汽缸头附有许多突片以增加强度。
清洁排气歧管和汽缸头配合面。
Clean the exhaust manifold and cylinder head mating surfaces.
紧固排气岐管汽缸头螺栓。
将引擎汽缸头放在销上。
它通常是位于汽缸头靠近散热器的堕落，根据汽车制造。
It is often located at the cylinder head near the radiator lapse, depending on the car make.
摩托车发动机汽缸头系列产品：包括独有只是产权的双金属汽缸头和水冷却汽缸头。
Motorcycle engine cylinder head series:Including the exclusive intellectual property of the dual metal cylinder head and water-cooled cylinder head. These products are dluminum casting products.
小型通用汽油机用垫片，化油器密封，隔板器密封，空气滤清器密封，曲轴箱密封，汽缸头垫片，隔热罩垫片，排气管密封。
Carburetor gasket seal, small general gasoline engine sealing, air filter separator device sealing, sealing, crankcase sealing, cylinder head gaskets, insulation gasket, exhaust pipe sealing.
雄力400不但推荐于硬质及软质铸铁的汽缸内径搪磨，还适用于块规的平面精磨及轴头销的研光工序。
HONIC 400 is not only recommended for cylinder honing on hard, soft and close-grained cast iron but also for flat honing and lapping operations on gauge blocks and gudgeon pins.
由于低负荷操作，可以预先知道引起油头、燃烧室、增压器、透平的脏堵，检查周期须缩短，维修保养周期须更新，汽缸油供给率须调整。
Due to low load operation, the inspection intervals shall be shortened, the maintenance intervals shall be reviewed, and the feed rate of Cyl .
由于低负荷操作，可以预先知道引起油头、燃烧室、增压器、透平的脏堵，检查周期须缩短，维修保养周期须更新，汽缸油供给率须调整。
Due to low load operation, the inspection intervals shall be shortened, the maintenance intervals shall be reviewed, and the feed rate of Cyl .
应用推荐