该PM 700混频器的设计能经受住的房子被严酷的生活道路上的艰难木，盖地毯环绕。
The PM700 mixer is designed to withstand the rigours of life on the road by being house in a tough wooden, carpet covered surround.
介绍采用微波混频器的上变频特性实现宽带平方电路的设计方法与具体实现，主要用于高码速率QPS K信号的载波恢复。
An introduction of the design and implementation of a broad-band square circuit is given, which is used to recover the carrier of the high speed QPSK signal.
介绍了采用三端口阻抗条件设计双栅FET混频器的方法。
A design method of DGFET mixer with three-port impedance condition is also described.
该文介绍用双脊波导作信号端制作毫米波宽频带混频器的设计方法。
A design method of mm wave mixer with double ridged waveguide used as signal port has been presented.
在理论分析的基础上，本文设计了一个应用于北斗卫星导航系统接收机芯片中的低噪声放大器和下变频混频器。
On the base of theory analysis, a LNA and a mixer of a receiver chip used in compass navigation satellite system have been designed.
设计并优化了一个基于共用跨导级结构的用于超高频rfid阅读器的正交下变频混频器。
A quadrature down-conversion mixer based on this topology is designed and optimized for an ultra high frequency RFID reader.
第三章介绍了微波混频器及镜频抑制混频器的工作原理，讨论了设计微波镜频抑制混频器中应该注意的一些问题。
In chapter three, after presenting the working principle of mixer and image-reject mixer, some problems which should be paid attention to during the mixer design are discussed.
本文首先介绍了一种毫米波段具有镜频抑制功能的四次谐波混频器的设计与实现。
At first, the design and implementation of MMW hybrid integrated sub-harmonic image rejection mixer is presented in this paper.
在混频器部分，首先概要叙述混频器的两种实现方法、主要的性能指标以及双平衡混频器的设计、优化流程。
In the sections about mixer, first, two realizing methods of mixer, its major performance parameters, the design and optimization flow of the double balanced mixer were explained briefly.
用国产梁式引线混频二极管，设计了平面集成混频器。
An integrated planar mixer is designed on the basis of domestic-made beam lead diodes.
设计了一种用于零中频gps接收机的低闪烁噪声混频器。
A low flicker noise mixer for zero-IF GPS receiver is presented.
将此方法在LAN上进行了尝试，证明了其同样适用于LAN上的微波混频器电路的设计，有助于满足微波混频器以及其他微波部件电路团队设计的需要。
The method is attempted in LAN, proved that it can be used to design microwave mixer circuit in LAN, which can satisfy the need for group design. Finally.
对于该混频器理论研究，包括非线性电路模型及三端器件混频器的设计方法方面都是必要的尝试，可为以后的理论探讨提供重要的经验。
The study about the mixer including nonlinear circuit model and the analysis method is necessary attempt. All of that can provide important experience for later research on it.
本文设计了一个应用在全息成像系统中的W波段的微带四次谐波混频器。
In this paper, a quadruple subharmonic mixer used in holographic imaging system at W band is designed.
介绍了CMOS混频器主要技术指标的设计思路和技术。
The design techniques of improved CMOS mixers were illustrated.
基于这种背景，本文提出了一种应用于超宽带系统的高性能（低压、高线性度、高变频增益）直接下变频混频器，采用标准的CMOS工艺设计和实现。
To solve these problems, this paper presents a high performance, namely low voltage, high linearity and high conversion gain, CMOS direct down conversion mixer for UWB (Ultra Wide Band) system.
本文对8毫米4次谐波混频器进行了大信号分析和小信号分析，并设计制作了一个微带结构的8毫米4次谐波混频器。
In this paper, the large-singal analysis and small-signal analysis are made on an 8 mm 4th harmonic mixer. This harmonic mixer using a microstrip configuration is developed with GaAs diodes.
通过对三种方案的分析和比较，本文把这种改进型单混频器实施方案作为本课题的最终设计方案。
The improved two-mixer project is regard as the final design project by analyzing and comparing the three projects.
建立了一套完整的FET混频器的分析设计方法。
A complete method for analysing and designing mixers in presented.
本文设计了基于标准的数字CMOS工艺的低噪声放大器和混频器。
A low noise amplifier (LNA) and a mixer realized in standard digital CMOS technology are presented in this thesis.
上述结果表明：设计的混频器各项性能指标均达到设计要求。
These results show that: the performance indicators of the design of mixer have met the design requirements.
第二、三、四章分别论述低噪声放大器、单刀双掷开关和无源混频器的基本设计原理和具体设计过程，其中包括版图的优化设计。
Chapter 2, 3 and 4 dissertates the basic design theories and detail design processes of LNA, SPDT switch and passive mixer, including the design and optimization of the layout.
本文设计了一种工作在1.2V低电源电压下的折叠混频器。
A 1.2v low voltage supply folded-switching mixer is designed in this paper.
本文设计了一种工作在1.2V低电源电压下的折叠混频器。
A 1.2v low voltage supply folded-switching mixer is designed in this paper.
应用推荐