继续，你们已经得到了各种的释放，从子系统或者组件，典型地是在，放射性废物的区域，你们可能能够，将一个燃料组件丢进去，所以，这些需要分析。
Continuing, and you have all kinds of releases from subsystems or components typically in the radwaste area where you might be able to drop a fuel assembly so all this has to be analysed.
航天发射场的加注系统是提供燃料的重要设备，需要进行可靠性分析和评定，分析影响系统可靠性的因素，确定其可靠度。
Fuel supply system of launch site is a very important system, and its reliability analysis and evaluation is required for analyzing the influence factors and evaluating its reliability.
对这些安全系统性能分析的结果表明：有关公众剂量，以及燃料、燃料通道和反应堆厂房等完整性的基本安全准则是满足的。
The assessment results for safety systems performance show that the fundamental safety criteria for public dose, and integrity of fuel, channels and the reactor building, are satisfied.
分析了地下工程对能源系统的特殊需求和现存问题，指出燃料电池技术在地下工程中的应用优势和发展前景。
The application advantages and future prospect of fuel cell technology in underground engineering is described, by analyzing the special needs and present problems of the energy system in it.
能量平衡和火用分析结果表明，该系统的燃料利用率可达86%以上。
An energy and exergy analysis shows that the overall fuel utilization efficiency of the proposed cogeneration system is more than 86%.
分析了质子交换膜燃料电池的工作原理，提出了将其集成为车用发动机系统的设计方案，并且付诸了实践应用。
This paper introduced the principle of Proton Exchange Membrane Fuel Cell (PEMFC), and design the vehicle FC-engine system, at the same time, we have taken many practice.
对主蒸汽压力控制系统、床温测量系统、床温校正系统和主燃料跳闸的动作条件进行了详细的分析。
The main steam pressure control system, bed temperature measure system, bed temperature adjust system and action condition of main fuel trip (MFT) are analyzed.
本文采用机理分析与系统辨识相结合的方法，对预混点燃式气体燃料发动机进行了深入细致的建模研究。
This paper studied the models of pre-mixed spark ignition gas engine particularly, which adopted the method of mechanism analysis and system identification.
介绍了燃料电池电动车整车控制系统的组成，分析了整车控制器的作用，详细讨论了踏板及档位处理方法。
This paper introduces the construction of control system in fuel cell electrical vehicle (FCEV). The functions of the vehicle controller are analyzed.
本文介绍了基于VB6和RS-485总线技术的燃料电池单片电压循环检测和分析系统的设计。
The single voltage detecting and analysis of fuel cell based on VB6 and RS-485 technology were introduced.
介绍了燃料电池电动车分布式整车控制系统的任务和组成，分析了各ECU节点的功能。
The tasks and constitution of distributed control system in fuel cell electrical vehicle (FCEV) are introduced. The function of each ECUs is analyzed.
通过对试验结果的比较与分析，提出了改善双燃料发动机引燃柴油供给系统参数的措施。
The methods to improve the parameters of pilot fuel supply system have been proposed by means of the comparison and analysis of test results.
分析了燃料电池发动机辅助系统功率的变化特点及其规律，并在试验研究的基础上，通过反三角函数进行改造，建立了辅助系统功率特性的半经验模型。
A semi-empirical model of a parasite system power of a fuel cell engine is developed by modifying the antitrigonometric function, and is verified by different test data.
并以飞机发动机燃料计量系统FMEA为例，阐述了功能角色模型的故障注入和故障模式的建立，以及故障分析过程。
Taking FMEA of fuel-metering system of jet plane engine as an example, failure infusing of functional role model, setting-up model of failure, and process of fault analysis was introduced.
文章对由燃料电池和燃气轮机组成的混合发电系统的性能进行了分析。
This paper addresses the performance analysis of a fuel cell-gas turbine hybrid system.
最后以喷气式发动机燃料计量系统为例，阐述对该系统进行故障分析的一般步骤。
The process of fault analysis is illustrated by the Fuel metering System of jet plane engine.
针对燃料煤输送带运输线，设计了燃料煤运输线的PLC控制系统，分析了控制系统的各个组成部分。
In this paper, PLC control system of fuel coal transportation network is designed and each part of the control system is analyzed.
在物流分析中，应用广义原子经济性理论对小麦燃料乙醇生态系统的物流进行分析和评价，并指出原子经济性得以进一步提高的途径。
The logistics of wheat fuel ethanol ecosystem is analyzed and estimated utilizing generalized atomic economic theory, and the path to make atomic economic theory further improvement is presented.
结合甲醇在动力系统中间接应用方式的考虑，分析了甲醇和二甲醚利用燃气轮机排热蒸汽重整进行燃料改良组成化学回热燃气轮机循环的可行性；
Combined with methanol's indirect use in power system, methanol and dimethyl-ether steam reforming use gas turbine exhaust gas to constitute the chemically recuperative gas turbine cycle.
本文介绍了成功应用于燃料电池轿车动力系统上的CAN总线控制系统，并对CAN总线的硬件结构和软件设计做了详细的分析。
The article describes a CAN bus system which has been successfully used in the Fuel Cell Car drive system and analyses its hardware construction and software design.
该文分析了车用质子交换膜燃料电池系统热管理子系统的结构，并建立热管理子系统的动态模型。
A dynamic model was developed to analyze the thermal management subsystem of a proton exchange membrane (PEM) fuel cell system.
根据质子交换膜燃料电池工作原理，对车载燃料电池系统进行了较详细的计算与分析。
According to the working principle of the PEMFC stack, the calculations and analysis for the FC vehicle system are conducted.
通过使用新加坡淡马锡理工学院燃料电池应用中心的燃料电池测试系统，对PEMFC的暂态电响应进行测量和分析。
By using a fuel cell test system in fuel cell Application Centre of Temasek Polytechnic, the transient electrical response of PEMFC was observed and investigated.
本文以热动力系统总体参数为出发点，对热动力系统中的发动机、燃烧室及燃料供应分系统的参数配置进行了预测和理论分析。
Based on the overall parameters of heating power system, the parameter setting of its engine combustion chamber and fuel supplying subsystem have been forecasted and theoretically analysed.
介绍了一种年产2000吨精锌、以原煤为燃料的一炉两塔型锌精馏炉的供热系统，并对生产中的能耗进行了简要分析。
Heating system of zinc-refining column using coal as fuel which produced 2000 tons refined zinc in a year was introduced in this paper. And energy consumption in production was simply analyzed.
对多孔电极、直接甲醇质子交换膜燃料电池及甲醇改质质子交换膜燃料电池作了分析和讨论，指出了对质子交换膜燃料电池系统进行水管理和热管理的重性和必要性。
The porous electrode? the Direct Methanol PEMFC and the Methanol-reformed PEMFC are analysed. The importance and necessity to study develop water and heat management of PEMFC are further discussed.
对多孔电极、直接甲醇质子交换膜燃料电池及甲醇改质质子交换膜燃料电池作了分析和讨论，指出了对质子交换膜燃料电池系统进行水管理和热管理的重性和必要性。
The porous electrode? the Direct Methanol PEMFC and the Methanol-reformed PEMFC are analysed. The importance and necessity to study develop water and heat management of PEMFC are further discussed.
应用推荐