流动成像测量探针数增多,方法多样;
The number of measuring probe for fluid imaging is increasing.
这台设备用于空间测量,使用一个运动的测量探针获得物体表面某点的坐标。
This is a device that is used for dimensional measuring, that USES a moving measuring probe to obtain the coordinates of points on an object surface.
摩尔偏析测量术通过测量探针光束经过不均匀介质后光线的偏折来估算介质的折射率。
Moire deflection measurement can be used to calculate refractive index by measuring deflection of probe beam passing through mediums.
用模型上布置的压差传感器和饱和度测量探针,测量了聚合物驱的开采效果、压力场和饱和度场变化。
Production performance, pressure field and saturation field are measured with a differential pressure unit and saturation measuring probes.
在非常好的CMI150结构基础上,CMI153用增强的性能和优越的基质敏感性传送测量探针。
Built upon our highly successful CMI150 architecture the CMI153 delivers an improved measurement probe with enhanced performance and superior substrate sensitivity.
本文描述了用静电探针测量探针悬浮电位的方法,给出MM-4中电位分布的实验结果。结果表明轴向电位分布不对称,径向分布对称;
Some experimental results of the potential distribution in MM-4 fusion device are presented by measuring the floating potential of probe.
提高作为纳米科技的“眼”和“手”的扫描探针显微镜(SPM)的测量和定位精度,是纳米仪器界始终追求的目标。
It is an objective for nanometer instrument researcher to improve the measurement precision of scanning probe microscope (SPM), the eye and hand of nanometer science and technology.
如有必要,延长百分表的探针,直到可以明确测量活塞顶为止。
If necessary extend the probe of the dial gauge until you can definitely take measurements on the piston crown.
图4 -47是四点同线探针用于电阻率测量的配置图。
Figure 4-47 is a diagram of four - point collinear probe setup for resistivity measurements.
图4 -47是四点同线探针用于电阻率测量的配置图。
Figure 4-47 is a diagram of four-point collinear probe setup for resistivity measurements.
测量原理如下:一个传送和接收红光和红外光的探针放置并透照搏动的微动脉床。
The principle of measurement is as follows: a probe, which features a transmitter and receiver of red and infrared light, is positioned to transilluminate a pulsatile arteriolar bed.
如果你尝试在其中特定z值平面内用一个2维测头测量一个3d立体圆锥体。那么探针直径将会影响精度。
If you're trying to check a 3d cone as a 2d dia at a certain Z level then, yes probe diameter will affect accuracy.
其中两个探针提供恒定的电流,而另外两个探针测量一部分样品上的电压降。
While two contacts supply a constant current, the other two contacts measure the voltage drop across a portion of the sample.
电流从两个外部的探针加入,而电压降则在两个内部的探针之间测量。
The current is sourced through the two outer probes and the voltage drop is measured between the two inner probes.
用金属探针法测量塔板上气液两相流中某些点的含气率。
A method of using metal probe for measuring the void fraction at any point in gas-liquid two-phase flow on Sieve tray is described.
在离子回旋共振加热(ICRH)实验中用于测量瞬态射频(RF)阻抗的探针列阵常常给出错误的结果。
Probe array used for the measurement of transient RF impedance in ion cyclotron resonance heating (ICRH) experiment often gives erroneous results.
计算获得的偏滤器内外靶板上打击点出现和消失的时间与布置在偏滤器靶板上静电探针测量到的信号很好地符合。
The time of the appearance and disappearance of the strike point at the target is in agreement with the signals measured by the static electric probes.
最后,通过数值模拟预测了在该旋转盘试验中是可以用五孔探针对流场进行测量的。
Finally measurement of the flow field in the rotating disk with a five-hole probe is demonstrated feasible by the numerical simulation.
开发了一套新型的三探头单纤光导探针测量系统,用于测量二维气泡速度。
An advanced measuring system with tri fiber optical probe has been developed to measure two dimensional bubble velocity.
由于探针可以采取冷却措施,因而可以测量很高的温度。
As the probe is cooled, the measurements for high flame temperature can be achieved.
对直流TIG电弧阳极板表面电流密度的测量方法——分离极板法和探针(自制)法进行了分析比较。
The measuring methods of D C TIG welding arc anode sheet surface current density split sheet method and probe (made by ourselves) method were analysed and compared.
本文用激光探针测量了砷离子注入硅在CW CO_2激光退火过程中的实时分辨反射率。
The time-resolved optical reflectivity of as ion-implanted silicon during CW CO_2 laser annealing has been measured by using laser probes.
本文讨论了测量离子探针灵敏度的各种方法。
This paper describes the sensitivity measurement of ion microprobe mass analyzer.
采用通常的六探针法进行了测量。
基于四探针电阻率测量技术,依据试验测得的混凝土表观电阻率变化确定裂缝位置。
The location of the crack can be found by the change of the apparent resistivity, based on four-probe electrical resistivity measuring technique.
本文探索了用朗谬尔探针测量火焰电子温度的方法。
The measurements for the electron temperature of flame using the Langmuir probe are explored.
实验测量表明单个同轴探针与圆波导匹配良好。
Experimental measurements present that single coaxial line probe matches with circular waveguide very well.
在不同位置采用五孔探针测量了两种叶栅的气动参数并在叶片表面做了墨迹流动显示。
Aerodynamic parameters of the two cascades are measured by a five-hole probe at different positions and ink trace flow visualization is conducted on blade surfaces.
在不同位置采用五孔探针测量了两种叶栅的气动参数并在叶片表面做了墨迹流动显示。
Aerodynamic parameters of the two cascades are measured by a five-hole probe at different positions and ink trace flow visualization is conducted on blade surfaces.
应用推荐