具体操作为：80V的恒定沉积电压作用1分钟；
The subsection constant voltage has three procedures:Constant voltage(80V)functions 1 minute;
实验研究了电沉积的最佳物理条件，包括沉积电压、沉积时间等。
The optimized parameters of electrical-deposition were experimentally studied, including the deposition voltage and deposition time.
通过三电极电池研究发现，锂离子电池在低温充电过程中出现的金属锂的沉积与电解液种类、充电倍率和截止电压等因素有关。
We found by the three-electrode experimental cell, deposition of metallic lithium during low-temperature charging is related to electrolyte, charging rate, cut-off voltage and so on.
通过控制电压、电极间距、温度等电解工艺条件，在钛合金表面沉积得到DLC膜。
DLC films can be deposited by changing technology, such as voltage, distance and temperature.
激励电源电压与频率、电介质材料、DBD结构、媒介气体等均会对电荷沉积效应产生较大影响。
Some factors can affect greatly the effect of chargesdeposited in layer, such as applied voltage and frequency, dielectric material, DBD configuration and media gas, etc.
水泵流量不足可能产生的原因：1、管道、泵流道叶轮部分阻塞，水垢沉积、阀门开度不足。2、电压偏低。3、叶轮磨损。
Pipe or channel impeller jammed, scale deposited or valve not enough opened. 2, Voltage too loe. 3, impeller worn out.
实验结果表明：电压与电解液温度等工艺参数影响涂层中羟基磷灰石的含量以及沉积过程中晶体长大和形核方式。
The results show that: the parameters affect the content of HA and the style of the growth and the formation of the crystals.
由于金属杂质原子扩散并沉积在器件的有源区，会造成诸如：反向漏电流较大，反向击穿电压是软击穿等有害的影响。
High leakage currents and soft reverse current-voltage characteristics are some of the detrimental effects produced by the metal atoms dissolved in the silicon matrix.
因为此电极沉积膜在既定的电压下具有一较高的电阻， 所以当所有表面及边缘被涂膜覆盖时，电泳沉积过程会自己停止。
To this point, we have discussed anodic and cathodic paint and have used the terms anionic and cationic as well.
因为此电极沉积膜在既定的电压下具有一较高的电阻， 所以当所有表面及边缘被涂膜覆盖时，电泳沉积过程会自己停止。
To this point, we have discussed anodic and cathodic paint and have used the terms anionic and cationic as well.
应用推荐