产生的电压超出设定值时，IR 2132启动内部保护电路，关断输出通道，实现电流保护。
When the voltage on the feedback resistance over the designed value, the inside protection circuit was operated and the output channels were cut in IR2132 to achieve current protection.
雷电感应电压和感性负载接入或脱离电源电路时所产生的干扰电压是电源网主要的干扰脉冲电压。
The inductive voltage of the thunder and lightning and the produced disturbance voltage when the inductive load turns on or is separated from the power network is main disturbance pulse voltage.
提出了一种能够自产生基准电压和偏置电流，并且锁定阈值电压和迟滞量稳定的新型欠压锁定电路。
A novel under-voltage lockout circuit is proposed which could generate reference voltage and bias current itself, and could stabilize lockout threshold voltage and hysteresis quality.
抑制各种感性负载切换或各种瞬间噪声在电路板中产生的EFT和浪涌电压。
Suppression of Inductive Switching or Other Transient Events Such as EFT and Surge Voltage at the Circuit Board Level.
后者电路呈电容性，不仅回路电流大，且电感、电容上产生过电压。
Under the latter condition, the circuit is capacitive, with large loop current and over-voltages on the inductance and the capacitance.
分析了一般电桥电路作为传感器其输出电压产生非线性误差的原因。
The reason of nonlinear error caused by output voltage in common electric bridge as the sensor is analyzed.
在两种情况下磁场会产生误差电压：1磁场随时间变化。2在电路和磁场之间存在相对运动。
Magnetic fields generate error voltages in two circumstances: 1 if the field is changing with time, and 2 if there is relative motion between the circuit and the field.
对工厂原装的热水器增加电源功率和；或增加电源电压可能导致热水器和；或电路系统产生变化。
Increasing the wattage anD/or voltage from factory original equipment can require changes to the water heater anD/or the electric service.
电压比较电路基于第一电压和第二电压之间的比较产生控制信号。
The voltage comparison circuit generates a control signal based on a comparison between the first voltage and the second voltage.
芯片内部主要包括数字控制器，显示数据存取器，DC - DC电压转换器，参考电流产生器，电压预充电路产生器，64个行驱动电路和132个列驱动电路。
It consists of a digital controller, SRAM for display data memory, a DC-DC voltage converter, reference current generators, a pre-charge voltage generator, 64 common drivers, and 132 segment drivers.
动态电压恢复器采用单向馈能电路结构，可以在能量单向流动的情况下，实现对因电缆压降而产生的电压暂降或暂升的持续补偿。
The dynamic voltage restorer is designed as unilateral energy flow equipment which can compensate continuous voltage sag or swell resulted from the voltage drop of power cable.
从表示电路增益的参考电压中减去所述温度校正电压，以产生电路的校正参考电压。
The temperature correction voltage is subtracted from a reference voltage representing a gain for the circuit to produce a corrected reference voltage for the circuit.
该电路在特殊触发电路的作用下，其输出端可产生全波可控整流电压和全控桥式整流电压。
Full wave controlled rectification voltage or controlled bridge rectification voltage can be generated under the controlling of a special trigger circuit.
从仿真的数据结果，我们可以清楚地认识到衬底寄生电阻所带来的衬底电压的不稳无论在数字电路还是模拟电路中都会产生一定的影响。
From the simulation data, we can clearly observe the instability of substrate voltage, caused by substrate resistor, will cause some trouble in both analog and digital circuit.
电压转换电路基于电源电压产生第一电压和第二电压。
The voltage conversion circuit generates a first voltage and a second voltage based on a power supply voltage.
设计实例结果表明，提出的电路结构和算法在产生相同输出电压情况下，简化了电路结构，提高了电源产生电路的整流效率。
The results prove that the architecture and algorithm simplify power generation circuits and enhance the circuit efficiency when providing the same output voltage.
探讨了IGBT功率电路尖峰电压产生的原因，并针对第三代IGBT，给出了适应不同功率的吸收电路。
The reason of appearing peak voltage in IGBT(insulated gate bipolar transistor)absorber is discussed. Absorbers corrcsponding to different powers are proposed for the 3rd generation IGBT.
高压产生系统主要采用电荷泵电路来产生高压，电压调节系统则主要采用低压差电压调节器来调节输出电压。
High voltage generate system mainly use charge pumps to generate high voltage. Voltage regulator system usually USES LDO to regulate output voltage.
在这方面，试图减少在具有几个直流电压源的电路中产生电压升高的风险。
In this connection it is endeavoured to reduce the risk of an increase in voltage in a circuit with several direct voltage sources.
在这方面，试图减少在具有几个直流电压源的电路中产生电压升高的风险。
In this connection it is endeavoured to reduce the risk of an increase in voltage in a circuit with several direct voltage sources.
应用推荐